Juki HZL-353ZR Handleiding

Juki Naaimachine HZL-353ZR

Lees hieronder de 📖 handleiding in het Nederlandse voor Juki HZL-353ZR (78 pagina's) in de categorie Naaimachine. Deze handleiding was nuttig voor 18 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/78
HZL - 353Z, 355Z, 357Z Series
INSTRUCTION MANUAL
Attention
Please read this instruction manual before using
the machine as it contains important operational
and safety information.
Keep this manual accessible so that you may refer
to it at anytime while operating the machine.
When using an electrical appliance, basic safety precautions should always be
followed, including the following: Read all instructions before using this sewing
machine.
1. The appliance should never be left unattended when plugged in.
2. Always unplug this appliance from the electric outlet immediately after
using and before cleaning.
1. Do not use the appliance as a toy. Caution is advised when the appliance
is used by children, or near children. This sewing machine can be used by
children aged from 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning use of the sewing
machine in a safe way and understand the hazards involved. Children shall
not play with the sewing machine. Cleaning and user maintenance shall
not be made by children without supervision.
2. Use this appliance only for its intended use as described in this manual.
Use only attachments recommended by the manufacturer as contained in
this manual.
3. Never operate this appliance if it has a damaged cord or plug, if it is not
working properly, if it has been dropped or damaged, or dropped into water.
Return the appliance to the nearest authorized dealer or service center for
examination, repair, electrical or mechanical adjustment.
4. Never operate the appliance with any air openings blocked. Keep
ventilation openings of the sewing machine and foot control free from the
accumulation of lint, dust, and loose cloth.
5. Keep fingers away from all moving parts. Special care is required around
the sewing machine needle.
6. Always use the proper stitch plate. The wrong plate can cause the needle
to break.
7. Do not use bent needles.
8. Do not pull or push fabric while stitching. It may deflect the needle causing
it to break.
9. Switch the sewing machine off when making any adjustments in the
needle area, such as threading needle, changing needle, threading bobbin,
or changing presser foot.
“DANGER
“WARNING
____ To reduce the risk of electric shock:”
____ To reduce the risk of burns, fire, electric shock, or
injury to persons:”
("O")
IMPORTANT SAFETY INSTRUCTIONS
10. Always unplug the machine from the electrical outlet when removing
covers, when lubricating or when making any other user servicing
adjustments mentioned in the instruction manual.
11. Never drop or insert any object into any opening.
12. Do not use outdoors.
13. Do not operate where aerosol (spray) products are being used or where
oxygen is being administered.
14. To disconnect, turn all controls to the off ("O") position, then remove plug
from outlet.
15. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
16. Basically, the machine should be disconnected from the electricity supply
when not in use.
17. If the power cord of this appliance is damaged, it must be replaced with a
special cord by your nearest authorized dealer or service center.
18. (Except USA/Canada) This machine is provided with double insulation.
Use only identical replacement parts. See instructions for servicing Double-
Insulated machine.
19. When you sew slowly for long time, machine will have heat or unusual
smell occurs. In this case, disconnect the plug from the wall outlet and use
it after a while. Contact your nearest dealer if it still occurs.
20. Don't use the machine if it's wet or in humid environment.
21.
22. Never place anything on the foot control.
23. The machine must only be used with foot controller type
24.
25.
The sewing machine is equipped with a LED lamp. If the LED lamp is
broken, it must be replaced by the manufacturer or its service agent in
order to avoid a hazard.
The sound pressure level under normal operating conditions is 75dB(A).
Keep the instruction at a suitable place that close to the machine, and hand
it over if you give the machine to a third party.
“SERVICING DOUBLE-INSULATED PRODUCTS
(Except USA / Canada)”
In a double-insulated product, two systems of insulation are provided instead of grounding. No
grounding means is provided on a double-insulated product nor should a means for grounding be
added to the product. Servicing a double-insulated product requires extreme care and knowledge
of the system and should only be done by qualified service personnel. Replacement parts for a
double-insulated product must be identical to those parts in the product. A double-insulated product
is marked with the words DOUBLE INSULATION or DOUBLE INSULATED.
The symbol may also be marked on the product.
KD-1902/FC-1902
(110-120V), KD-2902/FC-2902D (220-240V).


Product specificaties

Merk: Juki
Categorie: Naaimachine
Model: HZL-353ZR

Heb je hulp nodig?

Als je hulp nodig hebt met Juki HZL-353ZR stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Naaimachine Juki

Handleiding Naaimachine

Nieuwste handleidingen voor Naaimachine