Hotpoint NT M11 9X2SXB UK Handleiding

Bekijk gratis de handleiding van Hotpoint NT M11 9X2SXB UK (4 pagina’s), behorend tot de categorie Wasdroger. Deze gids werd als nuttig beoordeeld door 66 mensen en kreeg gemiddeld 4.5 sterren uit 6 reviews. Heb je een vraag over Hotpoint NT M11 9X2SXB UK of wil je andere gebruikers van dit product iets vragen? Stel een vraag

THANK YOU FOR BUYING A HOTPOINT PRODUCT.

In order to receive a more complete assistance, please

register your product on www.hotpoint.eu/register

EN

Quick guide

Before using the appliance carefully read the Safety

Instruction.

OPENING THE DOOR DURING THE CYCLE

Laundry can be checked while the drying cycle runs and any

garments already dry can be removed, while drying continues for

the remaining items. After closing the door, press the "Start/Pause"

button to resume machine operation.

Keep the door closed until the cycle end to save time and energy.

DAILY USE

Doing this will keep your machine working at its BEST:

- remember to empty your water tank after each drying cycle.

- remember to clean your lters after each drying cycle.

Refer to the Care & Maintenance section.

1. Plug the dryer into the power supply socket.

2. Open the door and load garments; always refer to instructions on

clothing labels and the max loads indicated in the programme

section. Empty pockets. Make sure garments do not get caught

between the door and/or the door lter. Do not load items that

are dripping wet. Do not tumble dry large, very bulky items.

3. Close the door.

4. Press the "On/O" button.

5. Select the most suitable programme

for the type of fabric in that

load.

6. Select the options, if necessary.

7. Press the "

Start/Pause"

button to begin drying.

8. At the end of the drying cycle, a buzzer will beep. An indicator on

the control panel signals the end of the cycle. Pull the load out

immediately to prevent the formation of creases on laundry.

9. Turn the machine o by pressing the "On/O" button, open the

door and pull the clothing out. If the machine is not switched o

manually, after about a quarter of an hour from the end of the

cycle , the appliance turns o automatically to save energy.

Note that some programme/option accords with "Crease Care"

system. This means that for some hours, after the end of the

drying cycle, the drum rotates at regular intervals to prevent the

formation of creases.

In case of power failure, it is necessary to press the "Start/Pause"

button to restart the cycle.

CARE LABEL

Always check the care labels, especially when placing garments in

the tumble dryer for the  rst time. Below are the most commonly

used symbols:

May be tumble dried.

Do not tumble dry.

Tumble dry – high heat.

Tumble dry – low heat.

The wool drying cycle of this machine

has been approved by The Woolmark

Company for the drying of wool

garments labelled as “hand wash”

provided that the garments are dried

according to the instructions issued

by the manufacturer of this machine.

Follow the garment care label for other

laundry instructions. . The Woolmark symbol is a Certi cation

mark in many countries.

M1762

FIRST TIME USE

Make sure that the water tank is correctly inserted. Make sure

that the drain hose on the back of the dryer is xed correctly,

either to the dryer’s water tank, or to your domestic drainage

system.

The dryer must be installed in a room with a temperature

ranging between 5°C and 35°C to ensure proper operation.

Before using the dryer make sure it has been in an upright

position for at least 6 hours.

Should you wish to change the opening side of the door, please

contact our After-sales Service. (See phone number in the

warranty booklet).

CONTROL PANEL

1 ON/OFF Button (hold for Reset)

2 Programme Selection Knob

3 Start/Pause Button

Options Buttons*

4 Active Care

5 Dryness Level

6 Start Delay

7 Timed Drying

8 Cycle End

9 Gentle (hold for Key Lock)

10 Crease Care (Mute)hold for

*Note: some models may have the wording in full instead of the icons.

INDICATORS

Dryness Level: Iron Dry - Hanger Dry - Cupboard Dry - Extra Dry

Cycle Phase: ENDDrying - Cool Down - End of Cycle -

Empty water tank - Clean door lter - Clean bottom lter

Refer to troubleshooting section: Failure: Call after sales service -

DEMO

Demo Mode

3 “

“

“

“

“

3 “

“

“

“

“

END

END

END

END

END

1

3

2

4

10

8

9

56 7

D

D

D

D

D

E

E

E

E

E

M

M

M

M

M

O

O

O

O

O

h

h

h

h

h

h

Product specificaties