Kenwood DDX793 Handleiding

Kenwood Niet gecategoriseerd DDX793

Lees hieronder de 📖 handleiding in het Nederlandse voor Kenwood DDX793 (80 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 61 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/80
Take the time to read through this instruction manual.
Familiarity with installation and operation procedures will help you obtain the best performance from your new DVD-receiver.
For your records
Record the serial number, found on the back of the unit, in the spaces designated on the warranty card, and in the space provided below. Refer to the model and serial
numbers whenever you call upon your Kenwood dealer for information or service on the product.
Model DDX793/DDX773BH/DDX593/DDX573BH/DDX416BT/DDX393/DDX373BT/DDX23BT Serial number
U d lyS Resi ents On
Register Online
Register your Kenwood product at www.Kenwoodusa.com
B5A-0858-00 (KN/RN)© 2015 JVC KENWOOD Corporation
DDX793
DDX773BH
DDX593
MONITOR WITH DVD RECEIVER
INSTRUCTION MANUAL
DDX573BH
DDX416BT
DDX393
DDX373BT
DDX23BT
ENGLISH 3
For DDX793/DDX773BH/DDX593/DDX573BH/
DDX393/DDX373BT/DDX23BT :
V CAUTION
Use of controls or adjustments or performance of
procedures other than those specified herein may result in
hazardous radiation exposure. In compliance with Federal
Regulations, the following are reproductions of labels on,
or inside the product relating to laser product safety.
JVC KENWOOD Corporation
2967-3, ISHIKAWA-MACHI, HACHIOJI-SHI, TOKYO, JAPAN
THIS PRODUCT COMPLIES WITH DHHS RULES 21CFR
SUBCHAPTER J IN EFFECT AT DATE OF MANUFACTURE.
Location : Top plate
FCC WARNING
This equipment may generate or use radio frequency
energy. Changes or modifications to this equipment may
cause harmful interference unless the modifications are
expressly approved in the instruction manual. The user
could lose the authority to operate this equipment if an
unauthorized change or modification is made.
FCC NOTE
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation.
This equipment may cause harmful interference to radio
communications, if it is not installed and used in accordance
with the instructions. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
For DDX793/DDX773BH/DDX593/DDX573BH/
DDX393/DDX373BT/DDX23BT :
IC (Industry Canada) Notice
This device complies with Industry Canada license-
exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference, and (2) this
device must accept any interference, including interference
that may cause undesired operation of the device.
The term “IC: ” before the certification/registration
number only signifies that the Industry Canada
technical specification were met.
CAUTION
This equipment complies with FCC/IC radiation exposure
limits set forth for an uncontrolled environment and
meets the FCC radio frequency (RF) Exposure Guidelines
in Supplement C to OET65 and RSS-102 of the IC radio
frequency (RF) Exposure rules. This equipment has very
low levels of RF energy that it deemed to comply without
maximum permissive exposure evaluation (MPE). But it is
desirable that it should be installed and operated keeping
the radiator at least 20 cm or more away from person’s
body (excluding extremities: hands, wrists, feet and ankles).
Under Industry Canada regulations, this radio transmitter
may only operate using an antenna of a type and maximum
(or lesser) gain approved for the transmitter by Industry
Canada. To reduce potential radio interference to other
users, the antenna type and its gain should be so chosen
that the equivalent isotropically radiated power (e.i.r.p.) is
not more than that necessary for successful communication.
• Contains Transmitter Module
FCC ID : ZWY8350X (for DDX793/DDX593)/
ZWY8811X (for DDX773BH/DDX573BH/DDX393/
DDX373BT/DDX23BT)
• Contains Transmitter Module
IC: 12033A-8350X (for DDX793/DDX593)/
12033A-8811X (for DDX773BH/DDX573BH/
DDX393/DDX373BT/DDX23BT)
V Cautions on the monitor:
• The monitor built into this unit has been
produced with high precision, but it may have
some ineffective dots. This is inevitable and is not
considered defective.
• Do not expose the monitor to direct sunlight.
• Do not operate the touch panel using a ball-point
pen or similar tool with a sharp tip.
Touch the buttons on the touch panel with your
finger directly (if you are wearing a glove, take it
off).
• When the temperature is very cold or very hot...
– Chemical changes occur inside, causing
malfunction.
– Pictures may not appear clearly or may move
slowly. Pictures may not be synchronized with
the sound or picture quality may decline in such
environments.
For safety...
• Do not raise the volume level too much, as this
will make driving dangerous by blocking outside
sounds, and may cause hearing loss.
• Stop the car before performing any complicated
operations.
Temperature inside the car...
If you have parked the car for a long time in hot or
cold weather, wait until the temperature in the car
becomes normal before operating the unit.
How to reset your unit
If the unit fails to operate properly, press the reset
button.
DDX793/DDX773BH
DDX593/DDX573BH/DDX416BT/DDX393/
DDX373BT/DDX23BT
BEFORE USE
BEFORE USE
BEFORE USE
BEFORE USEBEFORE USE
4
INITIAL SETTINGS
INITIAL SETTINGS
INITIAL SETTINGS
INITIAL SETTINGSINITIAL SETTINGS
Initial setup
When you power on the unit for the first time or
reset the unit, the initial setting screen appears.
• You can also change the settings on the <Setup>
screen. (Page 60)
1 Perform the initial settings.
• Press [ ] repeatedly to display more items.
*
1
*
2
<Demonstration>
(Page 61)
Activate or deactivate the
display demonstration.
<Language>
(Page 62)
Select the text language
used for on-screen
information.
• Set <GUI Language>
to display the operation
buttons and menu items
in the selected language
( ) or English [Local]
( ).[English]
<Angle>*1
(Page 8)
Adjust the panel angle.
<iPod Setup>
(Page 22)
Select the connection
method of iPod/iPhone.
<Front Camera>*2
(Page 38)
Configure the settings to
display the picture from
the connected front view
camera.
<Rear Camera>
(Page 38)
Configure the settings to
display the picture from
the connected rear view
camera.
<User
Customize>
(Page 56)
Change the display design.
2 Finish the procedure.
• Press [ ] repeatedly to change the page on
the screen.<Initial Setup>
The Home screen is displayed.
*1 Only for DDX793/DDX773BH .
*2 Only for DDX793/DDX773BH/DDX593/DDX573BH/DDX393.
Setting the security function
Registering a security code (only for
DDX416BT)
You can set a security code to protect your receiver
system against theft.
1 Display the Home screen.
On the monitor panel:
2 Display the setting screen.<System>
3 Display the screen.<Security Code Set>
• Press [ ] repeatedly to change the page on
the menu screen.<System>
• To clear the registered security code, perform
steps and , then press in 1 2 [CLR] <Security
Code>.
4 Enter a four-digit number ( ), then 1
confirm the entry ( ).2
• Press to delete the last entry.[Clear]
• Press to cancel the setting.[Cancel]
• Press [ ] to return to the current source
control screen.

