JL Audio M10IB5 Handleiding

JL Audio Subwoofer M10IB5

Lees hieronder de 📖 handleiding in het Nederlandse voor JL Audio M10IB5 (4 pagina's) in de categorie Subwoofer. Deze handleiding was nuttig voor 36 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4

Thank you for choosing a JL Audio Marine Subwoofer.

With proper installation, your new speaker

will deliver years of listening pleasure.

We strongly recommend that you have your subwoofer installed

by your authorized JL Audio dealer. The installation

professionals employed by your dealer have the necessary tools and experience to

properly install this product. If you prefer to perform

your own installation, please read this instruction manual

completely before beginning the process.

owner’s manual

Marine Subwoofer

M10IB5 / M10W5

2 JL AUDIO M10IB5/M10W5

INSTALLATION PROCEDURE

The diagram above shows the typical

installation procedure into a fiberglass panel using

the supplied hardware (Classic Grille Model shown.

Installation is the same for Sport Grille Models).

Always follow proper safety procedures when

working on a vessel. Use eye-protection at all times

and a dust mask and gloves when cutting.

1) Choose a flat mounting surface that has

sufficient

depth and air space behind it to accept

the subwoofer.

2) Cut a 8.875-inch (225 mm) diameter hole.

3) Run the speaker cable to the mounting location.

4) Place the woofer in the hole and mark the screw

hole locations using a sharp, pointed tool.

5) Remove the woofer and drill a pilot hole

(see chart on next page) in each of the screw

locations. It is also advisable to use a hand-driven

countersink tool on each hole to further inhibit

gel-coat cracking of fiberglass panels.

6) Connect the speaker wires and place the woofer,

with its grille in place, into the opening (for Sport

Grille models, pay attention to where the logo

badge will added.

7) While holding the speaker firmly in its mounting

location, evenly snug the mounting screws in a

criss-cross pattern, then hand tighten in a criss-

cross pattern.

Non-standard installations may require different

hardware. Always use marine-grade, stainless-steel

fasteners to ensure a secure, reliable installation.

We recommend the use of this speaker in a bi-amplified system using high-quality satellite speakers and amplifiers.

We do not recommend the use of this subwoofer with a passive crossover (coil), as this type of device will adversely

affect performance.

A l l s p e c i f i c a t i o n s a r e s u b j e c t t o c h a n g e w i t h o u t n o t i c e .

PHYSICAL SPECIFICATIONS

INCLUDED PARTS

• One Polymer Subwoofer Grille

• Six #10 x 1 5/8-inch (41 mm) pan-head

stainless-steel screws

• Six #10 stainless-steel washers

• Logo Badges (Sport-Grille Models Only)

One Pair Black (White & Titanium/Black Models)

One Pair Red (White & Titanium/Black Models)

One Pair White (White Models Only)

One Pair Titanium (Titanium/Black Models Only)

Subwoofer Physical Specifications

Nominal Diameter: 10 in. / 250 mm

Overall Diameter (A): 10.75 in. / 273 mm

Mounting Hole Diameter (B): 8.875 in. / 225 mm

Bolt Hole Circle (C): 9.706 in. / 247 mm

Motor Overmold Outer Diameter (D): 6.11 in. / 155 mm

Mounting Depth (E): 5.93 in. / 151 mm

Net Weight: 11.4 lbs. / 5.17 Kg

Driver Displacement: 0.064 ft / 1.81 litres

Subwoofer Parameters M10IB5 M10W5

Free Air Resonance (Fs): 42.20 Hz 31.55 Hz

Electrical “Q” (Qes): 0.819 0.484

Mechanical “Q” (Qms): 10.355 8.946

Total Speaker “Q” (Qts): 0.759 0.460

Equivalent Compliance (Vas): 1.16 ft3 / 32.85 litres 1.58 ft3 / 44.75 litres

One-way, Linear Excursion (Xmax)*: 0.52 in. / 13.2 mm 0.52 in. / 13.2 mm

Efficiency (1W/1m)**: 86.8 dB SPL 86.7 dB SPL

Effective Piston Area (Sd): 50.11 in² / 0.0323 m² 50.11 in² / 0.0323 m²

DC Resistance (Re): 4.167 ohm 3.602 ohm

Nominal Impedance: 4 ohm 4 ohm

Infinite Baffle Use: Yes No

Enclosure Use: Yes (Sealed Only) Yes (Sealed and Ported)

Power Handling (continuous): 250W 250W

* Xmax specifications are derived via one-way voice coil overhang method with no correction factors applied.

** Efficiency (1W/1m) is not an accurate indicator of a subwoofer’s output capability and should not be used

as a comparison to other subwoofers to determine which one is “louder” !

The enclosure recommendations listed are external dimensions which assume the use of 3/4” (19mm) thick material. If you are using 5/8” (16mm) thick material, subtract 1/4”

(6.5mm) from each dimension. Do not use any material with a thickness of less than 5/8” (16mm) as this may compromise the rigidity of the enclosure.

All enclosure volumes listed are net internal volumes! Box volume displacement, port displacement and brace displacement must be added to obtain the final gross internal

volume. All enclosure dimensions listed have already taken this into account.

