Kenwood KSC-44SL Handleiding

Bekijk gratis de handleiding van Kenwood KSC-44SL (25 pagina’s), behorend tot de categorie Oplader voor mobiel apparaat. Deze gids werd als nuttig beoordeeld door 14 mensen en kreeg gemiddeld 4.4 sterren uit 9 reviews. Heb je een vraag over Kenwood KSC-44SL of wil je andere gebruikers van dit product iets vragen? Stel een vraag

PRECAUTIONS

This AC adapter and Rapid charger is exclusively for use with KENWOOD transceivers.

The battery pack includes ammable objects such as organic solvent. Mishandling may cause the

battery to rupture producing ames or extreme heat, deteriorate, or cause other forms of damage to the

battery. Please observe the following prohibitive matters.

• Use only the specied AC adapter and battery charger by KENWOOD.

• Always remove the AC adapter from a wall outlet before attempting to inspect or clean the charger.

• Do not disassemble the charger and AC adapter.

• If the transceiver and battery pack are wet, do not place them into the charger.

• Do not expose the charger to rain or moisture.

• Do not use the damaged AC adapter and charger.

• Do not short the charging terminals with metal objects.

• Do not reverse-charge or reverse-connect the battery.

• Do not use the charger in hot or humid environments, in direct sunlight, nor near heaters.

CHARGING PROCEDURE

1 Plug the AC adapter cable into the adapter jack located on the rear of

the charger.

2 Plug the AC adapter into an AC outlet.

3 Slide a battery pack or a transceiver equipped with a battery pack

into the charging slot.

• Make sure the metal contacts of the battery pack mate securely

with the charger terminals.

• The indicator lights red and charging starts.

4 When charging is completed, the indicator lights green (or blinking

green).

• Remove the battery pack or the transceiver from the charging slot.

• When the charger will not be used for a long time, unplug the AC

adapter from the AC outlet.

CHARGER STATUS TABLE

Indicator ColorMeaning

RedA battery pack is in the charging slot and charging has started.

Blinking redThe battery pack is defective or the battery pack contacts are not properly

mated with those of the charger.

Green

(or blinking green)

Charging is completed; remove the battery pack or the transceiver from the

charging slot.

Blinking green and

yellow

The temperature of the battery pack has not satised the charging start

temperature. In this instance, remove the battery until its temperature

increases, then recharge it.

AC ADAPTER/ RAPID CHARGER

SIMPLE GUIDE

© 2015

B5A-1079-00

Product specificaties