Indesit IDVL 75 BRK.9 UK Handleiding

Indesit Wasdrogers IDVL 75 BRK.9 UK

Lees hieronder de 📖 handleiding in het Nederlandse voor Indesit IDVL 75 BRK.9 UK (16 pagina's) in de categorie Wasdrogers. Deze handleiding was nuttig voor 29 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/16

English

Contents

Installation, 2

Warnings, 4

Care and maintenance, 6

Description of the tumble dryer, 7

How to carry out a drying cycle, 9

Programmes and options, 10

Laundry, 13

Troubleshooting, 14

Assistance, 15

Instruction manual

TUMBLE DRYER

This symbol reminds you to read this

instruction manual.

! Keep this manual at hand for immediate reference whenever

necessary. Always store this manual close to the tumble dryer and

remember to pass it on to any new owners when selling or tran-

sferring the appliance, so they may familiarise with the warnings

and suggestions herein contained.

! Read these instructions carefully: the following pages contain

important information on installation and useful suggestions for

operating the appliance.

www.indesit.com

Installation

15 mm

Where to install the tumble dryer

If the dryer is installed below a worktop,

ensure there are 10 mm

between the upper pa-

nel of the dryer and any

objects above it, and 15

mm between the sides

of the machine and the

walls or furniture units

adjacent to it. This ensu-

res adequate air circu-

lation. Make sure the air

inlets on the rear panel are not blocked or

obstructed.

Ventilation

This appliance gently dries laundry by taking in cold, clean

and relatively dry air, heating it and passing it through the

fabric. To facilitate the drying process, damp air is expelled

at the rear, through a ventilation hose. When the dryer is in

use, there has to be adequate ventilation to avoid a back

flow of gases into the room from appliances burning other

fuels, including open fires.

Mobile ventilation system

When using the tumble dryer with the mobile ventilation

system, a ventilation hose must be connected. The hose

should be securely fastened to the ventilation hole at

the rear of the appliance (see “Description of the tumble

dryer”). We recommend the hose is connected to an outlet

near the tumble dryer, if possible. If it cannot be installed

in a permanent spot, the tumble dryer will still function

perfectly well if the ventilation hose is passed through a

partially-opened window.

Make sure you do not point the ventilation hose towards

the air inlet, which is located on the rear of the appliance.

The ventilation hose should not exceed a maximum

length of 2.4 metres; it should also be shaken frequently

to remove any fluff, dust or water deposits inside it. Make

sure you do not crush the hose. The hose supplied has an

oval section to aid installation.

Fixed ventilation kit

We recommend the ventilation hose is connected to a

ventilation for windows or doors, available from the kit

retailer which originally sold you the appliance or from your

local spare parts stockist.

Wall ventilation hole

1. Leave an opening in the wall.

2. Make the hose as short and

straight as possible, in order

to prevent any moisture from

condensing and leaking back

into the appliance.

3. The hole in the wall must

also be straight and pointing

downwards, so that the flow of

air coming out is not impeded.

Areas A and B should be checked frequently, to prevent

the accumulation of fluff or debris, particularly if the tumble

dryer is used very often. The hose adaptor must be fitted

correctly, in order to prevent damp air from coming back

into the room.

Ventilation hole

The ventilation hole should be directly behind the dryer in

order to keep the hose as short as possible.

Make sure you do not push the tumble dryer too far

backwards, as this could lead to the ventilation hose being

crushed, bent or even disconnected.

There should be no cuts, kinks or “U”-shaped bends

in the hose, as these could impede ventilation or trap

condensation.

The end of the hose must be facing downwards, in order to

prevent the hot, damp air from forming condensation in the

room or the tumble dryer.

Make sure that the tumble dryer is adequately ventilated,

and that the end of the ventilation hose is not pointing

towards the air inlet pipe on the rear of the appliance.

The ventilation hose must always be fitted to ensure

optimum performance.

The hose will need to be

expanded to be fitted and

clamped.

Make sure that the ventilation

hose, air inlet vents, and outlets

are not obstructed or blocked.

Do not let the tumble dryer

recirculate exhaust air.

Improper use of the tumble

dryer may result in fire hazards.

Ventilation

The air emitted by the tumble dryer must not be expelled in

the same duct as used for the fumes produced by different

appliances which burn gas or other fuels.

Do not discharge the exhaust air into an extraction system

or any duct with an extractor fan. This will affect the way

the thermal controls operate and can result in a fire hazard.

Make sure that the room in which the

tumble dryer is installed is not damp, and

that it is adequately ventilated.

We do not recommend that the dryer is

installed in a cupboard but the dryer must

never be installed behind a lockable door,

a sliding door or a door with a hinge on the

opposite side to that of the dryer door.

The appliance must be installed with the

rear surface placed against a wall.

Electrical connections

Before plugging the appliance into the so-

cket, check the following:

Make sure your hands are dry.

The socket must have an earth connec-

tion.

The socket must be able to withstand the

machine’s maximum power output as indi-

cated on the rating plate (see Description of

the tumble dryer).

The power supply voltage must fall within

the values indicated on the rating plate (see

Description of the tumble dryer).

Do not use extension leads. Do not pull

the power supply cable. Do not use multiple

plug adaptors if the appliance is fitted with a

plug. For appliances with fitted plug, if the

plug is not suitable for you socket outlet,

contact a qualified technician.

The dryer must not be installed outdoors,

even if the space is sheltered.

Once installed, the dryer’s electrical wire

and plug must be within reach.

The power cord must not be bent or

squashed.

If the plug being replaced is a non-

rewirable type, then the cut-off plug must be

disposed of safely. DO NOT leave it where it

can be inserted into a socket and create a

shock hazard.

The electric cord must be regularly

checked. If the supply cord is damaged, it

must be replaced by service agent. see (

Service).

The manufacturer denies any

responsibility should any of these rules not

be followed.

If in doubt about any of the above consult

a qualified electrician.

Levelling the tumble dryer

The tumble dryer should be installed level in order to

operate correctly.

After installing the tumble dryer in its permanent position

make sure it is level; check its side-to-side levelling first,

followed by front-to-back.

If the tumble dryer is not perfectly level, use a wooden

block to support it while you adjust the two front feet, up

down as necessary.

Before you start your dryer

Once the tumble dryer is installed, clean the inside of the

drum before operating it and remove any dirt accumulated

during transportation.

Product specificaties

Merk:	Indesit
Categorie:	Wasdrogers
Model:	IDVL 75 BRK.9 UK
Apparaatplaatsing:	Vrijstaand
Soort bediening:	Buttons,Rotary
Kleur van het product:	Zwart
Ingebouwd display:	Ja
Gewicht:	28800 g
Breedte:	595 mm
Diepte:	550 mm
Hoogte:	850 mm
Netbelasting:	2600 W
Type lader:	Voorbelading
Deurkleur:	Zwart
Snoerlengte:	1.5 m
Trommelinhoud:	100 l
Uitgestelde start timer:	Ja
Startvertraging:	9 uur
Kinderslot:	Ja
Duur cyclus:	129 min
Geluidsniveau:	69 dB
Energie-efficiëntieklasse:	B
Jaarlijks energieverbruik:	467 kWu
Geschikt voor paneelaanpassing:	Ja
Verstelbare voeten:	Ja
Huidige waardering:	13 A
Nominale capaciteit:	7 kg
Type beeldscherm:	LED
Droogprogramma's:	Wool,Mix,Sport,Jeans/denim,Cotton,Synthetics