La Crosse Technology WS-9711U-IT Handleiding

La Crosse Technology Weerstation WS-9711U-IT

Lees hieronder de 📖 handleiding in het Nederlandse voor La Crosse Technology WS-9711U-IT (13 pagina's) in de categorie Weerstation. Deze handleiding was nuttig voor 37 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/13

Contents

Language Page

___________________________________________________________

English 2

French 53

Spanish 103

WIRELESS 915 MHz TEMPERATURE STATION

Instruction Manual

TABLE OF CONTENTS

Topic Page

Inventory of Contents 3

Features 4

Setting Up 6

WWVB Radio Controlled Time 9

Battery Installation 10

Function Keys 12

LCD Screen and Settings 14

Manual Settings 18

Alarm setting 33

Weather Forecast and Tendency 34

Display of Temperature and Humidity Readings 38

Sunrise, sunset, sun duration 41

Moon phases 42

915 MHz Reception 43

Positioning 44

Care and maintenance 46

Specifications 47

Warranty 48

FCC Disclaimer 51

INVENTORY OF CONTENTS

1. Wireless Temperature Station WS-9711U-IT

2. Wireless Temperature Transmitter TX29U-IT

3. Instruction Manual

INSTANT TRANSMISSION is the state-of-

the-art new wireless transmission

technology, exclusively designed and

developed by LA CROSSE TECHNOLOGY.

INSTANT TRANSMISSION oers you an

immediate update (every 4 seconds!) of all

your outdoor data measured from the

transmitters: follow your climatic

variations in real-time!

This product offers:

LCD Display

Function Keys

FEATURES:

The Weather Station

 WWVB Radio controlled time with manual setting options

 WWVB Time reception ON/OFF

 12/24 hour display

 Hour, minute and second time display

 Calendar (weekday, date, month and year)

Foldout Stand

Battery compartment cover

Function Keys

Hanging hole

 Time zone option ±12 hours

 Alarm with snooze function

 Daylight saving time (DST) function

 Weather forecasting with 15 easy-to-read weather forecast signs featured by

"Weather girl"

 Weather forecasting icon sensitivity setting

 Temperature display in Fahrenheit (°F) or degrees Celsius (°C) selectable

 Indoor and outdoor temperature display with MIN/MAX recording

 Indoor humidity reading displayed as RH% with MIN/MAX recordings

 All MIN/MAX temperature recordings show date and time received

 All MIN/MAX recordings can be reset

 Display of sunrise time, sunset time and sun duration in 99 cities

 12 Moon phases display throughout the year

 Can take up to three outdoor transmitters

 LCD contrast setting

 Low battery indicator

 LED backlight

 Table standing/ Wall mounting

The Outdoor Temperature Transmitter (TX29U-IT)

 Remote transmission of outdoor temperature to Weather

Station by 915 MHz

 Water resistant casing

 Wall mounting case (Mounting at a sheltered place. Avoid

direct rain and sunshine)

Note: Sensor must be outside to transmit outdoor temperature.

The sensor reads data from the environment it is currently in.

SETTING UP:

When one transmitter is used

1. First, insert the batteries into the Temperature transmitter (see “Install and replace

batteries in the Temperature transmitter“).

2. Immediately after and within 30 seconds, insert the batteries into Weather station (see

“

Install and replace batteries in the Weather station

”). Once the batteries are in

place, all segments of the LCD will light up briefly. Next, the time shows 12:00 and the

"Weather girl" icon will be displayed. If these are not displayed after 60 seconds,

remove the batteries and wait for at least 10 seconds before reinserting them.

3. After inserting the batteries, the Weather station will start receiving data from the

transmitter. The outdoor temperature and the signal reception icon should then be

displayed on the Weather station. If this does not happen after 3 minutes, the batteries

will need to be removed from both units and reset from step 1.

4. In order to ensure sufficient 915 MHz transmission however, this should under good

conditions be a distance no more than 330 feet (100 meters) in open air between the

final position of the Weather Station and the transmitter (see notes on “Positioning”

and “915 MHz Reception”).

