Milwaukee 48-22-8542 Handleiding
Lees hieronder de 📖 handleiding in het Nederlandse voor Milwaukee 48-22-8542 (20 pagina's) in de categorie Kast. Deze handleiding was nuttig voor 31 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/20
Cat. No. / No de cat.
48-22-8541, 48-22-8542
OPERATOR'S MANUAL
MANUEL de L'UTILISATEUR
MANUAL del OPERADOR
WARNING To reduce the risk of injury, user must read and understand operator's manual.
AVERTISSEMENT An de réduire le risque de blessures, l'utilisateur doit lire et bien
comprendre le manuel.
ADVERTENCIA Para reducir el riesgo de lesiones, el usuario debe leer y entender el manual.
Este manual se aplica a los modelos anteriores (puede venderse por separado)
46" HIGH CAPACITY STEEL STORAGE CHEST &
46" HIGH CAPACITY STEEL STORAGE CABINET
COFFRE DE RANGEMENT EN ACIER GRANDE CAPACITÉ DE
1,16 m (46") ET CABINET DE RANGEMENT EN ACIER GRANDE
CAPACITÉ DE 1,16 m (46")
CAJA DE ALMACENAMIENTO DE ACERO DE GRAN CAPACIDAD
DE 1,16 m (46") Y GABINETE DE ALMACENAMIENTO DE ACERO
DE GRAN CAPACIDAD DE 1,16 m (46")
2
IMPORTANT SAFETY INSRUCTIONS
WARNING
READ ALL SAFETY WARNINGS
AND ALL INSTRUCTIONS. Failure
to follow the warnings and instructions may re-
sult in serious injury. Save all warnings and in-
structions for future reference.
WORK AREA SAFETY
•Use the chest/cabinet and accessories in accor-
dance with these instructions and in the manner
intended, taking into account the working conditions.
Use of the chest/cabinet for operations dierent from
those intended could result in a hazardous situation.
•Keep work area clean and well lit. Cluttered or
dark areas invite accidents.
•Fully assemble the chest/cabinet according to the
assembly instructions. Do not leave o any pieces.
•
Chest mu
st be fas
tened by screws through
connectors after it has been placed on top of
cabinet.
•Do not modify the chest/cabinet in any way. Use
only specically recommended accessories. Drilling
holes or modifying the chest/cabinet will lower the
load capacity, which can cause the chest/cabinet to
collapse, resulting in injury.
•Lock wheels when chest/cabinet is not being
moved. Unlocked wheels can allow the chest/cabi
-
net to move unexpectedly.
•Keep the chest/cabinet on a level surface. Do not
load, unload, or park chest/cabinet on an incline.
The chest/cabinet may become unbalanced and tip,
resulting in injury.
•Always balance the chest/cabinet load to avoid
tipping. Unbalanced chests/cabinets are more likely
to tip when being moved or when using the chest/
cabinet work surfaces. Evenly distribute the weight
front to back and side to side. Place more than half
the total load weight on the bottom cabinet when pos-
sible. To help prevent the chest/cabinet from tipping,
load the product starting with the bottom drawers.
• Do not exceed the maximum product weight,
including contents. Do not exceed the maximum
weight for each drawer. Overloaded chests/cabinets
can tip, collapse, or damage drawer slides.
• Do not open more than one drawer at a time.
Chest/cabinet may tip, causing injury.
• -Keep children and bystanders away while load
ing, unloading, and moving chest/cabinet. Dis-
tractions can cause you to lose control.
•Only lift the chest/cabinet according to the
instructions in this manual. Never lift by the
side handle. Other methods may be dangerous,
resulting in injury.
• Only transport the chest/cabinet when empty.
Properly secure when transporting.
• Do not mount the chest/cabinet on a truck bed
or any other moving object.
• Lock both the lid and all drawers before rolling
the chest/cabinet. The drawers could come open
and make the chest/cabinet unstable and tip.
• Only roll the chest/cabinet short distances by
using the handle provided.
• Secure all items before rolling the chest/cabinet.
Loose items could shift, causing the chest/cabinet to
become unstable.
• Do not use drawers as steps. Do not stand on the
chest/cabinet. Chest/cabinet will tip, causing injury.
• Be careful when closing the chest top cover.
Remove hands before closing the top cover.
• -Do not use chest/cabinet in explosive atmo
spheres, such as in the presence of ammable
liquids, gases or dust. This equipment has internal
arcing or sparking parts. Chest/cabinet should not
be located in a recessed area or below oor level.
•Chest/cabinet plugs must match the outlet.
Never modify the plug in any way. Do not use
any adapter plugs with earth (grounded) chest/
cabinet power strips. Unmodied plugs and match-
ing outlets will reduce risk of electric shock.
•Avoid body contact with earthed or grounded
surfaces such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded.
•Maintain chest/cabinet. Check for misalignment
or binding wheels, breakage or bending of drawer
slides or other parts and any other condition that
may aect the chest/cabinet's operation. Do not use
damaged chest/cabinet.
• Always use common sense and be cautious
when using tools. It is not possible to anticipate
every situation that could result in a dangerous out-
come. Do not use this tool if you do not understand
these operating instructions or you feel the work is
beyond your capability; contact Milwaukee Tool or
a trained professional for additional information or
training.
•Maintain labels and nameplates. These carry im-
portant information. If unreadable or missing, contact
a MILWAUKEE service facility for a free replacement.
•Have your chest/cabinet serviced by a qualied
repair person using only identical replacement
parts. Visit a local authorized service center for
repairs. Components, such as the power strip, are
not user replaceable. This will ensure that the safety
of the chest/cabinet is maintained.
Federal Communications Commission
WARNING: Changes or modications to this unit
not expressly approved by the party responsible for
compliance could void the user’s authority to operate
the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pur-
suant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harm-
ful interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment o and on, the user is encouraged to try
to correct the interference by one or more of the fol-
lowing measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
3
GROUNDING
WARNING
Improperly connecting the ground-
ing wire can result in the risk of
electric shock. Check with a qualied electrician
if you are in doubt as to whether the outlet is
properly grounded. Do not modify the plug pro-
vided with the chest/cabinet. Never remove the
grounding prong from the plug. Do not use the
chest/cabinet if the cord or plug is damaged. If
damaged, have it repaired before use. If the plug
will not t the outlet, have a proper outlet installed
by a qualied electrician.
Chests/Cabinets with Three Prong Plugs
Chests/cabinets marked “Grounding Required”
have a power strip with a three wire cord and three
prong grounding plug. The plug must be connected
to a properly grounded outlet (See Figure A). If the
power strip should electrically malfunction or break
down, grounding provides a low resistance path to
carry electricity away from the user, reducing the risk
of electric shock.
The grounding prong in the plug is connected through
the green wire inside the cord to the grounding sys-
tem in the power strip. The green wire in the cord
must be the only wire connected to the power strip's
grounding system and must never be attached to an
electrically “live” terminal.
Your power strip must be plugged into
Fig. A
an appropriate outlet, properly in-
stalled and grounded in accordance
with all codes and ordinances. The
plug and outlet should look like those
in Figure A.
SYMBOLOGY
Warning
Read Operator's Manual
Electrical Shock Hazard
Do not open more than one drawer at a
time. Chest/cabinet may tip, causing injury.
Be careful when closing the chest top
cover. Remove hands before closing
the cover.
Chest must be fastened by screws
through connectors after it has been
placed on top of cabinet.
Lock wheels when chest/cabinet is not
being moved. Unlocked wheels can
allow the chest/cabinet to move
unexpectedly.
Do not use drawers as steps. Chest/
cabinet may tip, causing injury.
FPO
Lock both the lid and all drawers before
moving the chest/cabinet.
SPECIFICATIONS
Cat. No. 48-22-8541, 48-22-8542*
..........................
Two-slide drawer capacity 100 lbs. (45.4 kg)
...........
Four-slide drawer capacity 200 lbs. (90.7 kg)
..........
Total capacity 2500 lbs. (1134 kg)
............................
AC input volts 120 ....................................................
Hertz 60 ....................................................................
Watts 1875 ...............................................................
Recommended Ambient Operating
Temperature 0°F to 104°F (-18°C 40°C) ........... to
* Items may be sold separately.
FUNCTIONAL DESCRIPTION
1
14
4
13
9
6
1. Top chest
2. Utility hook
3. Chest mat
4. Tool hanger
5. Rolling cabinet
6. Bottle opener
7. Cabinet corner
extrusion
8. Key
9. Front bumper
10. Rigid caster
11. Tool organizer
12. Drawer slide
13. Swivel caster
with brake
14. Shelf hinge bracket
15. Storage shelf
16. Rear bumper
2
3
19
5
8
26
17. Charger mounts
18. Power strip
(14 AWG, 1.8 m)
19. Cord storage
bracket
20. Side handle
21. Grommet
22. Bracket
23. Paper towel holder
bracket
24. Paper towel holder
rod
25. Chest corner
extrusion
26. Gas lift strut
10
17
15
12
18
20
23
24
16
7
25
11
21
22
Product specificaties
| Merk: | Milwaukee |
| Categorie: | Kast |
| Model: | 48-22-8542 |
Heb je hulp nodig?
Als je hulp nodig hebt met Milwaukee 48-22-8542 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Kast Milwaukee
21 November 2022
Handleiding Kast
- Kast HP
- Kast IKEA
- Kast Siemens
- Kast Apc
- Kast Bopita
- Kast Bruynzeel
- Kast Butler
- Kast Flexa
- Kast Foppapedretti
- Kast Gude
- Kast Handson
- Kast Livarno
- Kast Marantz
- Kast Miomare
- Kast Powerfix
- Kast Sencys
- Kast Tiger
- Kast United Office
- Kast Wehkamp
- Kast Woood
- Kast Jysk
- Kast Leen Bakker
- Kast Parisot
- Kast Talgø
- Kast Tvilum
- Kast Bush
- Kast Silver Cross
- Kast Vipack
- Kast BoConcept
- Kast KidKraft
- Kast MADE
- Kast Nolte
- Kast Rauch
- Kast BDI
- Kast Zuiver
- Kast Profijt Meubel
- Kast Ordex
- Kast Kirkton House
- Kast Empire
- Kast Dutchbone
- Kast Hooker
- Kast Calligaris .com
- Kast Gami
- Kast Tennsco
- Kast Livarno Lux
- Kast Toomax
- Kast Gladiator
- Kast Arthur Berndt
- Kast Bbf
Nieuwste handleidingen voor Kast
16 April 2024
16 April 2024
11 April 2024
10 April 2024
9 April 2024
9 April 2024
9 April 2024
9 April 2024
9 April 2024
6 April 2024