JL Audio Stealthbox SB-F-F1502/10W3v3/DG Handleiding

JL Audio Niet gecategoriseerd Stealthbox SB-F-F1502/10W3v3/DG

Lees hieronder de đź“– handleiding in het Nederlandse voor JL Audio Stealthbox SB-F-F1502/10W3v3/DG (2 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 23 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
I N S T A L L A T I O N G U I D E
for the
SB-F-F1502/10W3v3
SKU# 94370-94374
2004 - 2008 Ford F-150 Super Crew & Super Cab &
2006 - 2008 Lincoln Mark LT
Thank you for choosing a JL Audio Stealthbox® for your automotive sound system. With proper installation, your new vehicle-
specific enclosed subwoofer system will deliver years of listening pleasure.
We strongly recommend that you have your new Stealthbox® installed by your authorized JL Audio dealer. The installation
professionals employed by your dealer have the necessary tools and experience to disassemble and reassemble your vehicle
properly. If you prefer to perform your own installation, please read this installation guide completely
before beginning the process.
If you choose to perform the installation yourself, it is absolutely vital that
the Stealthbox ® be properly mounted to the vehicle according to these
instructions. Failure to mount the enclosure properly presents two problems:
1) The sub-bass performance will suffer due to the movement of the enclosure
caused by the force exerted by the woofer(s).
2) A loose enclosure presents a serious safety hazard in the event of a collision
or sudden deceleration.
S T E P 1
Remove all contents from the rear seating area.
Lift up both seats.
Remove the jack, jack tools and the jack’s mounting bracket.
The jack and the jack tools must be relocated.
Continued on Next Page
S T E P 2
Thread a supplied socket cup screw into the driver’s side rear
of the Stealthbox®, leaving 1.0” of the threads exposed.
S T E P 3
Thread another supplied socket cup screw into the
passenger’s side rear of the Stealthbox®, leaving 1.0” of the
threads exposed.
SB-F-F1502/10W3v3_INSTR_SKU#011251
INSTALLATION
D I F F I C U L T Y :
15
OUT
OF
ESTIMATED TIME:
1 HOUR
SB-F-F1502/10W3v3_INSTR_SKU#011251
C O N G R A T U L A T I O N S
You have completed the installation for this model!
Please refer to the Power Recommendation section for an
amplifier recommendation and basic set-up help.
S T E P 6
Place a supplied flat washer, lock washer and then hex nut
onto each socket cup set screw and secure.
S T E P 5
Guide the two socket cup set screws through the existing
holes that are located on the rear seat brackets.
S T E P 4
Run speaker wire from the amplifier’s location to the
Stealthbox® location and check for proper operation of
the woofer.
Page 3 • JL Audio, Inc 2016
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered
trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.
JLA-SKU# 011251 09.20.2016 • Printed in USA • ©2016 JL Audio, Inc.
For more detailed information please visit us online at www.jlaudio.com.
(954) 443-1100
w w w . j l a u d i o . c o m
1 0 3 6 9 N O R T H C O M M E R C E P A R K W A Y • M I R A M A R , F L O R I D A • 3 3 0 2 5 • U S A
I N C L U D E D H A R D W A R E
(2) 3/8” -16 x 2-1/4” Socket Cup Set Screw
(2) 3/8” Flat Washer
(2) 3/8” Split Lock Washer
(2) 3/8” -16 Hex Nut
S P E C I F I C A T I O N S
Enclosure Type: Bass Reflex (ported)
Driver Type: 10W3v3-2
Nominal Impedance: 2 ohms
Continuous Power Handling: 500 Watts
P O W E R R E C O M M E N D A T I O N
JL Audio recommends using a high quality amplifier such as the JL Audio XD300/1v2. The diagram below shows
the recommended crossover settings for the XD300/1v2 when being used to power your Stealthbox ®.
The JL Audio XD300/1v2 is a very versatile audio component. Please consult the owner’s manual for even more
detailed information about installing and tuning this amplifier.
M I D / H I G H F R E Q U E N C Y D R I V E R F I T M E N T
A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.
Front Speaker Size / Location: 5” x 7” / Front Doors
Fits JL Audio Models: TR570-CXi, C2-570x, C3-570, C5-570, C5-570x & ZR570-CSi
Rear Speaker Size / Location: 5” x 7” / Rear Door
Fits JL Audio Models: TR570-CXi, C2-570x, C3-570, C5-570, C5-570x & ZR570-CSi


Product specificaties

Merk: JL Audio
Categorie: Niet gecategoriseerd
Model: Stealthbox SB-F-F1502/10W3v3/DG

Heb je hulp nodig?

Als je hulp nodig hebt met JL Audio Stealthbox SB-F-F1502/10W3v3/DG stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd JL Audio

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd