Metra 99-5720L Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Metra 99-5720L (4 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 12 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
IMPORTANT
Installation Kit
120 99-5720L
Before starting, compare items on your invoice with items
received. If any parts are missing, first carefully check through
packaging material. If an item is missing, please call:
Crutchfield
Parts Supplied:
Ford/Mercury
Revision 08/27/02
Kit assembly instructions are on the following pages.
Page 1 of 4
*120995720L*
®
Copyright 2002 Crutchfield Corporation
Tools Required
Flat Blade
Screwdriver
T15 Torx
Driver
Receiver Mounting Bracket
(wiring attached)
Shaft Receiver Mounting Insert
Kit includes all necessary wiring adaptors.
at 1-888-955-6000
Installation Kit
120 99-5720L
DIN Sleeve
Temperature Control Switch
Receiver Mounting Bracket
1. Remove factory radio/climate control assembly
following instructions in the Mastersheet for
your particular vehicle.
2. Turn climate control knobs in the vertical
position and pull knobs to remove.
3. Remove two (2) torx screws securing
temperature control switch and fan switch
(one screw from each) from back of factory
assembly. Remove switches. Unclip vent
control switch and remove.
4. Secure all switches to rear of new receiver
mounting bracket in the same manner. Use
hardware previously removed (Figure 1).
5. Hold climate control knobs in the vertical
position and push onto shafts of switches
(Figure 1).
6. Remove DIN sleeve from receiver (Figure 2).
Slide sleeve into opening in receiver mounting
bracket and secure to bracket by bending the
securing tabs (Figures 3 & 4).
7. Slide receiver into DIN sleeve/mounting
bracket assembly (Figure 3).
Make wiring connections following
instructions on the next page.
Securing Tabs
Bend tabs after sleeve is inside
receiver mounting bracket.
FIGURE 1
IMPORTANT
Before starting, compare items on your invoice with items
received. Carefully check packing materials.
If an item is missing, please call:
Crutchfield
®
Copyright 2002 Crutchfield Corporation
FIGURE 2
FIGURE 4
FIGURE 3
Fan Control Switch
Vent Control Switch
Climate Control Knobs
2
ASSEMBLY - DIN UNIT
See the Crutchfield Mastersheet if installing a shaft unit.
at 1-888-955-6000
Speaker Adaptor Plug
Installation Kit - Receiver/Amplifier Bypass Wiring Adaptors
120 99-5720L
If your receiver does not have
a dimmer or illumination wire,
tape off the Orange/White wire.
Connect wires below to the matching function of
each wire on your receiver (refer to instructions
supplied with receiver).
IMPORTANT: The wire colors of your new receiver
may, or may not, match the wire colors of the
adaptor. Match adaptor and receiver wires by
function, disregarding color.
Install adaptor harnesses following
instructions on the next page.
CONNECT WIRES
Individually tape off any unused wires.
Red -12 Volts Switched Power
Yellow -12 Volts Constant Power
Orange/White - Dimmer
Black - Chassis Ground
®
Copyright 2002 Crutchfield Corporation
Power Adaptor Plug
Blue - Power Antenna
Soldering Instructions
1. Strip wires back 1/2”.
2. Tightly twist wires together.
3. Solder:
a. Heat wire.
b. Touch solder to wire, not to iron.
4. Tape
3
Note: Wires are
longer than shown
in illustration.
Violet/Black -Right Rear Speaker Negative
Violet - Right Rear Speaker Positive
Green - Left Rear Speaker Positive
Gray - Right Front Speaker Positive
Gray/Black - Right Front Speaker Negative
Green/Black - Left Rear Speaker Negative
White - Left Front Speaker Positive
White/Black - Left Front Speaker Negative


Product specificaties

Merk: Metra
Categorie: Niet gecategoriseerd
Model: 99-5720L

Heb je hulp nodig?

Als je hulp nodig hebt met Metra 99-5720L stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Metra

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd