Infinity MODULUS MS 1 II Handleiding

Bekijk gratis de handleiding van Infinity MODULUS MS 1 II (1 pagina’s), behorend tot de categorie Speaker. Deze gids werd als nuttig beoordeeld door 3 mensen en kreeg gemiddeld 4.6 sterren uit 7 reviews. Heb je een vraag over Infinity MODULUS MS 1 II of wil je andere gebruikers van dit product iets vragen? Stel een vraag

1

2

3

6

7

1

6

1

7

18

20

2

1

22

24

26

8101112

13

14

9

25

27

28

23

19

45

M

S-1

II

CabinetNot for Sale–

EXPLODED

VIEW

WIRING DIAGRAM

MS-1II

Infinity Loudspeaker Troubleshooting/Repair Tips

Most customers prefer to do simple loudspeaker repairs themselves. By following the steps below, a majority of loudspeakers can be returned to

t

heir original factory performance with minimum effort. Choose the example that best describes the problem you are experiencing.

P

r

o

blem 1: No sound or distor

t

ed sound fr

o

mone loudspeaker in a pair (or set)

Connect the dead/distorting loudspeaker to a different amplifier channel (one that had a functioning loudspeaker connected to it). If it functions

normally, the problem is not loudspeaker-related. If the loudspeaker still makes no sound or sounds distorted, a wire may have become loose

or disconnected, the network (also known as a crossover) may be defective, the drivers (woofer, tweeter, etc.) may be defective or, in very rare

cases, all may be defective.

Refer to the wiring diagram and exploded view below. The network is a small circuit board found on the inside of the terminal cup, or mounted to

an inside wall of the enclosure. It sends low-frequency sounds to the woofer, high-frequency sounds to the tweeter and, if applicable, mid-frequency

sounds to the midrange driver. Make sure all wires are secure and connected. Look for components on the network that look burnt, “bulged,”

or abnormal. If everything looks normal, connect the network to the drivers from another matching loudspeaker. MAKE SURE you attach the

correct wires to each driver – mid- and low-frequency sounds can damage the tweeter! If there is still no sound or distorted sound, the network

is defective. If there is clean undistorted sound, the drivers are defective.

Problem 2: No sound or distorted sound from one or mor(but not all) drivers in an enclosuree

Remove the problem driver(s) from the enclosure and make sure all wires are secure and connected. If they are, proceed with the following test:

Woofer or midrange driver –Connect the driver’s + and – input terminals directly to the loudspeaker wires from your receiver/amplifier and play

some music at a r

easonable volume. If the driver now sounds normal (produces a clean, undistorted sound), the network is most likely defective.

Tweeter –Replace the tweeter with a functioning tweeter from another loudspeaker. If the tweeter now functions normally (produces clean,

undistorted sound), the original tweeter is defective. If the replacement tweeter also sounds distorted or produces no sound, the network is

most likely defective.

Problem 3: Loudspeakers distort, rattle or pop at higher volumes

This is usually NOT a loudspeaker problem. Common causes are too much power (playing the loudspeakers too loud and causing them to distort),

an amplifier with not enough power (the amplifier can’oduce the red volume without distorting), excessive equalization (turning the tonetprequir

controls too far clockwise, and/or engaging the loudness/bass boost button on your receiver) or some combination of the above. If only one

loudspeaker is exhibiting the problem, and you’re confident that it’s not caused by too little power/too much power/excessive equalization, see

solutions for Problems 1 and 2.

ITEM

NO.

DESCRIPTION

QTY.PART NO.

1.

Front Grille (platinum)

1244-040-00313-0WA

(charcoal)1244-040-00313-0BA

2.Aluminum Face Plate1Not For Sale

3.

Grommet (platinum)

4

327-010-00112W

(charcoal)4327-010-00112B

4.Screw6352-AM04020D603

5.

Baf

fle

1

Not For Sale

6.Woofer110PR80BZR-DW01

7.Screw4351-LM04006A565

8.

T

weeter

1

60DA20AD-DT01

9.Screw2352-CM03010D593

10.Screw4352-FM04014P602

1

1.

Crossover

1

0B-1500-00751

12.Screw Cap1354-HM05418

13.Skidproof Sheet1355-L0507239

14.Washer Sheet1355-P0510240

ITEM

NO.

DESCRIPTION

QTY

.

P

ART NO.

15.

Rear

Cabinet (platinum)1Not for Sale

(charcoal)1Not for Sale

16.Right (Red) Terminal1215-000-00792

17.

Left (Black)

T

erminal1215-000-00793

18.Bracket Ball1325-AL-00187

19.Aluminum Plate (platinum)1320-AL-00184-0WA

(charcoal)

1

320-AL-00184-0W

20.Aluminum Base1320-AL-00185

21.Back Foot Base1320-RUB-00186

22.

Rubber Strip

1

398-NR-00249

23.Bracket Holder1320-AL-00416

24.Screw1351-KM04012A578

25.

W

rench Box

1

398-ABS-00250

26.Wrench1399-FE-00618

27.Screw1351-AM03005A015

28.Iron Plate1399-FE-00619

Product specificaties