Indesit PWE 8148 S Handleiding

Indesit Wasmachine PWE 8148 S

Lees hieronder de 📖 handleiding in het Nederlandse voor Indesit PWE 8148 S (84 pagina's) in de categorie Wasmachine. Deze handleiding was nuttig voor 25 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/84

English,1

WASHING MACHINE

Contents

Installation, 2-3

Unpacking and levelling

Connecting the electricity and water supplies

The first wash cycle

Technical data

Description of the washing machine, 4-5

Control panel

Display

Running a wash cycle, 6

Wash cycles and options, 7

Table of programmes and wash cycles

Wash options

Detergents and laundry, 8

Detergent dispenser drawer

Preparing the laundry

Special wash cycles

Precautions and advice, 9

General safety

Disposal

Opening the porthole door manually

Care and maintenance, 10

Cutting off the water and electricity supplies

Cleaning the washing machine

Cleaning the detergent dispenser drawer

Cleaning the pump

Checking the water inlet hose

Troubleshooting, 11

Service, 12

PWE 8148 S

Instructions for use

CIS

Ðóññêèé, 73

Français,13

Deutsch,25

Nederlands,37

Português,61

Español,49

Installation

 This instruction manual should be kept in a safe place

for future reference. If the washing machine is sold,

transferred or moved, make sure that the instruction

manual remains with the machine so that the new

owner is able to familiarise himself/herself with its

operation and features.

Read these instructions carefully: they contain vital

information relating to the safe installation and operation

of the appliance.

Unpacking and levelling

Unpacking

1. Remove the washing machine from its packaging.

2. Make sure that the washing machine has not been

damaged during the transportation process. If it has

been damaged, contact the retailer and do not proceed

any further with the installation process.

3. Remove the 4

protective screws (used

during transportation) and

the rubber washer with

the corresponding spacer,

located on the rear part of

the appliance (see figure).

4. Close off the holes using the plastic plugs provided.

5. Keep all the parts in a safe place: you will need them

again if the washing machine needs to be moved to

another location.

 Packaging materials should not be used as toys for

children.

Levelling

1. Install the washing machine on a flat sturdy floor,

without resting it up against walls, furniture cabinets or

anything else.

2. If the floor is not

perfectly level,

compensate for any

unevenness by tightening

or loosening the adjustable

front feet (see figure); the

angle of inclination,

measured in relation to the

worktop, must not exceed

2°.

Levelling the machine correctly will provide it with

stability, help to avoid vibrations and excessive noise and

prevent it from shifting while it is operating. If it is placed

on carpet or a rug, adjust the feet in such a way as to

allow a sufficient ventilation space underneath the

washing machine.

Connecting the electricity and water

supplies

Connecting the water inlet hose

1. Connect the inlet hose

by screwing it to a cold

water tab using a 3/4 gas

threaded connection (see

figure).

Before performing the

connection, allow the

water to run freely until it is

perfectly clear.

2. Connect the inlet hose

to the washing machine

by screwing it onto the

corresponding water inlet

of the appliance, which is

situated on the top right-

hand side of the rear part

of the appliance (see

figure).

3. Make sure that the hose is not folded over or bent.

 The water pressure at the tap must fall within the

range of values indicated in the Technical data table (see

next page).

 If the inlet hose is not long enough, contact a

specialised shop or an authorised technician.

Never use second-hand hoses.

Use the ones supplied with the machine.

Connecting the drain hose

Connect the drain hose,

without bending it, to a

drain duct or a wall drain

situated between 65 and

100 cm from the floor;

alternatively, place it

over the edge of a

basin, sink or tub,

fastening the duct

supplied to the tap (see

figure). The free end of

the hose should not be

underwater.

 We advise against the use of hose extensions; if it is

absolutely necessary, the extension must have the

same diameter as the original hose and must not

exceed 150 cm in length.

Electrical connections

Before plugging the appliance into the electricity

socket, make sure that:

 the socket is earthed and complies with all

applicable laws;

 the socket is able to withstand the maximum

power load of the appliance as indicated in the

Technical data table (see opposite);

 the power supply voltage falls within the values

indicated in the Technical data table (see opposite);

 the socket is compatible with the plug of the

washing machine. If this is not the case, replace the

socket or the plug.

 The washing machine must not be installed

outdoors, even in covered areas. It is extremely

dangerous to leave the appliance exposed to rain,

storms and other weather conditions.

 When the washing machine has been installed, the

electricity socket must remain within easy reach.

 Do not use extension cords or multiple sockets.

65 - 100 cm

 The cable should not be bent or compressed.

 The power supply cable must only be replaced by

authorised technicians.

Warning! The company shall not be held responsible

in the event that these standards are not observed.

The first wash cycle

Once the appliance has been installed, and before you

use it for the first time, run a wash cycle with

detergent and no laundry, using wash cycle number 2.

Technical data

Model PWE 8148 S

Dimensions

width 59.5 cm

height 85 cm

depth 62 cm

Capacity between 1 and 8 kg

Electrical

connections

please refer to the technical data

plate applied to the machine

Water connections

maximum pressure 1 MPa (10 bar

)

minimum pressure 0.05 MPa

(0.5 bar)

drum capacity 62 litres

Spin speed up to 1200 rpm

Test wash cycles

in compliance with

regulation

EN 60456

wash cycle 2; temperature 60°C;

performed with a 8 kg load.

This appliance conforms to the

following European Community

directives:

- 89/336/EEC dated 03.05.89

(Electromagnetic Compatibility)

and subsequent amendments

- 2006/95/EC – 2006/95/EC (Low

Voltage)

Product specificaties

Merk:	Indesit
Categorie:	Wasmachine
Model:	PWE 8148 S

Heb je hulp nodig?

Als je hulp nodig hebt met Indesit PWE 8148 S stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Wasmachine Indesit

Indesit BWE 81496X WSV EE Handleiding

10 April 2024

Indesit BWEBE 81496X WKV Handleiding

15 December 2023

Indesit BWE 91496X WSV EE Handleiding

11 November 2023

Indesit MTWE 81495 WK EE Handleiding

12 Juli 2023

Indesit BTW S72200 CH/N Handleiding

12 Juli 2023

Indesit BTW C1200 6N Handleiding

12 Juli 2023

Indesit BI WMIL 91485 UK Handleiding

7 Juli 2023

Indesit BTW L60400 BE Handleiding

30 Juni 2023

Indesit Maxi IWC 7105 Handleiding

20 Juni 2023

Indesit IWSE 5085 B Handleiding

18 Juni 2023

Handleiding Wasmachine

Nieuwste handleidingen voor Wasmachine

Winia WVD-A08T1WK14B Handleiding

28 April 2024

Continental Edison CELL7140IB Handleiding

28 April 2024

Bauknecht WAT Smart Eco 12C Handleiding

27 April 2024

Bauknecht B7 89 SILENCE EE Handleiding

27 April 2024

BEKO WTE 7512 BSS Handleiding

26 April 2024

MPM -4610-PH-04 Handleiding

25 April 2024

Samsung WW11DB8B95GH Handleiding

25 April 2024

Sôlt GGSFLW800W Handleiding

22 April 2024

Whirlpool ZEN FSCR70421 Handleiding

21 April 2024

Samsung WW90T4540TE Handleiding

18 April 2024