Marantz ST-4000 Handleiding


Lees hieronder de đź“– handleiding in het Nederlandse voor Marantz ST-4000 (9 pagina's) in de categorie Audio tuner. Deze handleiding was nuttig voor 30 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/9
R
TUNER
Model ST4000 User Guide
3
ENGLISHFRANçaISDEUTSCH
NEDERLANDS
ESPAĂ‘OLITALIANOPORTUGUĂŠSSVENSKADANSK
FOREWORD
Be sure to read this section before any connection to the mains supply.
WARNINGS
Never expose the equipment to rain or moisture.
Never remove the equipment’s cover.
Never insert anything into the equipment’s vents.
Never handle the mains lead while your hands are wet.
EQUIPMENT MAINS WORKING SETTING
This Marantz product is available in two different variations, depending
on geographical area. One variation has a preset mains voltage (230V
for General Europe model and U.K. model), while the other variation
features variable voltage that can be selected using a voltage selector
on rear panel (115V/230V).
The voltage selector must be set for your local mains voltage before
any connection to the mains supply. If you need to change its voltage
setting, consult your dealer your local Marantz service provider.
IMPORTANT: (FOR U.K. MODEL)
This apparatus is fitted with an approved moulded 13 Amp plug.
To change a fuse in this type of plug proceed as follows:
1. Remove fuse cover and fuse.
2. Fix new fuse which should be a BS1362 5A, A.S.T.A. or BSI ap-
proved type.
3. Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it should be cut
off and an appropriate plug fitted in its place.
If the mains plug contains a fuse, this should have a value of 5A. If a
plug without a fuse is used, the fuse at the distribution board should not
be greater than 5A.
NOTE:
The severed plug must be destroyed to avoid a possible shock hazard
should it be inserted into a 13A socket elsewhere.
HOW TO CONNECT A PLUG (FOR U.K. MODEL)
The wires in the mains lead are coloured in accordance with the follow-
ing code:
BLUE— “NEUTRAL” (“N”)
BROWN—“LIVE” (“L”)
1. The BLUE wire must be connected to the terminal which is marked
with the letter “N” or coloured BLACK.
2. The BROWN wire must be connected to the terminal which is marked
with the letter “L” or coloured RED.
3. Do not connect either wires to the earth terminal in the plug which is
marked by the letter “E” or by the safety earth symbol or coloured˙
green or green-and-yellow.
Before replacing the plug cover, make certain that the cord grip is
clamped over the sheath of the lead—not simply over the two wires.
COPYRIGHT
Recording and playback of any material may require previous consent.
Refer to the following for further information.
— Copyright Act 1956
— Dramatic and Musical Performers Act 1958
— Performers Protection Acts 1963 and 1972
— Any subsequent statutory enactments and orders
INTRODUCTION
Thank you for selecting the Marantz ST4000 FM/AM Stereo Tuner for
your system.
Please read these operating instructions carefully. We recommend that
you read the entire user guide before you attempt to connect or operate
the Tuner.
After you have reviewed the contents of this manual, we suggest that
you make all system connections before you attempt to operate the
unit.
Refer to the figures on the pages at the back of this user’s guide. The
callout numbers on the figures correspond to those found in the text. All
references to the connections and controls that are printed in BOLD
type are as they appear on the unit.
INSTALLATION
Remember the following important points when installing the Tuner.
• Do not expose the component to rain or moisture, as this may cause
damage to the Tuner.
• Prevent extra heat from reaching the unit. Never put the Tuner in the
full glare of the sun or near a heat source.
PRECAUTIONS
The following precautions should be taken when operating the equip-
ment.
GENERAL PRECAUTIONS
When installing the equipment ensure that:
— air is allowed to circulate freely around the equipment.
— it is placed on a vibration-free surface.
— it will not be exposed to excessive heat, cold, moisture or dust.
— it will not be exposed to direct sunlight.
— it will not be exposed to electrostatic discharges.
In addition, never place heavy objects on the equipment.
If a foreign objector water does enter the equipment, contact your near-
est dealer or service center.
Do not pull out the plug by pulling on the mains lead; grasp the plug
itself.
It is advisable when leaving the house, or during a thunderstorm, to
disconnect the equipment from the AC outlet.
ST4000 FEATURES
• 60-station (FM30, AM30) preset memory with auto preset memory
function.
• Up to 120-minute sleep timer.
• Radio Data System. (Europe version only)
• Timer ON/OFF.
4
ENGLISHFRANçaISDEUTSCH
NEDERLANDS
ESPAĂ‘OLITALIANOPORTUGUĂŠSSVENSKADANSK
!0 ST. NAME Button (See page 5)
!1 NEXT Step Button (See page 5)
!2 FM MODE Button
Used to select stereo or mono when listening to FM broadcasts.
NOTES:
• The AM scan step can be changed by pressing the FM MODE
buttons simultaneously for 5 seconds. (overseas version only)
!3 MEMORY Button
•MANUAL: To preset or ( ) in the system, pres brieflyFM AM MW
(0.5 second or less).
•AUTO: When you press the button for long (more than 0.5 sec-
ond), FM or ( ) broadcasting will automatically be presetAM MW
in the system.
!4 BAND selector Button
Press the button to switch between and FM AM ( ) bands.MW
CONTROLS AND THEIR FUNCTIONS (See
page 50)
qPOWER (STANDBY/ON) Button
wSLEEP Button
eTIMER Button
Press this button with DAILY preset and the indicator will shown on
the display.
rMulti-function Display
zSLEEP Indicators
xRDS, FILE, SLEEP TIME mode Indicators
•RDS: PS , PTY DATA RDS will be displayed, and indicator
lights.
•FILE: Alphabets, symbols, and numbers will be displayed
when you write a broadcasting name with File Button (up to
4 letters).
•Timer mode: DAILY When the function is programmed, the
daily ON/OFF times will be shown in the display.
cTuned Indicator
This indicator lights when correctly tuned to a broadcast.
vSTEREO Indicator
This indicator will light up when FM stereo broadcasting is re-
ceived.
bTIMER Indicator
nFrequency mode, TIME Indicator
• The frequencies of , ( ) will be displayed.FM AM MW
• Hour, Minute: When you program current time, DAILY, the
times of On/Off, and the hour and minute of among CT RDS
will be displayed.
mChannel Display
The channel number selected by use of the PRESET UP/DOWN
button will be shown in the display.
,Signal Indicator
The reception status of the broadcasting.
.MEMORY Indicator
tPRESET UP/DOWN Buttons
•Broadcast Memory function: Each time you press the PRESET
UP/DOWN button briefly (for 0.5 second or less), you can listen
to broadcasts in a programmed sequence. This function is used
to memorize or ( ) broadcasting, or to select memo-FM AM MW
rized broadcasts.
yTUNING UP/DOWN Buttons ( / )â–Ľ â–˛
Used to select the broadcast you want to listen to or adjust the
current time, DAILY SLEEP , presets, etc.
uDISPLAY Buttons
1) The button works only when you receive FM broadcasting sta-
tions, and is used to set the mode.RDS
2) Press the button longer than 1 second, and search willPTY
become operable.
iDAILY Button
oTIME ADJUST Button (See page 5)


Product specificaties

Merk: Marantz
Categorie: Audio tuner
Model: ST-4000

Heb je hulp nodig?

Als je hulp nodig hebt met Marantz ST-4000 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden