Kicker 52HDBX1469 Handleiding
Pagina's 8 Speaker
Bekijk de handleiding van Kicker 52HDBX1469 gratis online of download de PDF. Deze handleiding is 0 keer bekeken. Vraag over dit model? Stel een vraag
52HDBX1469
Package Contents: Fig. 1
(1) Install Guide
(1) Clutch Side Speaker Baffle
(1) Clutch Side Speaker Pigtail
(1) Clutch Side Speaker/LED Harness
(1) Hardware Pack
(1) Throttle Side Speaker Baffle
(1) Throttle Side Speaker Pigtail
(1) Throttle Side Speaker/LED Harness
(1) Clutch Side Cut Template
(1) Clutch Side Grille
(1) Clutch Side LED Pigtail
(1) Clutch Side Speaker Support Bar
(1) Throttle Side Cut Template
(1) Throttle Side Grille
(1) Throttle Side LED Pigtail
(1) Throttle Side Speaker Support Bar
(1) Rear Speaker Harness
(2) 40PS692
Recommended Tools: Fig. 2
Phillips Head Screwdriver
Torx T15
Torx T20
Jigsaw
Rotary Tool (optional)
3/4” Drill Bit or Hole Saw
Painters Tape
1/8” Drill Bit
1/2” Drill Bit
Drill
Pencil or Pen
Heavy grit sandpaper
Deburring tool
Water proof silicone
Fig. 2
Fig. 1
Baffle/Grille Installation:
1. Remove the Saddle Bag by unscrewing
the fasteners inside the bag. Fig. 3
2. Once removed, apply 1 to 2 layers of
painter’s tape to the front third of the
bag lid, this will help prevent any
scratches during cutting.
3. Place the Cut Template on top of the
Bag lid and make sure it fits without
bending or bulging around the edges.
4. -drill Using a Drill with a 1/8” Drill Bit pre
3 holes in the bag lid in the designated
locations as shown in the cut template.
Fig. 4
Fig. 5
Fig. 3
Fig. 4
5. Using 3 of the supplied coarse thread
screws, secure the cut template to the bag
lid. Fig. 5
Fig. 8
Installation Continued:
6. Using a Pen or Pencil trace the cut
lines onto the taped surface of the bag
lid through the cut template. Fig. 6
7. Using a 1/2” Drill bit Drill in the areas
shown on the cut template. Note: At this
point you may continue to step 9 and
cut through the template without remov-
ing it or continue from step 8.
8. Remove the 3 screws securing the cut
template to the bag lid and complete
the lines using a straight edge. Fig. 7
9. Using a Jigsaw cut along the lines.
Note: For this step it may be easier
to remove the lid from the saddle bag.
10. Once the hole is cut out use sandpaper
to smooth any jagged edges allowing
for a better seal once baffle and grill are
mated.
11. Taking the speaker baffle insert it into
place from the back of the baffle to the
front. Fig. 8
Fig. 6
Fig. 7
Product specificaties
| Merk: | Kicker |
| Categorie: | Speaker |
| Model: | 52HDBX1469 |
Heb je hulp nodig?
Als je hulp nodig hebt met Kicker 52HDBX1469 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden