Milwaukee C12 C Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Milwaukee C12 C (5 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 14 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/5
C12 C
Original instructions
2
0°C
60°C
60°C
0°C
100%
contact?
4
TECHNICAL DATA CHARGER
Voltage range .......................................................................12 V
Quick charge current ...........................................................3.0 A
Maintaining charge .............................................................500 mA
Battery charging time Li-Ion 1.5 Ah .....................................30 min
Weight according EPTA-Procedure 01/2014 ......................460 g
Recommended ambient charging temperature ...........+5...+40 °C
WARNING! Read all safety warnings and all
instructions. Failure to follow the warnings and instructions
may result in electric shock, re and/or serious injury.
Save all warnings and instructions for future reference.
SAFETY INSTRUCTIONS
Please pay attention to the safety instructions in the
attached lea et!
Do not dispose of used battery packs in the household
refuse or by burning them. Milwaukee Distributors o er to
retrieve old batteries to protect our environment.
Do not store the battery pack together with metal objects
(short circuit risk).
Use only System C 12 chargers for charging System C 12
battery packs. Do not use battery packs from other systems.
The following battery packs can be charged with this
charger:
Battery Cat.
No.
Cell Type DC Volts Capacity Cell No.
C12 B Li-Ion 12 V 1.5 Ah 3
C12 BX Li-Ion 12 V 3.0 Ah 2 x 3
M12 B Li-Ion 12 V 1.5 Ah 3
M12 BX Li-Ion 12 V 3.0 Ah 2 x 3
M12 B2 Li-Ion 12 V 2.0 Ah 3
M12 B3 Li-Ion 12 V 3.0 Ah 3
M12 B4 Li-Ion 12 V 4.0 Ah 2 x 3
M12 B6 Li-Ion 12 V 6.0 Ah 2 x 3
Do not try to charge non-
chargeable batteries with this
charger.
No metal parts must be allowed to enter the battery section
of the charger (short circuit risk).
Never break open battery packs and chargers and store
only in dry rooms. Keep dry at all times.
Do not touch the tool with conducting objects.
Never charge a damaged battery pack. Replace by a new
one.
Before use check machine, cable, and plug for any
damages or material fatigue. Repairs should only be carried
out by authorised Service Agents.
This appliance is not intended to
be used or cleaned by persons
with reduced physical, sensory or
mental capabilities, or lack of
experience or knowledge, unless
they have been given instructions
concerning the safe use of the
appliance by a person legally
responsible for their safety. They
should be supervised whilst using
the appliance. Children shall not
use, clean or play with this
appliance, which when not in use
should be secured out of their
reach.
Warning! To reduce the risk of re, personal injury, and
product damage due to a short circuit, never immerse your
tool, battery pack or charger in uid or al-low a uid to ow
inside them. Corrosive or conductive uids, such as
seawater, certain industrial chemicals, and bleach or bleach
containing products, etc., Can cause a short circuit.
SPECIFIED CONDITIONS OF USE
The quick charger can charge Milwaukee batteries from C
12 to 12 V.
Do not use this product in any other way as stated for
normal use.
MAINS CONNECTION
Connect only to single-phase a.c. current and only to the
system voltage indicated on the rating plate. It is also
possible to connect to sockets without an earthing contact
as the design conforms to safety class II.
BATTERIES
Battery packs which have not been used for some time
should be recharged before use.
Temperatures in excess of 50°C (122°F) reduce the
performance of the battery pack. Avoid extended exposure
to heat or sunshine (risk of overheating).
The contacts of chargers and battery packs must be kept
clean.
CHARACTERISTICS
After inserting the battery into the reception of the charger
the battery will automatically be charged (red lamp is
illuminated continuously)
When a hot or cold battery pack is inserted into the charger
( ashing red lamp), charging will begin automatically once
the battery reaches the correct charging temperature
(0°C...60°C).
Charging time varies depending on the battery temperature,
charge needed and the type of battery pack being charged.
As soon as charging is completed, the charger switches
over to ”trickle” charge to maintain the full capacity (green
control lamp is illuminated continuously, red lamp o )
It is not necessary to remove the battery after charging. The
battery can be stored permanently in the charger without the
danger of being overcharged.
If both LEDs ash at the same time, either the battery has
not been completely mounted or there is a fault in the
battery or the charger. For safety reasons you must stop
using the charger and battery immediately and have them
inspected by an Milwaukee Customer Service Centre.
TRANSPORTING LITHIUM BATTERIES
ENGLISH


Product specificaties

Merk: Milwaukee
Categorie: Niet gecategoriseerd
Model: C12 C

Heb je hulp nodig?

Als je hulp nodig hebt met Milwaukee C12 C stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Milwaukee

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd