Hotpoint FDF784G Handleiding

Hotpoint Vaatwasser FDF784G

Lees hieronder de 📖 handleiding in het Nederlandse voor Hotpoint FDF784G (20 pagina's) in de categorie Vaatwasser. Deze handleiding was nuttig voor 28 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/20

Instruction booklet

,1509)50-4

Contents

Installation, 2-5

Positioning and levelling

Technical data

Electrical connection

Connecting the water supply

Description of the appliance, 6

Overall view

Control panel

Loading the racks, 7

Lower rack

Cutlery basket

Upper rack

Start-up and use, 8-9

Starting the dishwasher

Loading the detergent

Washing options

Wash cycles, 10

Wash cycle table

Rinse aid and refined salt, 11

Loading the rinse aid

Loading the refined salt

Care and maintenance, 12

Shutting off the water and electricity supplies

Cleaning the dishwasher

Preventing unpleasant odours

Cleaning the sprayer arms

Cleaning the water inlet filter

Cleaning the filters

Leaving the machine unused for extended periods

Precautions and advice, 13-14

General safety

Disposal

Saving energy and respecting the environment

Troubleshooting, 15

After Sales Service, 16

After Sales Service

Essential Contact Information

Parts and Accessories

Appliance Registration

Hotpoint Guarantee, 17

.,. %&"

English, 1

Positioning and levelling

1. Remove the appliance from all packaging and

check that it has not been damaged during

transportation.

If it has been damaged, contact the retailer and do not

proceed any further with the installation process.

2. Check the dishwasher by placing it so that its sides

or back panel are in contact with the adjacent

cabinets or even with the wall. This appliance can also

be recessed under a single worktop* (see the

Assembly instruction sheet).

3. Position the dishwasher on a level and sturdy floor. If

the floor is uneven, the front feet of the appliance may

be adjusted until it reaches a horizontal position (the

angle of inclination must not exceed 2 degrees). If the

appliance is levelled correctly, it will be more stable

and much less likely to move or cause vibrations and

noise while it is operating.

4*. Adjust the height of the rear foot from the front of

the appliance* on the central lower part of the

dishwasher, turning a hexagonal spanner (red color)

with an opening of 8 mm in a clockwise direction to

increase the height or in an anticlockwise direction to

decrease the height.

Anti-condensation strip*

After installing the dishwasher, open the door and

stick the adhesive transparent strip under the

wooden shelf in order to protect it from any

condensation that may form.

Keep this instruction manual in a safe place for

future reference. If the appliance is sold, given away

or moved, please ensure the manual is kept with the

machine, so that the new owner may benefit from the

advice contained within it.

Please read this instruction manual carefully: it

contains important information regarding the safe

installation, use and maintenance of the appliance.

If the appliance must be moved at any time,

keep it in an upright position; if absolutely

necessary, it may be tilted onto its back.

Advice regarding the first wash cycle

After the appliance has been installed, immediately

before running the first wash cycle, completely fill

the salt dispenser with water and add only then

approximately 1 kg of salt (see chapter entitled

Rinse aid and refined salt). The water may overflow:

this is normal and is not a cause for concern. Select

the water hardness value (see chapter entitled Rinse

aid and refined salt). - After the salt has been

poured into the machine, the LOW SALT indicator

light* switches off.

If the salt container is not filled, the water

softener and the heating element may be damaged

as a result.

* Only available in selected models.

Installation

Technical data

Dimensions

width 60 cm

height 85 cm

depth 60 cm

Capacity 14 standard place-settings

Water supply

pressure

0,05 ÷ 1MPa (0.5 ÷ 10 bar)

7,25 – 145 psi

Power supply

voltage See appliance data plate

Total absorbed

power See appliance data plate

Fuse See appliance data plate

This dishwasher conforms to

the following European

Community Directives:

-2006/95/CE dated 16/01/2007

(Low Voltage) and subsequent

modifications

-89/336/EEC dated 03/05/89

(Electromagnetic Compatibility)

and subsequent modifications

-97/17/EC (Labelling)

-2002/96/ CE Waste Electrical

and Electronic Equipment

(WEEE)

The dishwasher meets the requirements set out

by the regulations in force concerning safety and

electrical equipment.

Any technical checks should be conducted

exclusively by a trained and authorised technician:

Repairs carried out by unaithorised persons will

invalidate the guarantee, as well as posing a

potential hazard to the user.

The manufacturer declines all responsibility for

damage to persons or property resulting from failure

to observe the above precautions, from tampering

with even a single component or from the use of

non-original spare parts.

Electrical Connection

Before inserting the plug into the electrical socket,

make sure that:

 the socket is earthed and complies with current

regulations;

 the socket can withstand the maximum load of

the appliance, which is indicated on the data

plate located on the inside of the door (see

Description of the appliance);

 the power supply voltage falls within the values

indicated on the data plate on the inside of the

door;

 the socket is compatible with the plug of the

appliance. If this is not the case, ask an

authorised technician to replace the plug (see

Assistance); do not use extension cables or

multiple sockets.

Once the appliance has been installed, the

power supply cable and the electrical socket should

be easily accessible.

The cable should not be bent or compressed.

If the power supply cable is damaged, it must

be replaced by the manufacturer or its Technical

Assistance Service in order to prevent all potential

hazards. (See Assistance)

This appliance must be earthed.

Fuses:your appliance comes fitted with a plug and a

13A fuse. If you need to replace the fuse, only those

rated at 13A and ASTA approved to BS1362 should

be used. If you lose the fuse cover, a replacement

may be obtained from your local authorised Service

Centre or Electrical company. Correct replacement is

identified by colour coding or the marking on base

of plug.

DO NOT use the plug unless the fuse cover is

fitted.

Changing the Plug

Cut off and dispose of the supplied plug if it

does not fit your socket.

To avoid a shock hazard DO NOT insert the

discarded plug into a socket anywhere else.

Wires in the mains lead are coloured accordance

with the following code:

Green/Yellow - Earth

Blue - Neutral

Brown - Live

If you change the plug, the colour of the wires in the

mains lead may not correspond with the terminal

markings in the plug, which if not coloured, could

be:

EARTH E or

NEUTRAL N

LIVE L

Changing the Mains Lead

A lead can be ordered from Hotpoint Service

UK: 08709 066 066 or

Republic of Ireland: 1850 302 220

- If you have damaged the existing lead or require a

longer one a charge will be made. It is strongly

advised that this work is carried out by a qualified

electrician.

- If the domestic wiring includes a residual current-

operated circuit breaker, ensure that it conforms to

the latest regulations.

The dishwasher must not be connected to the

electricity supply while installation is being carried

out.

- This appliance should only be connected to a 230/

240V AC source, via a properly installed earthed

socket.

- Use the dishwasher solely in a domestic

environment.

- DO NOT stand or place heavy objects on the door

when it is open, this could damage the door or

cause the appliance to tip forward.

The Company shall not be held responsible for

any incidents that occur if these regulations are not

observed.

Product specificaties

Merk:	Hotpoint
Categorie:	Vaatwasser
Model:	FDF784G
Apparaatplaatsing:	Vrijstaand
Breedte:	600 mm
Diepte:	600 mm
Hoogte:	850 mm
Aantal couverts:	14 couverts
Deurkleur:	Grijs
Droogklasse:	A
Geluidsniveau:	49 dB
Waterconsumptie per cyclus:	15 l
Wasklasse:	A
Aantal wasprogramma's:	8
Watertoevoer:	Koud
AC-ingangsspanning:	220 - 240 V
AC-ingangsfrequentie:	50 - 60 Hz
Type beeldscherm:	LED