Hydrotherm Dynamic-SS/X8/OP Handleiding

Hydrotherm Ketel & boiler Dynamic-SS/X8/OP

Lees hieronder de 📖 handleiding in het Nederlandse voor Hydrotherm Dynamic-SS/X8/OP (30 pagina's) in de categorie Ketel & boiler. Deze handleiding was nuttig voor 30 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/30
Welcome to the future of hot water.
OWNER’S MANUAL
DYNAMIC- XSS/ 8/OP
DYNAMIC - SS/X8/C
Congratulations on purchasing your new system.
You are now the proud owner of Australia’s best value, best performing heat
pump. We spent over three years designing and developing the Hydrotherm
range to ensure that each unit will provide years of trouble free operation.
However, in order to perform optimally it is important to ensure that your
Hydrotherm is installed and operated inline with the instruction found in this
manual. Once operational there is little you need to do, except enjoy plenty
of affordable hot water.
3
1.0 PARTS & CONSTRUCTION SCHEMATIC................
2.0 INSTALLATION INSTRUCTIONS............................
3.0 PLUMBING SCHEMATICS......................................
4.0 PLUMBING INSTALLATION...................................
5.0 ELECTRICAL CONNECTIONS.................................
6.0 COMMISSIONING THE SYSTEM............................
7.0 OPERATION PANEL INSTRUCTIONS.....................
8.0 ERROR HANDLING................................................
9.0 TROUBLE SHOOTING.............................................
10. SERVICE REPRESENTATIVE MAINTENANCE.......
11. WARRANTY.............................................................
CONTENTS
For Outdoor use, or if its installed
inside minimum15m
3 room volume
The Ambient of the appliance to
be used is -5°C to 35°C
Positioning, installation and
commissioning must be carried out
by trained personnel working in
accordance with these operating
and installation instructions.
WARNING:
This appliance is not intended for
use by persons (including children)
with reduced physical sensory
or mental capabilities, or lack of
experience and knowledge, unless
they have been given supervision
or instruction concerning use of the
appliance by a person responsible
for their safety. Children should
be supervised to ensure that they
do not play with the appliance.
The appliance shall be installed in
accordance with national wiring
regulations.
Symbols used in these instructions
Observe the following safety instructions:
Please Note:
Warning about possible dangers.
iNote:
Important information and tips.
iNote: Carefully read these
operating and installation
instructions and keep them safe.
Should the equipment change
hands, pass these instructions to
the subsequent owner. Pass them
to the trained contractors for
servicing purposes.
1.1 Heat Pump Schematic
1.2 Heat Pump Tank Schematic
2.1 Delivery
2.2 Location
2.3 Airflow
2.4 Noise
3.1 VOLT Connection Dimensions & Components
3.2 DYNAMIC Connection Dimensions & Components
5.1 Electrical Schematic
5.2 Pre-Connection & Regulations
5.3 Hard Wiring the System
7.1 Control / Display Interface
7.2 Display Panel
7.3 Setting The Clock
7.4 Timers
7.5 F11 Maximum Temperature Setting
7.6 F12 Temperature To Activate The Heat Pump
7.7 Other Settings
4
6
8
10
12
14
16
24
25
26
27


Product specificaties

Merk: Hydrotherm
Categorie: Ketel & boiler
Model: Dynamic-SS/X8/OP

Heb je hulp nodig?

Als je hulp nodig hebt met Hydrotherm Dynamic-SS/X8/OP stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Ketel & boiler Hydrotherm

Handleiding Ketel & boiler

Nieuwste handleidingen voor Ketel & boiler