Metra 70-1618 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Metra 70-1618 (2 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 52 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
Yellow - 12 Volts Constant Power
Blue - Power Antenna
Match wires below to the matching function of each wire on your receiver (refer to instructions supplied with receiver). The wire colors of your
new receiver may, or may not, match the wire colors of the adaptor. Match adaptor and receiver wires by function, disregarding color.
Your receiver illumination wire could be Orange or Orange/White. As with other wires, match this wire to illumination wire in this harness by
function, not by color. If your receiver does not have an illumination wire, tape off the illumination wire.
Individually tape off any unused wires.
Make final wiring connections following instructions on the next page.
Receiver Wiring Adaptor
120 70-1618
Revision 12/08/14
STEP 1 -- MATCH & CONNECT WIRES
*120701618*
IMPORTANT
Before starting, compare items on your invoice with items
received. Thoroughly check packing materials. If an item
is missing, please call Crutchfield at 1-888-955-6000.
A.
B.
C.
D.
Copyright 2014 Crutchfield Corporation
Orange/White - Illumination
IMPORTANT: Audi and VW do not supply a switched 12 Volt source
for the receiver. The 12 volt constant and 12 volt switched wires of
your receiver can be wired to the yellow of this harness or the fuse
block may be used for a 12 volt switched source.
Gray/Black - Right Front Speaker Negative
White/Black - Left Front Speaker Negative
Black - Chassis Ground
White - Left Front Speaker Positive Gray - Right Front Speaker Positive
Receiver Wiring Adaptor Connections
120 70-1618
Page 2
STEP 2 -- CONTINUED
A. Strip wires back 1/2”.
B. Twist wires together and
insert in crimp cap.
C. Squeeze middle of cap
for tight connection.
Copyright 2014 Crutchfield Corporation
STEP 3 -- APPLICATION
When ready to install the receiver, plug
the Wiring Adaptor from the new receiver
or receiver assembly into the factory
radio harness(es) in the vehicle dash.
D. Complete crimp connections
for all necessary wires.
E. Be sure to wrap any wires from
the Wiring Adaptor that are
not necessary (wires with no
match from the new receiver)
with electrical tape.
STEP 2 -- CRIMP CONNECTIONS
Tools & Parts
Required
Wire Stripper/Crimp Tool Crimp Caps
Unused Wire (tape over bare wires)
Receiver Wiring Adaptor
Generic Illustration
Generic Illustration


Product specificaties

Merk: Metra
Categorie: Niet gecategoriseerd
Model: 70-1618

Heb je hulp nodig?

Als je hulp nodig hebt met Metra 70-1618 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Metra

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd