Ignis G0F L634O Handleiding

Bekijk gratis de handleiding van Ignis G0F L634O (52 pagina’s), behorend tot de categorie Vaatwasser. Deze gids werd als nuttig beoordeeld door 21 mensen en kreeg gemiddeld 4.5 sterren uit 9 reviews. Heb je een vraag over Ignis G0F L634O of wil je andere gebruikers van dit product iets vragen? Stel een vraag

1

ENQuick Guide

PROGRAMS TABLE

ProgramPrograms description

Drying

phase

Auto

Door

Available options

*)

Duration

of wash

program

(h:min)

**)

Water

consumption

(litres/cycle)

Energy

consumption

(kWh/cycle)

1.

Eco50°- Eco program is suitable to clean normally soiled ta-

bleware. that for this use. it is the most ecient program in

terms of its combined energy and water consumption. and

that it is used to assess compliance with the EU Ecodesign leg-

islation.

3:109.50.85

2.

Auto Intensive65°-Automatic program for heavily soiled

dishes and pans (not to be used for delicate items).

2:00 - 3:10 14.0 - 17.01.50 - 1.85

3.

Auto Mixed 55°- Automatic program for normally soiled pans

and dishes.

1:30 - 2:30 14.5 - 16.01.15 - 1.30

4.

Fast&Clean 28’45° - Program to be used for half load of light-

ly-soiled dishes with no dried food residues. Does not have

drying phase.

-

0:289.00.60

5.

Pre-Wash -Use to refresh crockery planned to be washed lat-

er. No detergent to be used with this program.

--

0:104.00.01

ECO program data is measured under laboratory conditions according to European Standard EN 60436:2020. Note for Test Laboratories: For information on

comparative EN testing conditions, please send an email to the following address: [email protected]

Pre-treatment of the dishes is not needed before any of the programs.

*) Not all options can be used simultaneously.

**) Values given for programs other than the program Eco are indicative only. The actual time may vary depending on many factors such as temperature and

pressure of the incoming water, room temperature, amount of detergent, quantity and type of load, load balancing, additional selected options and sensor cali-

bration. The sensor calibration can increase program duration up to 20 min.

CONTROL PANEL

1. On-O/Reset button with indicator

light

2. Program selection button with

indicator light

3. Half Load button with indicator light

4. Rinse Aid rell indicator light

5. Salt rell indicator light

6. Program indicator lights

7. Delay indicator light

8. Delay button with indicator

light

9. Tablet (Tab) button with

indicator light

10. Start/Pause button with

indicator light / Drain out

FIRST TIME USE

FILLING THE SALT RESERVOIR

The use of salt prevents the formation of LIMESCALE on the dishes and on

the machine’s functional components.

• It is mandatory that the salt reservoir never be empty.

• It is important to set the water hardness.

The salt reservoir is located in the lower part of the dishwasher and must be

lled when the SALT REFILL indicator light in the control panel is lit.

1. Remove the lower rack and unscrew the reservoir cap

(anticlockwise).

2. Only the rst time you do this: ll the salt reservoir

with water.

3. Position the funnel and ll the salt reservoir (see gure)

right up to its edge (approximately 1 kg); it is not unu-

sual for a little water to leak out.

4. Remove the funnel and wipe any salt residue away from the opening.

Make sure the cap is screwed on tightly, so that no detergent can get into the

container during the wash program (this could damage the water softener be-

yond repair). Whenever you need to add salt, it is mandatory to complete the

procedure before the beginning of the washing cycle to avoid corrosion.

FILLING THE RINSE AID DISPENSER

Rinse aid makes dish DRYING easier. The rinse

aid dispenser should be lled when the ARINSE

AID REFILL indicator light in the control pan-

el is lit.NEVER pour the rinse aid directly into the

appliance tub.

A

C

D

FILLING THE DETERGENT DISPENSER

To open the detergent dispenser use the opening device . Introduce the C

detergent into the dry dispenser only. Place the amount of detergent for D

pre-washing directly inside the tub.

If all-in-one detergents are used, we recommend using the TABLETbutton,

because it adjusts the program so that the best washing and drying results

are always achieved.

Usage of detergent not designed for dishwashers may cause malfunc-

tion or damage to the appliance.

WATER SOFTENING SYSTEM

Water softener automatically reduces water hardness, consequently pre-

venting scale buildup on heater, contributing also to better cleaning e-

ciency. This system regenerates itself with salt, therefore it is required

to rell salt container when empty.

Frequency of regeneration depends on water hardness level setting - regen-

eration takes place once per 6 Eco cycles with water hardness level set to 3.

Regeneration process starts in nal rinse and nishes in drying phase, be-

fore cycle ends.

• Single regeneration consumes: ~3.5L of water;

• Takes up to 5 additional minutes for the cycle;

• Consumes below 0.005kWh of energy.

3

1

2

85469710

THANK YOU FOR BUYING AN IGNIS PRODUCT.

Before using the appliance carefully read the Safety Instruction.

PLEASE SCAN THE QR CODE ON YOUR

APPLIANCE IN ORDER TO HAVE MORE

DETAILED INFORMATION

Product specificaties