Icon Fires LB914 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Icon Fires LB914 (12 pagina's) in de categorie Haarden. Deze handleiding was nuttig voor 38 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/12
1"
"
Commercial Burner Manual
2"
"
Operating Manual
Thank you for purchasing this Icon Fires Burner. Icon Fires is very safety conscious and
we have taken every care in designing, manufacturing and assembling your Icon
Fires Burner to ensure it operates effectively, efficiently and safely. In return we ask
that you exercise care when using this product and follow the instructions below.
Before using your Icon Fires burner, please read all the information contained in this
operation manual carefully. Icon Fires cannot be held responsible for any damage
or injury caused if these instructions are not followed.
IMPORTANT SAFEGUARDS
Read all instructions and warnings before using this fireplace.
WARNING
• DO NOT OVERFILL THE BURNER’S INTENDED CAPACITY.
• DO NOT INSTALL INTO AN AREA WHERE THERE IS A DRAFT WHICH CAN AFFECT THE
FLAME. ESPECIALLY WHEN INSTALLING IN OLD HEARTHS, MAKE SURE HEARTH IS
SEALED.
• USE ONLY THE FUEL FOR WHICH THE LINEAR BURNER IS INTENDED.
• DO NOT TOUCH THE EXTERIOR OF THE LINEAR BURNER DURING OR AFTER BURNING.
• PARTS OF THIS LINEAR BURNER CAN REACH HIGH TEMPERATURES.
• DO NOT HAVE COMBUSTIBLE OBJECTS IN CLOSE PROXIMITY TO THE BURNER.
• NEVER POSITION THE BURNER WITHIN RANGE OF COMBUSTIBLE ITEMS THAT CAN BE
MOVED/BUMPED BY ACCIDENT, OR BLOWN BY THE WIND. e.g CURTAINS & BLANKETS
• ONLY USE THE LINEAR BURNER IN AREAS WITH GOOD VENTILATION.
• DO NOT COVER THE LINEAR BURNER VENT WITH ANY DECORATIVE ITEMS WHETHER
THEY ARE COMBUSTIBLE OR NON COMBUSTIBLE , INCLUDING BUT NOT LIMITED TO
ARTIFICIAL LOGS, STONES, PEBBLES, GLASS BEADS etc.
CAUTION
• Make sure you have read and understood this manual before using this product.
• Do not overfill or spill fuel when refilling.
• If fuel is spilled, wipe with a dry cloth and allow the rest to evaporate before
introducing a flame to the burner.
• If the burner is accidentally overfilled, follow the steps given in these next pages.
• To refill, wait until the burner is at the room temperature after the flame has been
turned off. NOTE: the flame may not be visible to the naked eye in daylight.
• Never refill over or near an open flame.
• Use the supplied funnel or pump to refill.
Remove all plastic & packaging before using the burner.
3"
"
Trouble shooting and operating tips:
• The hooks on the back of the Sliding Lid Handle can be used to carry the Linear Burner
by hooking it around the slotted openings in the Vent Plate as shown in the image
below.
• The first fill will take longer as the material inside the Fuel Tank will absorb the fuel.
Subsequent filling should be quicker. Take care to not fill the burner at a faster rate than
what the material inside can absorb the fuel.
• If the fire does not extinguish the first time by closing the Sliding Lid follow these steps and
repeat if necessary.
o Check that the surface below the sliding plate is clean and free from
obstruction.
o Apply strong downward force and in one quick motion move the sliding plate
towards the closed position. If the flame is still visible repeat this step as a
double motion still applying strong downward force in quick succession.
• Never blow on the flame whilst the Sliding Lid is in an open position.
• If your Linear Burner does not ignite after it has been closed overnight you must refill the
burner.
• VERY IMPORTANT: Take special care when adding fuel to the Linear Burner, always close
the Sliding Lid for a few minutes before adding fuel to make sure there is no visible flame
in the Burner Vent.
• If after some time you find the Sliding Lid has become ‘sticky’ when attempting to move
it then remove the Sliding Lid from its housing and rub the underside using the green side
of a Scotch Bright scouring pad. Take care to only scrub in the direction of the brushing
lines of the stainless steel.
• Make sure you keep your burner clean especially the surface that the Sliding Lid slides on
and ensure that any excess fuel on the surface of the burner is wiped off before use.
"
"
"
"
"


Product specificaties

Merk: Icon Fires
Categorie: Haarden
Model: LB914

Heb je hulp nodig?

Als je hulp nodig hebt met Icon Fires LB914 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Haarden Icon Fires

Icon Fires

Icon Fires SB800 Handleiding

22 September 2023
Icon Fires

Icon Fires SB500 Handleiding

22 September 2023
Icon Fires

Icon Fires LB914 Handleiding

22 September 2023
Icon Fires

Icon Fires RD380 Handleiding

22 September 2023
Icon Fires

Icon Fires SB320 Handleiding

22 September 2023

Handleiding Haarden

Nieuwste handleidingen voor Haarden