LandAirSea SilverCloud Handleiding
LandAirSea
GPS apparaat
SilverCloud
Bekijk gratis de handleiding van LandAirSea SilverCloud (10 pagina’s), behorend tot de categorie GPS apparaat. Deze gids werd als nuttig beoordeeld door 4 mensen en kreeg gemiddeld 4.9 sterren uit 2.5 reviews. Heb je een vraag over LandAirSea SilverCloud of wil je andere gebruikers van dit product iets vragen? Stel een vraag
Pagina 1/10
Contents of Box
1 - 54 unit
2 - Rubber waterproof gaskets - (1 pre-installed into device)
1 - On/off Tool
1 - Micro-USB charging cord
1 - Quick Start Guide (For Activation)
Original (Full) Tracking and Energy Saver Modes
The unit is automatically set on motion based tracking upon arrival. In this mode the unit
will track based on motion only, and enter a dormant sleep state when stationary. When the unit
is activated, and powered on we recommend taking it for a 10 - 15 minute drive to allow it to fully
connect with your account. The unit will begin tracking the movement based on the plan selected
upon activation. In the motion sensing Full/Original tracking mode the unit will enter its sleep
state after 2-3 minutes of motionlessness. During its period of sleep the unit is completely
dormant and will not discharge battery life.
In Energy Saver Mode (ESM), the unit's motion sensor is turned off and the unit is placed
onto a timer instead. The unit willThis will cause the unit to not update when it is in motion.
only wake up at the end of each cycle of time, attempt to register a new update, and then go back
to sleep.
To place the device into an ESM, navigate to the Energy Saver menu in the SilverCloud
mobile application. From this menu you will see the below options.
1. Update location every 30 minutes (10 to 15 day battery life)
2. Update location every 1 hour (15 to 30 day battery life)
3. Update location every 2 hours (1 to 1.5 month battery life)
4. Update location every 4 hours (1.5 to 2.5 month battery life)
5. Update location every 6 hours (2 to 3 month battery life)
6. Update location every 12 hours (3 to 4 month battery life)
7. Update location every 24 hours (4 to 6 month battery life)
8. Full or Original Tracking Mode (Your subscription rate)
*Please note the energy saver battery life projections are based on the device beginning
at 100% charged. Sending the energy saver commands force the unit to wakeWILL NOT
or connect.
Upon selecting one of these options and sending the command to your unit, the next
update it registers the unit will receive the command and shift into the option you have selected.
This means, if your unit is currently in an ESM, it will not receive the command to adjust settings
until the end of the cycle it was set to. (i.e. If the unit is in 24 hour ESM, it will not receive any
new commands until the 24 hour cycle elapses and the unit wakes up again. If the unit is
in full/original tracking mode it will not enter ESM until it senses motion.)
Update Rates/Subscription
The subscription plans available for the devices will relate to the rate at which the unit will
refresh its location while the device is in motion. This will determine how much detail the unit will
give you in between point A and B of its drive. Depending on the information you are looking to
receive from the device will determine which plan will be most beneficial for you. The available
plans are listed below.
1. 3-minute updates
2. 1-minute updates
3. 30-second updates
4. 10-second updates
5. 5-second updates
6. 3-second updates
* When on the 5 and 3 second update rates you will notice that the battery will discharge
slightly quicker than on the other plans.
Life of Battery and Charging
(Internal Battery: 3.7V 1500mAh, 350mA Max Input Rating: 4.5-5.5V 400mA Max)
In the device's stock Original or Full Tracking Mode, the battery life will depend on the
amount of driving or motion the unit goes through. The battery should last approximately 25
activity hours. It will only use the battery when the device is in motion, and when the device stops
moving it will enter a dormant sleep state. With most average drivers (1 to 2 hours of driving a
day), the unit should last approximately a week and a half to two weeks.
In the ESM options, the unit does not register with motion so the battery is able to last
much longer. You can find the approximate timeframes for the various energy saver modes in the
above section labeled .Original (Full) Tracking and Energy Saver modes
When charging your device, upon plugging in the unit you will see the red charging light
turn on. This means the device recognizes the charging cord being plugged in, and that it is
actively charging. Once the light turns off, the unit recognizes that it is 100% charged.
*If the device is brought indoors to charge, the unit may not be able to fully establish a
connection to update and show the new battery percentage online. At this point we recommend
ensuring the device is powered up and then take it outside to register a new update. Once the
unit is able to register an update online, you should see it reflect at 100% battery through the
SilverCloud mobile application and online portal. NOTE: If the battery drains the unit will
automatically power back on once attached to the charger, and does not need to be manually
turned on.
Product specificaties
| Merk: | LandAirSea |
| Categorie: | GPS apparaat |
| Model: | SilverCloud |
Heb je hulp nodig?
Als je hulp nodig hebt met LandAirSea SilverCloud stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding GPS apparaat LandAirSea
14 Juli 2025
Handleiding GPS apparaat
- Ventus
- Avidyne
- Optimus
- First Alert
- IFM
- Canyon
- Tragant
- Trackilive
- Tractive
- LG
- QStarz
- Teltonika
- Audiovox
- Fysic
- Orbit
Nieuwste handleidingen voor GPS apparaat
2 Juni 2025
2 Mei 2025
2 Mei 2025
1 Mei 2025
27 April 2025
26 Maart 2025
12 Maart 2025
10 Maart 2025
10 Maart 2025
9 Maart 2025