JBL GSF3 Handleiding

JBL Speaker GSF3

Lees hieronder de 📖 handleiding in het Nederlandse voor JBL GSF3 (6 pagina's) in de categorie Speaker. Deze handleiding was nuttig voor 64 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/6
Installation Guide
GSF3 & GSF6 Landscape Speakers
CAUTION: Installation must be done by qualified persons using safe
installation standards.
The installer is responsible for proper selection and use of mounting hardware
and processes to install the speakers in a safe manner.
Wire Connection
• CABLE-- - - - The GSF speakers have a captive 1 meter long cable for bare wire connection via an external installer provided
weather proof- junction box.
o Polarity -- – . The red wire is + (positive) and the black wire is (negative)
o Wire Gauge – 1 The wire gauge is 18 AWG ( mm2).
o Wire Jacket – - The wire jacket is 5 mm (+0/ 05.mm) in diameter.
o Connecting -- Use proper wire nuts or other safe connectorsprofessional that are appropriate for the installation
conditions and that are sized properly for wire gauge(s) and number of wires to be connected together in the
connector.
o Routing – - - When using the ground stake or L bracket base, the cable can be routed through the base.
Black - = (negative)
Red = + (positive)
CABLE
Bare-Wire End of Cable
Setting TAP SELECTOR SWITCH
(TAP SELECTOR SWITCH is located on the bottom of the speaker enclosure)
• Rotate bottom- : panel TAP SELECTOR SWITCH to select between
o GSF3:
8 - ) Ω(ie, low impedance / direct
15W or 7.5W for either 70V or 100V distributed speaker system
3.75W for 70V distributed speaker system only
o GSF6:
8 - Ω(ie, low impedance / direct)
30W or 15W for either 70V or 100V distributed speaker system
7.5W for 70V distributed speaker system only
Installing GROUND OUDSPEAKER-STAKE BASE or L BRACKET BASE - to L
• The speaker comes with both a GROUND-STAKE BASE and an L-BRACKET BASE. Use whichever one applies to the installation
requirements of the project.
• At the bottom of the LOUDSPEAKER there is a SOCKET. Three come with the speaker (packaged in a separate - rhead set sc ews
pouch) for attaching the chosen base into the SOCKET.
o Screw Dimensions -- – , GSF3: M4 x 0.7 5mm with 3 mm hex drive
GSF6: M4 x 0.7 – 9 , mm with 3 mm hex drive
(GSF SPEAKER shown with L-BRACKET BASE)
(continued ↓)
ROTARY TAP SELECTOR SWITCH
• Use the included 3 mm hex wrench to tighten the 3 set screws to hold the chosen base securely.
• For GROUND-STAKE BASE, press base into the ground.
(GSF SPEAKER shown with included GROUND STAKE base)-
• For L BRACKET BASE, securely attached base to either horizontal surface (such as decking or railing) or vertical surface (such as t- he
side of a building or post). Use the proper attachment hardware for the material and characteristics of what it’s being attached to.
Aiming LOUDSPEAKER
• Loosen HINGE BOLT by using included 4 mm hex key. Aim loudspeaker, and then retighten.
• Aiming Speaker at Downward Angle Provides Best Drainage – The greatest water drainage and reliability can be achieved by
aiming the speaker at a slight downward aiming angle.
• Maximum Upward Aiming Angle of 30° -- For when aimed slightly upward, there is a drain hole at the bottom of the speaker
that helps to drain water from the front of the speaker’s driver °at aiming angles up to a maximum 30 . At upward aiming
angles potentially °greater than 30 , water can pool on the driver, causing damage.
Ingress Protection Rating
• IP66 -- The GSF speakers are rated IP66 ( per IEC529 highly protected against ingress from dust and water). However, the
speaker is not rated for submersion in water, so steps must be taken to ensure that no immersion situation occurs.
HINGE BOLT
(use included 4 mm hex key)
(Shown with included L-BRACKET base)
CAUTION WHEN RE-AIMING SPEAKER:
When ground stake is utilized, re aiming speaker - -
horizontally requires either: a) completely pull ing
stake from ground and re back into -pressing
ground at new aiming angle or b) loosening 3 set ,
screws, re- -aiming speaker, and re tightening set
screws. Trying to rotate speaker with stake in
ground could and set screws tightened result in
damage or breakage.
CAUTION WHEN ROTATING ON L- : BRACKET
When bracket rotating speakerL- is utilized, on L-
bracket otating requires loosening 3 set screws, r
speaker, and re tightening set screws. Trying to -
rotate speaker set screws tightened could with
result in damage or breakage.

Product specificaties

Merk: JBL
Categorie: Speaker
Model: GSF3

Heb je hulp nodig?

Als je hulp nodig hebt met JBL GSF3 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Speaker JBL

JBL

JBL SCL-5 Handleiding

9 April 2024
JBL

JBL SCL-6 Handleiding

9 April 2024
JBL

JBL Control 321C Handleiding

22 Maart 2024
JBL

JBL Control 322C Handleiding

22 Maart 2024
JBL

JBL Control 321CT Handleiding

22 Maart 2024
JBL

JBL PartyBox On-the-Go Essential Handleiding

19 Maart 2024
JBL

JBL PartyBox Club 120 Handleiding

19 Maart 2024
JBL

JBL L82 Classic Handleiding

19 Maart 2024
JBL

JBL Stage XD-5 Handleiding

19 Maart 2024
JBL

JBL L42ms Handleiding

6 Maart 2024

Handleiding Speaker

Nieuwste handleidingen voor Speaker

OTTO

OTTO Bluetooth Revo NC2 Handleiding

20 April 2024
REL Acoustics

REL Acoustics Strata Handleiding

20 April 2024
REL Acoustics

REL Acoustics Strata III Handleiding

20 April 2024
Soen

Soen Transit Handleiding

18 April 2024
Miller & Kreisel

Miller & Kreisel MP300RC Handleiding

18 April 2024
Soen

Soen Transit XS Handleiding

18 April 2024
Miller & Kreisel

Miller & Kreisel MP7 Handleiding

18 April 2024
Qian

Qian QRBT1801 Handleiding

17 April 2024
Focal

Focal Twin6 Handleiding

17 April 2024
Kenwood

Kenwood KFC-WPS1000F Handleiding

16 April 2024