Marantec Comfort TU500 Handleiding
Marantec
Garagepoortopener
Comfort TU500
Lees hieronder de đ handleiding in het Nederlandse voor Marantec Comfort TU500 (40 pagina's) in de categorie Garagepoortopener. Deze handleiding was nuttig voor 38 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/40
COMFORT TU
TU500, TU800
Gear-motor for sliding gates
Getriebe fĂŒr Schiebegitter
Motoriduttori per scorrevoli
Motoreducteur pour coulissants
Motorreductores para rejas correderas
Motorredutores para portÔes de correr
NapÄd silnikowy do bram przesuwnych
Motoriduttore interrato
Under grounded gear motor
Motoreducteur enterré
Motorreductor interrado
Unrterflur-Drehtorantrieb
Motorredutor interrado
Podziemny motoreduktor
UNDER
Istruzioni ed avvertenze per lâinstallazione e lâuso
Instructions and warnings for installation and use
Instrucciones y advertencias para su instalaciĂłn y uso
Anleitungen und Hinweise zu Installation und Einsatz
InstruçÔes e advertĂȘncias para a instalação e utilização
Instructions et avertissements pour lâinstallation et lâusage
Management
System
ISO 9001:2008
www.tuv.com
ID 9105043769
2
EN
INDEX
1
2
3
7
4
5
6
Safety warnings
2.1
2.2
4.1
4.2
4.3
4.4
4.5
5.1
5.2
Product overview
Product description
Set panel and technical characteristics
Preliminary checks
EC Declaration of Conformity
Installing the product
Installing
Fixing
Rack assembling
Limit switch îżxing
Manual running
Testing and commissioning
Testing
Commissioning
Figures
pag. 3
pag. 4
pag. 4
pag. 4
pag. 5
pag. 39
pag. 5
pag. 5
pag. 6
pag. 6
pag. 6
pag. 6
pag. 6
pag. 6
pag. 6
pag. 37
3
EN
1 - SAFETY WARNINGS
ORIGINAL INSTRUCTIONS - important safety instructions. Fol-
low the instructions since incorrect installation can lead to se-
vere inquiry! Save these instructions.
Read the instructions carefully before proceeding with installation.
The design and manufacture of the devices making up the
product and the information in this manual are compliant with
current safety standards. However, incorrect installation or
programming may cause serious injury to those working on or
using the system. Compliance with the instructions provided
here when installing the product is therefore extremely impor-
tant.
If in any doubt regarding installation, do not proceed and contact the
Marantec Technical Service for clariîżcations.
Under European legislation, an automatic door or gate system
must comply with the standards envisaged in the Directive
2006/42/EC (Machinery Directive) and in particular standards
EN 12453; EN 12635 and EN 13241-1, which enable declaration
of presumed conformity of the automation system.
Therefore, îżnal connection of the automation system to the electri-
cal mains, system testing, commissioning and routine maintenance
must be performed by skilled, qualiîżed personnel, in observance of
the instructions in the âTesting and commissioning the automation
systemâ section.
The aforesaid personnel are also responsible for the tests required
to verify the solutions adopted according to the risks present, and for
ensuring observance of all legal provisions, standards and regula-
tions, with particular reference to all requirements of the EN 12453
standard which establishes the test methods for testing door and
gate automation systems.
Before starting installation, perform the following checks and
assessments:
ensure that every device used to set up the automation system is
suited to the intended system overall. For this purpose, pay special
attention to the data provided in the âTechnical speciîżcationsâ sec-
tion. Do not proceed with installation if any one of these devices is
not suitable for its intended purpose;
check that the devices purchased are suïcient to guarantee system
safety and functionality;
perform a risk assessment, including a list of the essential safety
requirements as envisaged in Annex I of the Machinery Directive,
specifying the solutions adopted. The risk assessment is one of the
documents included in the automation systemâs technical îżle. This
must be compiled by a professional installer.
