Metra HDCC-02 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Metra HDCC-02 (16 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 15 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/16
HDCC-02
I N S T A L L A T I O N I N S T R U C T I O N S
AxxessInterfaces.com © COPYRIGHT 2019 METRA ELECTRONICS CORPORATION REV. 9/16/19 INSTHDCC-02
Product Info
INTERFACE FEATURES
INTERFACE FEATURES
TOOLS & INSTALLATION ACCESSORIES REQUIRED
• Crimping tool and connectors, or solder gun,
solder, and heat shrinkTape • Wire cutter
• Zip ties
TABLE OF CONTENTS
Connections
- For models
without
a factory amp ....................2
- For models
with
a factory amp ..........................3
Installation .............................................................4
Programming .........................................................4
Extra settings .........................................................5
Honda LaneWatch Camera Retention
2014-2015
APPLICATIONS
Provides accessory power (10-amp)
Provides NAV outputs (parking brake, reverse, speed sense)
Pre-wired ASWC-1 harness (ASWC-1 sold separately)
Retains the factory backup camera
Retains the LaneWatch camera
Retains ability to change factory clock and date*
Retains the factory AUX-IN jack
Can be used in non-amplified, or amplified models
Retains balance and fade
Micro-B USB updatable
• HDCC-02 interface
• HDCC-02 harness
Honda
Civic 2014-2015
CR-V 2015
* Excluding LX and NAV models
2
CONNECTIONS
For models
without
a factory amp:
From the HDCC-02 harness to the aftermarket radio
Main harness:
Connect the wire to the ground wire.Black
Connect the Yellow wire to the battery wire.
Connect the wire to the accessory wire.Red
For the following (8) connections, cut off the RCA jacks to expose the speaker wire inside.
Connect the wire to the left front positive speaker output.White
Connect the wire to the left front negative speaker output.White/Black
Connect the wire to the right front positive speaker output.Gray
Connect the Gray/Black wire to the right front negative speaker output.
Connect the wire to the left rear positive speaker output.Green
Connect the wire to the left rear negative speaker output.Green/Black
Connect the wire to the right rear positive speaker output.Purple
Connect the wire to the right rear negative speaker output.Purple/Black
16-pin harness:
Connect the Orange/White wire to the illumination wire.
The following (3) wires are for aftermarket multimedia/navigation radios that require these wires:
Connect the wire to the parking brake wire (if applicable).Light Green
Connect the wire to the speed sense wire (if applicable).Blue/Pink
Connect the wire to the reverse wire (if applicable).Green/Purple
Connect the Yellow RCA jack to the backup camera input.
This RCA jack is used to retain the backup camera as well as the LaneWatch camera.Note:
Connect the and RCA jacks to the audio AUX-IN jacks (if applicable).White Red
8-pin harness:
Disregard the RCA jack, it will not be used in this application. White
12-pin pre-wired ASWC-1 harness & 3.5mm jack:
This harness and 3.5mm jack is to be used along with the optional (sold separately) to ASWC-1
retain steering wheel audio controls. If the is not being used, disregard this harness. If ASWC-1
it will be used, refer to the vehicle specific instruction from Axxess Interfaces for radio ASWC-1
connections and programming. Disregard the harness that comes with the .ASWC-1
The Gray/Blue wire will only be used in vehicles equipped with Bluetooth. Connect this wire
to the Yellow wire in pin-15 from the 32-pin harness in the factory Bluetooth module.
Bluetooth module location:
Civic - Behind glovebox
CR-V - In dash, under radio
Continue to Installation
3
REV. 9/16/2019 INSTHDCC-02
CONNECTIONS
For models
with
a factory amp:
From the HDCC-02 harness to the aftermarket radio
Main harness:
Connect the wire to the ground wire.Black
Connect the Yellow wire to the battery wire.
Connect the wire to the accessory wire.Red
Connect the wire to the amp turn-on wire.Blue/White
Connect the RCA jack to the front left RCA output.White
Connect the RCA jack to the front right RCA output.Gray
Connect the RCA jack to the rear left RCA output.Green
Connect the RCA jack to the rear right RCA output.Purple
16-pin harness:
Connect the Orange/White wire to the illumination wire.
The following (3) wires are for aftermarket multimedia/navigation radios that require these wires:
Connect the wire to the parking brake wire (if applicable).Light Green
Connect the wire to the speed sense wire (if applicable).Blue/Pink
Connect the wire to the reverse wire (if applicable).Green/Purple
Connect the Yellow RCA jack to the backup camera input.
This RCA jack is used to retain the backup camera as well as the LaneWatch camera.Note:
Connect the and RCA jacks to the audio AUX-IN jacks (if applicable).White Red
8-pin harness:
Connect the RCA jack to the subwoofer output jack.White
12-pin pre-wired ASWC-1 harness & 3.5mm jack:
This harness and 3.5mm jack is to be used along with the optional (sold separately) to ASWC-1
retain steering wheel audio controls. If the is not being used, disregard this harness. If ASWC-1
it will be used, refer to the vehicle specific instruction from Axxess Interfaces for radio ASWC-1
connections and programming. Disregard the harness that comes with the .ASWC-1
The Gray/Blue wire will only be used in vehicles equipped with Bluetooth. Connect this wire
to the Yellow wire in pin-15 from the 32-pin harness in the factory Bluetooth module.
Bluetooth module location:
Civic - Behind glovebox
CR-V - In dash, under radio
Continue to Installation


Product specificaties

Merk: Metra
Categorie: Niet gecategoriseerd
Model: HDCC-02

Heb je hulp nodig?

Als je hulp nodig hebt met Metra HDCC-02 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Metra

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd