Metra GMOS-MOST-02 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Metra GMOS-MOST-02 (5 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 15 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/5
CAUTION!
All accessories, switches, climate
controls panels, and especially air bag indicator
lights must be connected before cycling the
ignition. Also, do not remove the factory radio
with the key in the on position, or while the
vehicle is running.
GMOS-MOST-02
I N S TA L L AT I O N I N S T R U C T I O N S
AxxessInterfaces.com © COPYRIGHT 2018 METRA ELECTRONICS CORPORATION REV. 3/2/18 INSTGMOS-MOST-02
INTERFACE FEATURES
INTERFACE COMPONENTS
TOOLS REQUIRED
• Cutting tool • Crimping tool • Tape
• Connectors (example: butt-connectors, bell
caps, etc.) • Small flat-blade screwdriver
TABLE OF CONTENTS
Connections to be made ....................................2-3
Installing the GMOS-MOST-02 ...............................3
Programming the GMOS-MOST-02 .......................4
Adjusting the GMOS-MOST-02 ...............................4
GM MOST® Amplifier Interface 2014-up*
APPLICATIONS
Provides accessory power (12-volt 10-amp)
Retains R.A.P. (retained accessory power)
Retains OnStar / OE Bluetooth
Retains warning chimes
Provides NAV outputs (parking brake, reverse, speed sense)
Pre-wired ASWC-1 harness (ASWC-1 sold separately)
Retains the factory backup camera
Used in MOST ® amplified applications
Adjustable gain control for overall volume
High level speaker input
Retains balance
Micro “B” USB updatable
CHEVROLET
Corvette 2014-up Impala 2014-up
• GMOS-MOST-02 interface
• GMOST-MOST-02 harness
• 16-pin harness with stripped leads
• Backup camera harness
• 10-pin jumper harness
*Visit AxxessInterfaces.com for up-to-date vehicle specific applications.
2
CONNECTIONS TO BE MADE
From the 16-pin harness with stripped leads to the aftermarket radio:
Connect the Red wire to the accessory wire.
Note:
If installing an ASWC-1 (sold separately), there will be an accessory wire there to
connect as well.
Connect the Blue/White wire to the amp turn on wire. This wire must be connected to hear
sound from the factory amplifier.
If the aftermarket radio has an illumination wire, connect the Orange/White wire to it.
If also installing an ASWC-1 (sold separately), connect the Brown wire to the wire in Brown
the 12-pin pre-wired ASWC-1 harness.
Connect the Gray wire to the right front positive speaker output.
Connect the Gray/Black wire to the right front negative speaker output.
Connect the White wire to the left front positive speaker output.
Connect the White/Black wire to the left front negative speaker output.
Connect the Green wire to the left rear positive speaker output.
Connect the Green/Black wire to the left rear negative speaker output.
Connect the Purple wire to the right rear positive speaker output.
Connect the Purple/Black wire to the right rear negative speaker output.
The following (3) wires are only for multimedia/navigation radios that require these wires.
Connect the Blue/Pink wire to the VSS/speed sense wire.
Connect the Green/Purple wire to the reverse wire.
Connect the Light Green wire to the parking brake wire.
From the GMOS-MOST-02 harness to the aftermarket radio:
Connect the Black wire to the ground wire.
Connect the Yellow wire to the battery wire.
Disregard the Red wire, it will not be used in this application.
Disregard the Red & White RCA jacks, they will not be used in this application.
12-pin pre-wired ASWC-1 harness:
This harness is to be used along with the ASWC-1 (sold separately) to retain steering wheel
audio controls. If the ASWC-1 is not being used, disregard this harness. If it will be used,
please refer to the ASWC-1 instructions for radio connections and programming.
Note: Disregard the harness that comes with the ASWC-1.
Connect the Red wire to the accessory wire.
Connect the Brown wire to the Brown wire from the 16-pin harness with stripped leads.
Connect the Green/Black
wire, to the wire Green/Black
in the 10-pin Black connector
located in the steering
column. (Figure A)
(Figure A)
Green/Black wire
Continued on the next page
3
REV. 3/2/2018 INSTGMOS-MOST-02
CONNECTIONS TO BE MADE (CONT.) INSTALLING THE GMOS-MOST-02
DIN jack:
Disregard the DIN jack, it will not be used in this application.
Note: The relay attached to the GMOS-MOST-02 harness is only for audible turn signal clicks. No
extra steps are required to retain this feature, so leave the relay as-is.
From the backup camera harness to the aftermarket radio:
If the vehicle is equipped with a factory backup camera, connect the Yellow RCA jack to the
backup camera input.
With the key in the off position:
Locate the radio brain and Human Machine Interface module (HMI):
Corvette:
Radio Brain: Passenger foot-well
HMI: Left side of dash
Impala:
Radio Brain & HMI: Under passenger side dashboard
Connect the
GMOS-MOST-02 harness
to the 20-pin Gray connector, and 8-pin Light Gray
connector, removed from the radio brain.
Connect the
backup camera harness
to the 12-pin Gray connector removed from the
HMI module.
Connect the
16-pin harness with stripped leads
, and the
GMOS-MOST-02 harness
, into the
GMOS-MOST-02 interface.
If the vehicle is equipped with a media player, connect the
10-pin jumper harness
to the
connector removed from the media player.
Note: If also installing an ASWC-1, connect it after you program and test the GMOS-MOST-02,
with the key in the off position.


Product specificaties

Merk: Metra
Categorie: Niet gecategoriseerd
Model: GMOS-MOST-02

Heb je hulp nodig?

Als je hulp nodig hebt met Metra GMOS-MOST-02 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Metra

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd