JBL MS-BassPro SQ Handleiding

JBL Subwoofer MS-BassPro SQ

Lees hieronder de 📖 handleiding in het Nederlandse voor JBL MS-BassPro SQ (10 pagina's) in de categorie Subwoofer. Deze handleiding was nuttig voor 36 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/10
OWNER’S MANUAL
MS-BassPro SQ
powered automotive subwoofer
2
IntrOductIOn
Thank you for choosing the JBL® MS-BassPro SQ powered automotive
subwoofer. The MS-BassPro SQ has been designed to deliver outstanding
bass performance from a compact, easily installed powered subwoofer
enclosure.
To get the best performance from your MS-BassPro SQ, we strongly
recommend that installation be entrusted to a qualified professional.
Although these instructions explain how to install the MS-BassPro SQ in
a general sense, they do not show specific installation methods that may
be required for your particular vehicle. If you do not have the necessary
tools or experience, do not attempt the installation yourself. Instead,
please ask your authorized JBL car audio dealer about professional
installation.
In order that we may better serve you should you require warranty
service, please retain your original sales receipt and register your
MS-BassPro SQ online at www.jbl.com.
Included IteMs
InstallIng the suBwOOfer
InstallatIon WarnIngs and tIps
• Always wear protective eyewear when using tools.
• Disconnect the vehicle’s negative (–) battery terminal before starting
the installation.
• Check clearances on both sides of a planned mounting surface. Be
sure that screws or wires will not puncture brake lines, fuel lines or
wiring harnesses, and that wire routing will not interfere with the safe
operation of the vehicle.
• When making electrical connections, make sure they are secure and
properly insulated.
• I f you must replace the MS-BassPro SQ’s fuse, be sure to use the same
type of fuse and current rating as that of the original.
MountIng the subWoofer
Choose a location for the subwoofer that doesn’t interfere with cargo,
a fold-down rear seat or the trunk lid. The best location is usually a
corner of the trunk or cargo area, as shown in the illustrations. These
locations, in addition to being out of the way, will provide the best sonic
reproduction in the 60Hz to 100Hz range because the woofer output
will be “corner loaded” against the vehicle’s walls. In any case, the
MS-Basspro SQ must not interfere with the safe operation of the vehicle.
3
www.jbl.com
English
cOnnectIOns
IMPORTANT: Disconnect the vehicle’s negative (–) battery terminal
before beginning installation.
AUDIO SENSE SWITCH:
No remote turn on connection is necessary because the MS-BassPro SQ
includes signal sensing turn on, which will turn the subwoofer on when
it receives an audio signal at its input connectors. The subwoofer will
automatically turn off approximately five minutes after the input signal
ceases.
If your audio system’s source unit includes a remote turn on wire and you
would prefer to use it, defeat the signal sensing turn on circuit by moving
the Audio Sense switch to the “off” position.
CONNECTING THE SUBWOOFER TO YOUR VEHICLE’S AUDIO
SYSTEM
The JBL MS-BassPro SQ is equipped with two line-level (RCA) input
connectors that can handle line-level and speaker-level input signals. Use
RCA audio cables to connect the subwoofer to source units with preamp-
level outputs; use the supplied bare wire-to-RCA adapters to connect the
subwoofer to source units that don’t have RCA output connectors. Consult
the following system application diagrams to help you plan the installation
of your MS-BassPro SQ. For additional installation suggestions, contact
your local authorized JBL car audio dealer.
If your car audio system’s head unit has front or rear stereo line-
level outputs:
Use a stereo RCA audio cable (not supplied) to connect the MS-BassPro
SQ to the head unit’s front or rear left and right line-level outputs.
L. Front
Speaker
L. Rear
Speaker Audio System
Head Unit Left/Right
Line-Level
Outputs
Stereo RCA Audio Cable
(not supplied)
R. Front
Speaker
R. Rear
Speaker

Product specificaties

Merk: JBL
Categorie: Subwoofer
Model: MS-BassPro SQ

Heb je hulp nodig?

Als je hulp nodig hebt met JBL MS-BassPro SQ stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Subwoofer JBL

JBL

JBL SUB80P Handleiding

5 Maart 2024
JBL

JBL VT4880ADP Handleiding

14 November 2023
JBL

JBL VTX B15 Handleiding

13 November 2023
JBL

JBL VLA-C125S Handleiding

13 November 2023
JBL

JBL VT4882DP-DA Handleiding

13 November 2023
JBL

JBL PRX618S-XLF Handleiding

13 November 2023
JBL

JBL LSR6312SP Handleiding

13 November 2023
JBL

JBL PD525S Handleiding

13 November 2023
JBL

JBL PRX718XLF Handleiding

13 November 2023
JBL

JBL SUB 100P Handleiding

19 Juni 2023

Handleiding Subwoofer

Nieuwste handleidingen voor Subwoofer

RCF

RCF S 19 Handleiding

10 April 2024
RCF

RCF S 29 Handleiding

10 April 2024
KEF

KEF KC92 Handleiding

6 April 2024
Klipsch

Klipsch Reference Premiere RP-1200SW Handleiding

3 April 2024
Klipsch

Klipsch Reference Premiere RP-1000SW Handleiding

3 April 2024
Velodyne

Velodyne Deep Waves 10 Handleiding

27 Maart 2024
Klipsch

Klipsch PRO-1000SW Handleiding

27 Maart 2024
Totem

Totem KIN Sub Handleiding

27 Maart 2024
Velodyne

Velodyne Deep Waves 12 Handleiding

27 Maart 2024
Kanto

Kanto SUB8V Handleiding

27 Maart 2024