LG LSW440B Handleiding

LG Muurbeugels LSW440B

Lees hieronder de 📖 handleiding in het Nederlandse voor LG LSW440B (3 pagina's) in de categorie Muurbeugels. Deze handleiding was nuttig voor 21 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/3

OWNER’S MANUAL

Wall Mounting Bracket

P/NO : MFL63640551 (1312-REV00)

Please read this manual carefully before operating

your set and retain it for future reference.

www.lg.com

(Brazil : www.lge.com)

LSW440B

ENGLISH

Do not wipe the product with a wet towel and do not use any

heater or humidifier below where the product is installed.

If water flows into the product or if moisture and heat are applied to the

product, it can cause a fire, an electric shock or problem to the product.

Unplug the power cord from the power outlet before

installing the product.

If you install the product with the power cord plugged, it can

cause an electric shock or a fire.

Do not install the product near any object that

may cause vibration.

Do not install the product near any high voltage power

cable or power source.

Do not install the product with bare hands. Always

wear proper work gloves.

It can cause an injury.

Do not allow the video connectors connected to the

display to press against the wall. Use the included

right-angle adapters if needed.

Only use attachments/accessories specified by the

manufacturer.

Install the product according to the directions in

the user manual.

If the product is not installed based on the directions in

the user manual, it can cause a serious injury or damage

to the product.

When drilling holes in the wall, always use a drill bit

and drill of designated diameter. Also follow the

designated directions for the depth of the hole.

If the product is installed without following the designated

method, the product may be unstable and cause a safety

issue.

When installing the product or adjusting the height of

the product after installing, always do so with 2 people.

Working alone can cause the product to fall off and result in

injury or damage to the product.

During the installation, check the type of wall

material and use the sealed anchor and screw if the

conditions comply.

If you do not use the designated anchor or screw, the

mount may not be able to withstand the weight of

the product and cause a safety issue.

Caution

Before installation

* Do not use the product for purposes other than mounting a display on the wall.

* When installing/using the wall mount, be cautious of product damage and avoid accidents.

* If you have not fully read and understood the installation manual, do not install the product and contact

the dealer to have a specialized installer install the product for you.

* Even if you are not a specialized installer, it is advantageous to have experience in mechanical or

construction field in completely understanding this manual and installing the product.

* This product is designed to be mounted to walls that use standard intervals between the studs.

* Install the screw to attach the wall mount so that it can be assembled at the center from both ends of

the studs. Use of stud finder, a separate device, is recommended.

* Install the product only on a vertical wall.

The manufacturer is not responsible for issue from installing the product on severely wall or on the

ceiling.

* Keep the included accessories out of reach of babies or children as it can cause safety issues including

suffocation from swallowing the parts.

* Make sure screws are tight against the wall, but do not overtighten.

* Be careful not to install a TV that exceeds the weight restrictions of the wall mount.

* Be careful with the tools used during installation to prevent accidents or damage.

ENGLISH

3How to install the wall mount

→ If the screw cannot be assembled in the designated

location inevitably, it can be assembled by rearranging

to the closest location. But, do not change 2 or more

locations from the designated spot.

→ Assemble the wall mount screw on 2 left and 2 right

location on the top part and 1 left and 1 right location

on the bottom part.

→ At this time, use a "+" driver (Manual or motorized) or

8 mm wrench to tighten the screw so that the wall, wall

bracket and screw are completely pressed against one

another.

1. Set the display with the guide spacer assembled on the wall mount bracket on the wall in arrow direction. At this time, align the

bottom assembly part and lift the set up lightly to align the top part.

2. When adjusting the location, assemble the provide safety clip as shown in the picture to prevent the product from moving.

Tighten the safety clip screw completely. If the safety clip is not tightened as shown in the picture, the product can fall off.

→ Pull on the bottom of the set to make sure the display is secure.

→ When installing a display rotated, only rotate the display 90 degrees (portrait mode). (Only applies for VESA 200X200,

400x400)

→ Make sure to keep a certain level of distance from the wall so that excessive force is not applied on the cable or accessory.

→ When you push the product with excessive force, the product can be damaged.

4 How to assemble the wall mount support and display

- Always install the display with 2 or more people.

Wall mount

screw

Safety clip

Safety clip screw

* Assemble the wall

mount support, product

and safety clip.

* Caution : Prevent the

power cord from being

pinched between the wall

mounting bracket and the

set when installing the set.

(A pinched power cord

may cause an electrical

short)

Product specificaties

Merk:	LG
Categorie:	Muurbeugels
Model:	LSW440B
Kleur van het product:	Zilver
Gewicht:	5200 g
Breedte:	460 mm
Diepte:	20 mm
Hoogte:	450 mm
Montagewijze:	Muur
Maximale gewichtscapaciteit:	50 kg
Paneelmontage-interface:	400 x 400 mm
Horizontaal draaibaar:	-15 - 15 °
Aantal displays ondersteund:	1
Bereik kantelhoek:	-12 - 12 °
Maximale schermgrootte:	65 "
Minimale schermgrootte:	42 "