5. Once the remote temperature has been received and displayed on the Weather

station, the WWVB time (radio controlled time) code reception is automatically started.

This takes typically between 3-5 minutes in good conditions. If after 10 minutes, the

WWVB time has not been received, press the SET key to manually enter a time

initially.

When more than one transmitter is used

1. User shall remove all the batteries from the Weather Station and transmitters and wait

for 60 seconds if setting has been done with one transmitter before.

2. Insert the batteries to the first transmitter.

3. Within 30 seconds of powering up the first transmitter, insert the batteries to the

Weather Station. Once the batteries are in place, all segments of the LCD will light up

briefly. Following this, the time (shown as 12:00) and the weather girl icon will be

displayed. If they are not shown in the LCD after 60 seconds, remove the batteries

and wait for at least 60 seconds before reinserting them.

4. The outdoor temperature from the first transmitter (channel 1) should then be

displayed on the Weather station. Also, the signal reception icon will be displayed. If

this does not happen after 2 minutes, the batteries will need to be removed from both

units and reset from step 1.

5. Insert the batteries to the second transmitter as soon as the outdoor temperature

readings from the first transmitter are displayed on the Weather station.

Note: User must insert the batteries into the second transmitter within 10 seconds of

reception of the first transmitter.

6. The outdoor data from the second transmitter and the "channel 2" icon should then be

displayed on the Weather station. If this does not happen after 2 minutes, the batteries

will need to be removed from all the units and reset from step 1.

7. Insert the batteries in the third transmitter as soon as the "channel 2" icon and outdoor

data are displayed on the Weather station. Within 2 minutes, the channel 3 outdoor

data from the third transmitter will be displayed and the channel icon will shift back to

"1". If this does not happen, you must restart from step 1.

Note: User must insert the batteries into the third transmitter within 10 seconds of

reception of the second transmitter.

8. In order to ensure sufficient 915 MHz transmission however, this should under good

conditions be a distance no more than 330 feet (100 meters) in open air between the

final position of the Weather Station and the transmitter (see notes on “Positioning”

and “915 MHz Reception”).

9. Once the remote temperature has been received and displayed on the Weather

station, the WWVB time (radio controlled time) code reception is automatically started.

This takes typically between 6-8 minutes in good conditions.

IMPORTANT:

Transmission problems will arise if the setting for additional sensors is not followed as

described above. Should transmission problems occur, it is necessary to remove the

batteries from all units and start the setup again from step 1.

Note: Daily WWVB reception (Atomic time) is attempted at the top of each hour between

12:00 am to 6:00 am. If the reception is successful, there is no reception attempt until the

following day. When this is successful, the received time will override the manually set time.

The date is also updated with the received time. (Please also refer to the notes on “WWVB

Radio Controlled time” and “Manual Time Setting”)

WWVB RADIO CONTROLLED TIME

The NIST (National Institute of Standards and Technology – Time and Frequency Division

WWVB radio station is located in Ft. Collins, Colorado, and transmits the exact time signal

continuously throughout the United

States at 60 kHz. The signal

can be received up to 2,000

miles away through the internal antenna in the Wireless Weather Station. However, due to

the nature of the Earth’s ionosphere, reception is very limited during daylight hours. The

Wireless Weather Station will search for a signal every night when reception is best. The

WWVB radio station receives the time data from the NIST Atomic clock in Boulder,

Colorado. A team of atomic physicists is continually measuring every second, of every day,

to an accuracy of ten billionths of a second per day. These physicists have created an

international standard, measuring a second as 9.192.631.770 vibrations of a Cesium-133

atom in a vacuum. This atomic clock regulates the WWVB transmitter.

Note

If the WWVB tower icon flashes on the top left of the LCD, but does not set the time

or the tower does not appear at all, then please note the following:

 Recommended distance from any interfering sources like computer monitors or TV

sets is a minimum of 6 feet (2 meters).

 With ferro-concrete rooms (basements, superstructures), the received signal is

naturally weakened. In extreme cases, please place the unit close to a window and/ or

point its front or back towards the Fort Collins, Colorado transmitter.

 During nighttime, the atmospheric disturbances are usually less severe and reception

is possible in most cases. A single daily reception is adequate to keep the accuracy

deviation below 1 second.

 In case the Weather Station is not able to detect the WWVB-signal (disturbances,

transmitting distance, etc.), the time can be manually set (please refer to the notes on

Manual time setting).

INSTALL OR REPLACE BATTERIES IN THE WEATHER STATION

The Weather Station uses 2 x AA, IEC LR6, 1.5V batteries. To install or replace the

batteries, please follow the steps below:

1. Remove the cover at the back of the Weather Station.

2. Insert batteries observing the correct polarity (see

marking).

3. Replace compartment cover.

INSTALL OR REPLACE BATTERIES IN THE TEMPERATURE TRANSMITTER

The Temperature Transmitter uses 2 x AA, IEC LR6 and a 1.5V battery.

To install or replace the batteries, please follow the steps below:

1. Remove the battery compartment cover at the back of the

transmitter.

2. Insert the batteries, observing the correct polarity (see marking).

3. Replace the battery compartment cover on the unit.

Note:

When changing batteries in any of the units, all units need to be reset

by following the setup procedures. This is because a random security

code is assigned by the transmitter at start-up and this code must be received and stored by

the Weather station in the first 3 minutes of power being supplied to it.

BATTERY CHANGE:

It is recommended to replace the batteries in all units regularly to ensure optimum accuracy

of these units (Battery life See Specifications below).

Please participate in the preservation of the environment. Return used

batteries to an authorized depot.

FUNCTION KEYS:

Weather Station:

SET:

This key is used to:

 Enter the set mode for the following functions: LCD contrast, Time zone, Daylight

saving time ON/OFF, Time Reception ON/OFF, 12/24 hour display, Manual time,

Year, Month, Date, Sunrise/ Sunset city location, Snooze time duration, °F/°C, and

Weather forecast sensitivity settings.

 Toggle between the display of "Weekday + date + month", "Second", "Alarm time",

and "Date + month + year".

SET key

MIN/ MAX ke

LM key

SNOOZE/ SUN key

CH/ + key

Product specificaties

Merk:	La Crosse Technology
Categorie:	Weerstation
Model:	WS-9711U-IT

Heb je hulp nodig?

Als je hulp nodig hebt met La Crosse Technology WS-9711U-IT stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Weerstation La Crosse Technology

La Crosse Technology V23 Handleiding

4 Maart 2024

La Crosse Technology 308-1414Bv3 Handleiding

15 Augustus 2023

La Crosse Technology V42-AU Handleiding

15 Augustus 2023

La Crosse Technology WS-7025U Handleiding

15 Augustus 2023

La Crosse Technology WS-7208TWC Handleiding

8 Juli 2023

La Crosse Technology 327-1418BW Handleiding

8 Juli 2023

La Crosse Technology C79790V2 Handleiding

6 Juli 2023

La Crosse Technology V41 Handleiding

6 Juli 2023

La Crosse Technology WS-8035U-IT Handleiding

18 Juni 2023

La Crosse Technology 308-1417V3 Handleiding

13 Juni 2023

Handleiding Weerstation

Nieuwste handleidingen voor Weerstation

Otio S606 Handleiding

20 April 2024

Hyundai WS 2331 Handleiding

20 April 2024

Techno Line WS 7208 Handleiding

12 April 2024

Techno Line WS 6762 Handleiding

9 April 2024

Oregon Scientific BAR 888A Handleiding

5 April 2024

TFA 30.5057.02 Handleiding

19 Maart 2024

Ventus W210 Handleiding

13 Maart 2024

ClimeMET CM7048 Handleiding

13 Maart 2024

Ventus W640 Handleiding

13 Maart 2024

ClimeMET CM2026 Handleiding

12 Maart 2024