Leisure LR8001 Handleiding

Bekijk gratis de handleiding van Leisure LR8001 (2 pagina’s), behorend tot de categorie Spoelbak. Deze gids werd als nuttig beoordeeld door 101 mensen. Heb je een vraag over Leisure LR8001 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

/ 2 PDF

05/04 1820

1. It is recommended that the inset sink is fi tted to the

worktop before being permanently fi xed to the cabi-

net.

2. Place the sink upside down on worktop. Position the

sink relative to the worktop as required, ensuring

that the cabinet framework will be clear of all parts of

the sink, or alternatively where provided use cut-out

template found on sink wrapper.

With sharp soft pencil

draw round sink as ac-

curately as possible.

3. Remove the sink and draw another line 10mm inside

the outline of the sink top.

This is the cutting line for the aperture.

4. Drill as large a hole as possible inside the cutting

line. Using a pad saw, jig saw or similar, cut out the

aperture to the cutting line.

5. Remove the paper backing from the quadrant section

and apply to all 4 corners of the sink.

Remove the protective back from the main seal and

stick to the underside of sink.

6. Attach the fi xing clips to the sink rail ensuring that

the two ‘prongs’ of the clip face inwards. Open the

hinge on the clip.

Stainless Steel Inset Sinks with Fixed Position Clips

7. Turn the sink upside down and lay the worktop over

the sink. Swing the clip into position. (This is the most

effective method although if the worktop has been

fi xed to the cabinet, the sink can be placed in the

aperture and the fi xing effected from underneath).

8. Loosely tighten the corner fi xing clips to centralise

the sink in the cut-out.

9. Tighten the fi xing screws.

Do not overtighten the fi xing clamps once the sink is

fully bedded in the sealing tape. Do not tighten fully

at the fi rst attempt.

10. In certain circumstances it may not be possible to fi t

a clip to all the fi xed positions; provided a good seal

is achieved it is not detrimental to omit clips where

diffi culty arises.

Recommended tightening sequence for sink

fi xing clips

Product specificaties