Light & Motion CLx10 Handleiding

Bekijk gratis de handleiding van Light & Motion CLx10 (2 pagina’s), behorend tot de categorie Verlichting. Deze gids werd als nuttig beoordeeld door 27 mensen en kreeg gemiddeld 5.0 sterren uit 7 reviews. Heb je een vraag over Light & Motion CLx10 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

OWNER’S MANUAL

* The light will run at full power off external external source as long as

1- the battery is charged to 60% or more

2- power supply minimum 110Watt

Light will operate best on external power if internal battery is charged

60% or more. If the light is run off wall power with an empty battery,

the extra heat generated while charging may reduce the output.

OPERATING FROM EXTERNAL POWER

OPERATING THE CLx WITH

SOFTBOXES

When using 3rd-Party modifers that cover

the heat sink, trapped heat can cause

the light to lower it’s output. To prevent

overheating, open the modifier vents or

dial back to a lower lumen output.

MENU DISPLAY

OPERATION SPECIFICATION

DETAILED OPERATIONS

AUTO FAN OPERATION

Auto fan behavior

0-4000 lumens - fan off

4000+ to 6400 lumens - fan low

over 6400 lumens - fan high

charging - fan low

MENU SCREEN

• Long press of middle button access /exits menu

• Short press of front/rear button adjusts the

selected option up/down.

• Short press of middle button advances to

the next option (i.e. if the group setting was

selected, it would advance the frequency. The

selected option blinks slowly so you know which

one is active).

• After 20sec pass without a button press, the

menu screen will exit.

OPERATION

OFF

ON

Power Knob

MODE

Short Press = Step Increase/Decrease

Long Press = Smooth Increase /

Decrease Output

Short Press = ON/OFF

Long Press = Menu Settings

RF ON/OFF

Group (1-4)

Frequency /Channel (1-20)

/

/

/

Percentage / Lumen Output

External Power Supply Wattage

Lm

60w110w

110w

Power Supply

YS MOUNT W/

UMBRELLA HOLDER

• FLAT PORT DM

CSTAND MOUNT

HIGH LEVERAGE

HANDLE

THUMB SCREW

INCLUDED MODIFIERS

INCLUDED

MOUNTS

Light & Motion

711 Neeson Road,

Marina, CA 93933 USA

[email protected]om

lightandmotion.com

Must be on to charge

ELINCROM MODIFIER

MOUNT

Short Press: Moves Up

Short Press: Cycles through settings

Long Press: Enter / Exit

Short Press: Moves Down

MENU CONTROLS

Thermal Sensor is not Detect

Return unit to Light and Motion for

servicing.

Overheating Icon

Wait to charge until

symbol disappears

LED is not detected

Battery Status

Light Operating With

External Power

Lumen/Percentage Output

8000/5000

POWER

LUMENS

MIN

90

LED

8000

External Power Detected

Overheating icon

OLED DISPLAY

CARE & MAINTENANCE

• Maintain o-rings with a light coating of silicone grease to preserve seal.

• Clean charge terminals with rubber pencil eraser or cotton-tipped or foam-tip

swab with vinegar/water solution.

STORAGE & TRAVEL

• Never store the lights with the batteries fully discharged as this may cause

permanent damage to the batteries.

• Store your light partially to fully charged for long life.

• Do not leave lights in direct sun or stored in hot location.

• Turn power switch off for travel.

• Always operate the CLx with a DM modifier installed to protect the LED from dust

and moisture.

Product specificaties