Liftmaster LA412UL Handleiding

Bekijk gratis de handleiding van Liftmaster LA412UL (2 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 70 mensen en kreeg gemiddeld 4.9 sterren uit 6 reviews. Heb je een vraag over Liftmaster LA412UL of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Doc 6001309 (01-20289) Page 1 of 2 Rev A

Use the following procedure to remove and replace a LiftMaster Swing Gate Operator cover:

WARNING

Failure to follow the instructions in Step 1 may cause injury due to unexpected gate movement.

Always wait one minute after power-off to service the gate.

1.Turn off power to the gate operator at the circuit breaker and wait for one minute. Thegate

will move after one minute if system has the Power Fail Option.

2. When you are certain that the gate will not move due to Power Fail Option operation:

A) Disconnect the Drag Link from the gate Anchor.

B) Loosen the locking nut and mounting bolt, then remove the Swing Arm Cap Assembly and

Drag Link Assembly from the drive shaft. Set this assembly aside.

3. Remove the four cover mounting bolts and remove the gate operator cover.

4. If new cover has optional door: Remove the two top mounting screws from the control box clear

plastic cover. NOTE: These screws must be removed or the control box clear plastic cover cannot

be removed through the gate operator cover door.

5. Install the new gate operator cover and secure with mounting hardware.

6. Reinstall the Drag Link, Swing Arm and Swing Arm Cap Assemblies.

7. Turn on power to the gate operator at the circuit breaker.

Swing Gate Cover Removal and Installation.

SWING GATE OPERATOR COVER

REMOVAL AND INSTALLATION

(WITH OR WITHOUT DOOR)

Product specificaties