Product specificaties

Merk: Kenwood
Categorie: Niet gecategoriseerd
Model: DDX793

Heb je hulp nodig?

Als je hulp nodig hebt met Kenwood DDX793 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Niet gecategoriseerd Kenwood

Kenwood

Kenwood LS-600BT Handleiding

19 Maart 2024
Kenwood

Kenwood Excelon CA-POD14AC Handleiding

15 Augustus 2023
Kenwood

Kenwood Excelon CA-GRL98RG Handleiding

15 Augustus 2023
Kenwood

Kenwood Excelon CA-PLT98 Handleiding

15 Augustus 2023
Kenwood

Kenwood Excelon CA-PLT14SG Handleiding

15 Augustus 2023
Kenwood

Kenwood Excelon CA-PLT14RG Handleiding

15 Augustus 2023
Kenwood

Kenwood Excelon P-HD4UT Handleiding

15 Augustus 2023
Kenwood

Kenwood Excelon CA-GRL14RG Handleiding

15 Augustus 2023
Kenwood

Kenwood Excelon CA-POD14LC Handleiding

15 Augustus 2023
Kenwood

Kenwood Excelon CA-PLT98RG2 Handleiding

15 Augustus 2023

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Playtive

Playtive IAN 327221 Handleiding

1 Mei 2024
Samsung

Samsung UN32J4001AF Handleiding

1 Mei 2024
Bauknecht

Bauknecht KSI 18GF2 P2 Handleiding

27 April 2024
Fakir

Fakir Artemis TS 150 Handleiding

26 April 2024
Sony

Sony UTX-M03 Handleiding

26 April 2024
Sony

Sony URX-P03 Handleiding

26 April 2024
Sony

Sony WRU-806B Handleiding

26 April 2024
Sony

Sony UTX-B03 Handleiding

26 April 2024
Sony

Sony UTX-P03 Handleiding

26 April 2024
Sony

Sony ODS-L10 Handleiding

26 April 2024