Considering the risk situations that may arise during instal-
lation phases and use of the product, the automation system
must be installed in compliance with the following safety pre-
cautions:
never make modiîżcations to any part of the automation system other
than those speciîżed in this manual. Operations of this type can only
lead to malfunctions. The manufacturer declines all liability for da-
mage caused by unauthorised modiîżcations to products;
if the power cable is damaged, it must be replaced by the manufac-
turer or its after-sales service, or in all cases by a person with similar
qualiîżcations, to prevent all risks;
do not allow parts of the automation system to be immersed in water
or other liquids. During installation ensure that no liquids are able to
enter the various devices;
should this occur, disconnect the power supply immediately and
contact a Marantec Service Centre. Use of the automation system in
these conditions may cause hazards;
never place automation system components near to sources of heat
or expose them to naked lights. This may damage system compo-
nents and cause malfunctions, îżre or hazards;
The drive shall be disconnected from its power source during
cleaning, maintenance and when replacing parts. If the discon-
nect device is not in a visible location, aïx a notice stating:
âMAINTENANCE IN PROGRESSâ:
connect all devices to an electric power line equipped with an
earthing system;
the product cannot be considered to provide eïective protection
against intrusion. If eïective protection is required, the automation
system must be combined with other devices;
the product may not be used until the automation system âcommis-
sioningâ procedure has been performed as speciîżed in the âAutoma-
tion system testing and commissioningâ section;
the system power supply line must include a circuit breaker device
with a contact gap allowing complete disconnection in the conditions
speciîżed by class III overvoltage;
use unions with IP55 or higher protection when connecting hoses,
pipes or cable glands;
the electrical system upstream of the automation system must com-
ply with the relevant regulations and be constructed to good wor-
kmanship standards;
this appliance can be used by children aged from 8 years and above
and persons with reduced physical, sensory or mental capabilities or
lack of experience and knowledge if they have been given supervi-
sion or instruction concerning use of the appliance in a safe way and
understand the hazards involved;
before starting the automation system, ensure that there is no-one
in the immediate vicinity;
before proceeding with any cleaning or maintenance work on the
automation system, disconnect it from the electrical mains;
special care must be taken to avoid crushing between the part ope-
rated by the automation system and any îżxed parts around it;
children must be supervised to ensure that they do not play with the
equipment.
that the drive cannot be used with a driven part incorporating a wi-
cket door unless the drive can only be operated with the wicket door
in the safe position;
The automation system component packaging material must
be disposed of in full observance of current local waste dispo-
sal legislation.
Marantec reserves the right to amend these instructions if ne-
cessary; they and/or any more recent versions are available at
www.marantec.com
Frequently examine the installation for imbalance where ap-
plicable and signs of wear or damage to cables, springs and
mounting.
Do not use if repair or adjustment is necessary.
ATTENTION !
ATTENTION !
ATTENTION !
ATTENTION !
ATTENTION !
Product specificaties
| Merk: | Marantec |
| Categorie: | Garagepoortopener |
| Model: | Comfort TU500 |
Heb je hulp nodig?
Als je hulp nodig hebt met Marantec Comfort TU500 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Garagepoortopener Marantec
19 Juli 2023
19 Juli 2023
19 Juli 2023
19 Juli 2023
19 Juli 2023
19 Juli 2023
19 Juli 2023
19 Juli 2023
19 Juli 2023
19 Juli 2023
Handleiding Garagepoortopener
- Garagepoortopener Abon
- Garagepoortopener Aperto
- Garagepoortopener Berner
- Garagepoortopener Budgetgaragedeuren
- Garagepoortopener Dickert
- Garagepoortopener DITEC
- Garagepoortopener Doco
- Garagepoortopener Doorsystems
- Garagepoortopener Einhell
- Garagepoortopener Entrematic
- Garagepoortopener FAAC
- Garagepoortopener Geba Tronic
- Garagepoortopener Goris
- Garagepoortopener Homentry
- Garagepoortopener Hormann
- Garagepoortopener Liftmaster
- Garagepoortopener MAC
- Garagepoortopener Novoferm
- Garagepoortopener Novotecnica
- Garagepoortopener Profitech
- Garagepoortopener Rademacher
- Garagepoortopener Seculux
- Garagepoortopener Silver
- Garagepoortopener Skylink
- Garagepoortopener Somfy
- Garagepoortopener Sommer
- Garagepoortopener Superrollo
- Garagepoortopener Tormatic
- Garagepoortopener Craftsman
- Garagepoortopener Chamberlain
- Garagepoortopener Maveo
Nieuwste handleidingen voor Garagepoortopener
1 December 2023
2 Oktober 2023
2 Oktober 2023
16 September 2023
16 September 2023
16 September 2023
16 September 2023
16 September 2023
16 September 2023
16 September 2023