JL AUDIO M10IB5/M10W5 3

INTERCHANGEABLE LOGO BADGE

(Sport-Grille Models Only)

Interchangeable Logo Badges for Sport Grille

model subwoofers are included to further customize

your installation. The design of the Sport Grille allows

for the JL Audio logo to be added in your choice of

included colors and oriented in the manner that best

suits your installation.

NOTE: A left and a right badge of each color is

included. These two different orientations ensure

the “JL Audio” Logo will read correctly wherever

positioned (most commonly the 3:00 or 9:00

position).

Remove the adhesive backing from the badge

and affix the badge to the grille using the small

positioning hole as a guide. See diagram at right.

! ! CAUTION ! !

While this speaker is designed to be water and

spray resistant, it is not designed to be submerged

or to withstand high-pressure water spray.

Please exercise care when washing your boat to

avoid damaging your speaker. Do not install on

submersibles, personal watercraft or any other

vessel likely to be under water at any time.

Prolonged exposure to sound pressure levels in

excess of 100dB can cause permanent hearing loss.

This high-performance speaker can exceed this

level. Please exercise restraint in its operation in

order to preserve your ability to enjoy its fidelity.

When installing a subwoofer in your vessel, it is

extremely important to secure it firmly. This applies

not only to the woofer itself, but also the structure

it is mounted to. If not firmly attached, the speaker

can become a dangerous projectile in a collision.

Please review the mounting information carefully

and use the supplied marine-grade hardware to

mount this product.

A l l s p e c i f i c a t i o n s a r e s u b j e c t t o c h a n g e w i t h o u t n o t i c e .

Fiberglass Thickness Recommended Pilot Hole Drill Size

0.125 in. (3.18 mm) or less 1/8 in. (3.18 mm) pilot hole

foam core / fiberglass sandwich 1/8 in. (3.18 mm) pilot hole

larger than 0.125 in. (3.18 mm) 9/64 in. (3.57 mm) pilot hole

#10 SCREW: PILOT HOLE RECOMMENDATIONS

3:00 Position

9:00 Position

Subwoofer Recommended Sealed Design

Volume

(net int.)

External Dimensions

( idth x eight x epth)W H D

(Hz)

(Hz) Qtc

M10W5 0.875 ft³

24.8 litres

14 in. x 14 in. x 12 in.

356 mm x 356 mm x 305 mm 49 52.85 .770

M10IB5 2.50 ft³

70.8 litres

18 in. x 18 in. x 17.75 in.

457 mm x 457 mm x 451 mm 42 .91851.06

Subwoofer Recommended Ported Design

Volume

(net int.)

Enclosure External Dimensions

( idth x eight x epth)W H D

Round Port Specs

( nner I Diameter x Length) Port Information Tune to:

(Hz)

M10W5 1.250 ft³

35.4 litres

16.5 in. x 13.5 in. x 14 in.

419 mm x 343 mm x 356 mm

3 in. x 13 in.

76 mm x 330 mm

Round port requires a 90˚ elbow

to fit in the specified enclosure 32 34

Sealed Design Ported Design

ENCLOSURE SPECIFICATIONS

NOTE: The M10IB5 Marine Subwoofer is not

recommended for use in Ported Enclosures.

Product specificaties

Merk:	JL Audio
Categorie:	Subwoofer
Model:	M10IB5

Heb je hulp nodig?

Als je hulp nodig hebt met JL Audio M10IB5 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Subwoofer JL Audio

JL Audio Fathom ICS-SYS-208 Handleiding

8 Januari 2024

JL Audio Fathom ICS-SYS-108 Handleiding

8 Januari 2024

JL Audio Fathom IWS-SYS-208 Handleiding

8 Januari 2024

JL Audio Stealthbox SB-B-X5E70/10W3v3 Handleiding

31 Augustus 2023

JL Audio Stealthbox SB-SC-TCG2/10W3v3 Handleiding

31 Augustus 2023

JL Audio Stealthbox SB-F-EXPL3/10W3v3 Handleiding

31 Augustus 2023

JL Audio M6-8IB-L Handleiding

5 Juli 2023

JL Audio M6-10IB-L Handleiding

3 Juli 2023

JL Audio Fathom SA-600W Handleiding

6 Juni 2023

JL Audio Fathom f110 Handleiding

28 Mei 2023

Handleiding Subwoofer

Nieuwste handleidingen voor Subwoofer

RCF S 19 Handleiding

10 April 2024

RCF S 29 Handleiding

10 April 2024

KEF KC92 Handleiding

6 April 2024

Klipsch Reference Premiere RP-1200SW Handleiding

3 April 2024

Klipsch Reference Premiere RP-1000SW Handleiding

3 April 2024

Velodyne Deep Waves 10 Handleiding

27 Maart 2024

Klipsch PRO-1000SW Handleiding

27 Maart 2024

Totem KIN Sub Handleiding

27 Maart 2024

Velodyne Deep Waves 12 Handleiding

27 Maart 2024

Kanto SUB8V Handleiding

27 Maart 2024