Majella MCVC Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Majella MCVC (4 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 84 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
!
!
!
!
!
!
!
!
!
MVCF-I USER MANUAL
Version 1.0
!
!
!
!
!
!
Voltage contolled Filter ( -I) MVCF
User Manual
©2020 Majella Audio
2
INTRODUCTION
The MVCF-I is 12dB/oct voltage controlled
filter, with lowpass and hi-pass mode. The
MVCF-I has voltage controlled resonance
and cutoff. There is control over the input
gain and the resonance can be driven into
self-oscillation.
CONTENT
In the box of the assembled version of the
MVCF-I . contains the following
•!Assembled and Tested Module
•!16 pin to 16 pin ribbon cable
•!Mounting hardware: M3 4x screws
and M3 washers / rack crash
protectors
If anything of the above is missing. Please
contact your dealer or support@majella-
audio.com
SPECIFICATIONS
•!Dimensions: 128.5 x 30 x 45 mm
(6HP)
•!Doepfer A-100 Eurorack compatible
(16 pin power connector)
•!Power consumption: +/- 12V (15mA)
POWER CONNECTION
This module is designed to be connected to
your Eurorack system, using a 16- pin ribbon
cable. The -12V (red stripe) should be
directed as shown in . the picture below
W A RN IN G !
This module is designed for Eurorack
systems. The supply should be +-12V and
connected signals should not be out of the
+-12V range!
Do not reverse polarity when
connecting the power, this will damage
your module permanently!
Voltage contolled Filter ( -I) MVCF
User Manual
©2020 Majella Audio
3
OVERVIEW
OVERVIEW
OVERVIEW
OVERVIEW OVERVIEW (See figu
(See figu
(See figu
(See figu(See figure 1)
re 1)
re 1)
re 1)re 1)
CONTROLS
1.!C U TOF F
Controls the cutoff frequency from 0Hz to
17kHz.
2.!RESONANCE
Controls the resonance amount from 0dB
up to self-oscillation from 95% knob turn.
3.!CUTOFF AMO U N T
Controls the amount of control voltage that
controls the cutoff ( frequency see 9).
4.!RESONANCE AMOU N T
Controls the amount of control voltage that
controls the resonance (see 10).
5.!GAIN
Controls the input signal gain.
6.!HI- PASS button
Normally the MVCF-I is a lowpass VCF.
When this button is pressed the MVCF-I is a
hi-pass VCF.
CONNECTIONS
7.!INPUT
Audio (VCO) input.
8.!OUTPUT
Audio output.
9.!CUTOFF
Control voltage input to control cutoff
frequency.
10.!RESONANCE
Control voltage input to control resonance
amount.
Figure 1: Overview


Product specificaties

Merk: Majella
Categorie: Niet gecategoriseerd
Model: MCVC

Heb je hulp nodig?

Als je hulp nodig hebt met Majella MCVC stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Majella

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd