Indesit PWDE 7124 S Handleiding

Indesit Wasmachine PWDE 7124 S

Lees hieronder de 📖 handleiding in het Nederlandse voor Indesit PWDE 7124 S (60 pagina's) in de categorie Wasmachine. Deze handleiding was nuttig voor 24 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/60

English,1

WASHER-DRYER

! This symbol reminds you to read this instruction manual.

Contents

Installation, 2-3

Unpacking and levelling

Connecting the electricity and water supplies

The first wash cycle

Technical data

Description of the washer-dryer, 4-5

Control panel

Display

How to run a wash cycle or a drying cycle, 6

Wash cycles and options, 7

Table of programmes and wash cycles

Wash options

Detergents and laundry, 8

Detergent dispenser drawer

Preparing the laundry

Special wash cycles

Precautions and advice, 9

General safety

Disposal

Care and maintenance, 10

Cutting off the water and electricity supplies

Cleaning the washer-dryer

Cleaning the detergent dispenser drawer

Caring for the door and drum of your appliance

Cleaning the pump

Checking the water inlet hose

Troubleshooting, 11

Service, 12

PWDE 7124 W

Instructions for use

Français,13

Español,25

Português,37

Italiano,49

! This instruction manual should be kept in a safe place for

future reference. If the washer-dryer is sold, transferred or

moved, make sure that the instruction manual remains with

the machine so that the new owner is able to familiarise

himself/herself with its operation and features.

! Read these instructions carefully: they contain vital

information relating to the safe installation and operation of

the appliance.

Unpacking and levelling

Unpacking

1. Remove the washer-dryer from its packaging.

2. Make sure that the washer-dryer has not been damaged

during the transportation process. If it has been damaged,

contact the retailer and do not proceed any further with the

installation process.

3. Remove the 4 protective

screws (used during

transportation) and the

rubber washer with the

corresponding spacer,

located on the rear part of

the appliance ( ).see figure

4. Close off the holes using the plastic plugs provided.

5. Keep all the parts in a safe place: you will need them

again if the washer-dryer needs to be moved to another

location.

! Packaging materials should not be used as toys for

children.

Levelling

1. Install the washer-dryer on a flat sturdy floor, without

resting it up against walls, furniture cabinets or anything

else.

2. If the floor is not perfectly

level, compensate for any

unevenness by tightening

or loosening the adjustable

front feet ( ); see figure

the angle of inclination,

measured in relation to the

worktop, must not exceed

2°.

Levelling the machine correctly will provide it with stability,

help to avoid vibrations and excessive noise and prevent it

from shifting while it is operating. If it is placed on carpet or

a rug, adjust the feet in such a way as to allow a sufficient

ventilation space underneath the washer-dryer.

Connecting the electricity and water

supplies

Connecting the water inlet hose

1. Connect the inlet hose

by screwing it to a cold

water tap using a 3/4 gas

threaded connection (see

figure).

Before performing the

connection, allow the

water to run freely until it is

perfectly clear.

2. Connect the inlet hose

to the washer-dryer by

screwing it onto the

corresponding water inlet

of the appliance, which is

situated on the top right-

hand side of the rear part of

the appliance . (see figure)

3. Make sure that the hose is not folded over or bent.

! The water pressure at the tap must fall within the range

of values indicated in the Technical data table (see next

page).

! If the inlet hose is not long enough, contact a specialised

shop or an authorised technician.

! Never use second-hand hoses.

! Use the ones supplied with the machine.

Installation

Connecting the drain hose

Connect the drain hose,

without bending it, to a

drain duct or a wall drain

situated between 65 and

100 cm from the floor;

alternatively, placed it over

the edge of a basin, sink

or tub, fastening the duct

supplied to the tap (see

figure). The free end of

the hose should not be

underwater.

! We advise against the use of hose extensions; if it is

absolutely necessary, the extension must have the same

diameter as the original hose and must not exceed 150

cm in length.

Electrical connections

Before plugging the appliance into the electricity socket,

make sure that:

• the socket is earthed and complies with all applicable

laws;

• the socket is able to withstand the maximum power

load of the appliance as indicated in the Technical data

table (see opposite);

• the power supply voltage falls within the values

indicated in the Technical data table ( );see opposite

• the socket is compatible with the plug of the washer-

dryer. If this is not the case, replace the socket or the plug.

! The washer-dryer must not be installed outdoors, even

in covered areas. It is extremely dangerous to leave the

appliance exposed to rain, storms and other weather

conditions.

! When the washer-dryer has been installed, the electricity

socket must remain within easy reach.

! Do not use extension cords or multiple sockets.

! The cable should not be bent or compressed.

! The power supply cable must only be replaced by

authorised technicians.

Warning! The company shall not be held responsible in the

event that these standards are not observed.

The first wash cycle

Once the appliance has been installed, and before you use

it for the first time, run a wash cycle with detergent and no

laundry, using wash cycle number 2.

65 - 100 cm

Technical data

Model PWDE 7124 W

Dimensions

width 59.5 cm

height 85 cm

depth 55 cm

Capacity from 1 to 7 kg for wash programme

from 1 to 5 kg for the drying programme

Electrical

connections

please refer to the technical data plate

fixed to the machine

Water connections

maximum pressure 1 MPa (10 bar)

minimum pressure 0.05 MPa (0.5 bar)

drum capacity 52 litres

Spin speed up to 1200 rotations per minute

Energy rated

programmes

according to

regulation

EN 50229

wash: programme 2; temperature 60°C;

using a load of 7 kg.

drying: first drying cycle performed with

a 2 kg load, by selecting the drying level

“A1” (IRON);

second drying cycle performed with a

5 kg load, by selecting the maximum

drying level “A4” (EXTRA).

This appliance conforms to the following

EC Directives:

- 2004/108/EC (Electromagnetic Compa-

tibility)

- 2006/95/EC (Low Voltage)

- 2002/96/EC

Product specificaties

Merk:	Indesit
Categorie:	Wasmachine
Model:	PWDE 7124 S
Apparaatplaatsing:	Vrijstaand
Soort bediening:	Buttons,Rotary
Kleur van het product:	Zilver
Deurscharnieren:	Links
Ingebouwd display:	Ja
Gewicht:	66000 g
Breedte:	595 mm
Diepte:	551 mm
Hoogte:	850 mm
Type lader:	Voorbelading
Trommelinhoud:	52 l
Uitgestelde start timer:	Ja
Startvertraging:	24 uur
Resterende tijd indicatie:	Ja
Energie-efficiëntieklasse (oud):	B
Energieverbruik wassen:	- kWu
Wasklasse:	A
Aanpasbare centrifugesnelheid:	Ja
Maximale centrifugesnelheid:	1200 RPM
Droogcapciteit:	5 kg
Jaarlijks engergieverbruik wassen & drogen:	1134 kWu
Energiegebruik bij wassen & drogen:	- kWu
Waterverbruik wassen & drogen:	- l
Aantal wasprogramma's:	16
Minimum centrifugesnelheid:	1200 RPM
Spoelen Plus functie:	Ja
Nominale capaciteit (wassen):	7 kg
Wasprogramma's:	Hand/wool,Quick,Delicate/silk