Indesit IWDD 6145 Handleiding

Indesit Was/Droogcombi IWDD 6145

Lees hieronder de 📖 handleiding in het Nederlandse voor Indesit IWDD 6145 (36 pagina's) in de categorie Was/Droogcombi. Deze handleiding was nuttig voor 43 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/36

Contents

Installation, 2-3

Unpacking and levelling

Connecting the electricity and water supplies

The first wash cycle

Technical data

Description of the washer-dryer and

starting a wash cycle, 4-5

Control panel

Indicator lights

Starting a wash cycle

Wash cycles, 6

Table of wash cycles

Personalisation, 7

Setting the temperature

Setting the drying cycle

Functions

Detergents and laundry, 8

Detergent dispenser drawer

Preparing the laundry

Garments requiring special care

Load balancing system

Precautions and tips, 9

General safety

Disposal

Care and maintenance, 10

Cutting off the water or electricity supply

Cleaning the washer-dryer

Cleaning the detergent dispenser drawer

Caring for the door and drum of your appliance

Cleaning the pump

Checking the water inlet hose

Troubleshooting, 11

Service, 12

IWDD 6145

Instructions for use

WASHER-DRYER

English,1

! This symbol reminds you to read this instruction manual.

Deutsch,13 Nederlands,25

! This instruction manual should be kept in a safe place for

future reference. If the washer-dryer is sold, transferred or

moved, make sure that the instruction manual remains with

the machine so that the new owner is able to familiarise

himself/herself with its operation and features.

! Read these instructions carefully: they contain vital infor-

mation relating to the safe installation and operation of the

appliance.

Unpacking and levelling

Unpacking

1. Remove the washer-dryer from its packaging.

2. Make sure that the washer-dryer has not been damaged

during the transportation process. If it has been damaged,

contact the retailer and do not proceed any further with the

installation process.

3. Remove the 4 protective

screws (used during tran-

sportation) and the rubber

washer with the correspon-

ding spacer, located on the

rear part of the appliance

(see figure).

4. Close off the holes using the plastic plugs provided.

5. Keep all the parts in a safe place: you will need them

again if the washer-dryer needs to be moved to another

location.

! Packaging materials should not be used as toys for

children.

Levelling

1. Install the washer-dryer on a flat sturdy floor, without re-

sting it up against walls, furniture cabinets or anything else.

2. If the floor is not perfectly

level, compensate for any

unevenness by tightening

or loosening the adjusta-

ble front feet (see figure);

the angle of inclination,

measured in relation to the

worktop, must not exceed

2°.

Levelling the machine correctly will provide it with stability,

help to avoid vibrations and excessive noise and prevent it

from shifting while it is operating. If it is placed on carpet or

a rug, adjust the feet in such a way as to allow a sufficient

ventilation space underneath the washer-dryer.

Connecting the electricity and water

supplies

Connecting the water inlet hose

1. Connect the supply pipe

by screwing it to a cold

water tap using a ¾ gas

threaded connection (see

figure).

Before performing the con-

nection, allow the water to

run freely until it is perfectly

clear.

2. Connect the inlet hose

to the washer-dryer by

screwing it onto the corre-

sponding water inlet of the

appliance, which is situa-

ted on the top right-hand

side of the rear part of the

appliance (see figure).

3. Make sure that the hose is not folded over or bent.

! The water pressure at the tap must fall within the values

indicated in the Technical details table (see next page).

! If the inlet hose is not long enough, contact a specialised

shop or an authorised technician.

! Never use second-hand hoses.

! Use the ones supplied with the machine.

Installation

Connecting the drain hose

Connect the drain hose,

without bending it, to a drai-

nage duct or a wall drain

located at a height between

65 and 100 cm from the

floor;

alternatively, rest it on

the side of a washbasin

or bathtub, fastening the

duct supplied to the tap

(see figure). The free end

of the hose should not be

underwater.

! We advise against the use of hose extensions; if it is

absolutely necessary, the extension must have the same

diameter as the original hose and must not exceed 150 cm

in length.

Electrical connections

Before plugging the appliance into the electricity socket,

make sure that:

• thesocketisearthedandcomplieswithallapplicable

laws;

• thesocketisabletowithstandthemaximumpowerload

of the appliance as indicated in the Technical data table

(see opposite);

• thepowersupplyvoltagefallswithinthevaluesindicated

in the Technical data table (see opposite);

• thesocketiscompatiblewiththeplugofthewasher-dr-

yer. If this is not the case, replace the socket or the plug.

! The washer-dryer must not be installed outdoors, even

in covered areas. It is extremely dangerous to leave the

appliance exposed to rain, storms and other weather

conditions.

! When the washer-dryer has been installed, the electricity

socket must be within easy reach.

! Do not use extension cords or multiple sockets.

! The cable should not be bent or compressed.

! The power supply cable must only be replaced by autho-

rised technicians.

Warning! The company shall not be held responsible in the

event that these regulations are not respected.

The first wash cycle

Once the appliance has been installed, and before you use

it for the first time, run a wash cycle with detergent and no

laundry, using the wash cycle 2.

65 - 100 cm

Technical data

Model IWDD 6145

Dimensions

width 59.5 cm

height 85 cm

depth 53.5 cm

Capacity from 1 to 6 kg for the wash programme;

from 1 to 5 kg for the drying programme.

Electrical

connections

please refer to the technical data plate

fixed to the machine

Water connections

maximum pressure 1 MPa (10 bar)

minimum pressure 0.05 MPa (0.5 bar)

drum capacity 52 litres

Spin speed up to 1400 rotations per minute

Energy rated

programmes

according to

regulation

EN 50229

Wash: programme 2; temperature 60°C;

using a load of 6 kg.

Drying: first drying cycle performed with

1 kg load, by selecting a drying time of

60 min.;

second drying cycle performed with

5 kg load and the DRYING knob on the

setting .

This appliance conforms to the following

EC Directives:

- 2004/108/EC (Electromagnetic Compa-

tibility)

- 2006/95/EC (Low Voltage)

- 2002/96/EC

Product specificaties

Merk:	Indesit
Categorie:	Was/Droogcombi
Model:	IWDD 6145
Apparaatplaatsing:	Vrijstaand
Soort bediening:	Draaiknop
Kleur van het product:	Wit
Deurscharnieren:	Links
Ingebouwd display:	Ja
Breedte:	595 mm
Diepte:	535 mm
Hoogte:	850 mm
Type lader:	Voorbelading
Trommelinhoud:	52 l
Uitgestelde start timer:	Ja
Aantal droogprogramma's:	3
Breedte verpakking:	650 mm
Diepte verpakking:	590 mm
Hoogte verpakking:	890 mm
Energie-efficiëntieklasse (oud):	B
Energieverbruik wassen:	- kWu
Wasklasse:	A
Jaarlijkse energieverbruik wassen:	224 kWu
Centrifuge-droger klasse:	B
Maximale centrifugesnelheid:	1400 RPM
Droogcapciteit:	5 kg
Jaarlijks waterverbruik wassen:	10400 l
Jaarlijks engergieverbruik wassen & drogen:	972 kWu
Energiegebruik bij wassen & drogen:	- kWu
Waterverbruik wassen & drogen:	- l
Water verbruik wassen:	52 l
Aantal wasprogramma's:	16
Half-geladen:	Ja
Nominale capaciteit (wassen):	6 kg