JL Audio C1-400X Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor JL Audio C1-400X (8 pagina's) in de categorie Autospeaker. Deze handleiding was nuttig voor 21 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/8
OWNER’S MANUAL
4-inch (100 mm) Coaxial Loudspeakers
Thank you for choosing JL Audio loudspeakers for
your automotive sound system.
We strongly recommend that you have your new loudspeakers installed by
an authorized JL Audio dealer. Your authorized dealer has the training,
expertise and installation equipment to ensure
optimum performance of these loudspeakers in your vehicle.
If you decide to install the loudspeakers yourself, please read this manual
thoroughly to familiarize yourself with their installation
requirements and setup procedures.
Should you have any questions regarding the instructions in this manual,
please contact your authorized JL Audio dealer for assistance, or call the
JL Audio Technical Support Department at (954) 443-1100
during business hours (USA - Eastern Time Zone).
2 | JL Audio - C1-400x Owner’s Manual
Due to ongoing product development, all specifications are subject to change without notice.
Coaxial Physical Dimensions
Frame Outer Diameter (A) 4.03 in. / 102 mm
Mounting Hole Diameter (B) 3.70 in. / 94 mm
Tweeter Protrusion (C) 0.61 in. / 16 mm
Motor Outer Diameter (D) 2.33 in. / 59 mm
Mounting Depth (E) 1.81 in. / 46 mm
3
C1-400x SPECIFICATIONS:
Continuous Power Handling: 35 Watts
Recommended Amp Power: 10-50 Watts per channel (RMS)
Efficiency: 84.5 dB @ 1W / 1m | 90.5 dB @ 1W / 0.5m
Sensitivity: 87.5 dB @ 2.83V / 1m
Nominal Impedance: 4 ohm
Frequency Response: 64 Hz - 24 kHz ± 3 dB
Woofer:
Injection-molded, mineral-filled, polypropylene cone
Rubber, positive roll surround
1.0 in. (25 mm) diameter voice coil
Flat, linear roll spider, with integrated lead wires
Ferrite magnet
Tweeter:
Edge-driven, silk-suspended aluminum dome
0.75 in. (19 mm) diameter diaphragm / voice coil
Ferrofluid cooling / damping
Neodymium magnet
Crossover:
Natural roll-off, low-pass
2nd order, high-pass filter with inductor and
electrolytic capacitor
Included Components and Parts:
• Two (2) C1-400x 4.0-inch (100mm) coaxial loudspeakers
• Eight (8) #8 x 0.75-inch (19mm) sheet metal screws
• Eight (8) mounting clips
• Two (2) 4.7 mm female crimpable connectors
• Two (2) 2.8 mm female crimpable connectors
GETTING STARTED
• Turn off the audio system. It is also
advisable to disconnect the negative (–)
terminal of your vehicle’s battery whenever
performing installation work.
• Before cutting, drilling or inserting any screw,
check clearances on both sides of the planned
mounting surface. Also check for any potential
obstacles, such as window tracks and motors,
wiring harnesses, etc. Check both sides of the
vehicle, many vehicles are not symmetrical!
• Always wear protective eyewear.
SPEAKER PLACEMENT CONSIDERATIONS
Grilles are included with C1 speakers, as they not
are designed for installation into OEM (factory)
speaker locations, located behind factory grilles.
Should you need grilles, you will need to purchase
aftermarket grilles separately.
WA R N I N G
!!
Prolonged exposure to sound pressure levels in
excess of 100dB can cause permanent hearing
loss. These high-performance loudspeakers can
exceed this level. Please exercise restraint in their
operation in order to preserve your ability to enjoy
their fidelity.


Product specificaties

Merk: JL Audio
Categorie: Autospeaker
Model: C1-400X

Heb je hulp nodig?

Als je hulp nodig hebt met JL Audio C1-400X stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Autospeaker JL Audio

Handleiding Autospeaker

Nieuwste handleidingen voor Autospeaker