Hotpoint-Ariston FMF823 Handleiding

Hotpoint-Ariston Wasmachine FMF823

Lees hieronder de 📖 handleiding in het Nederlandse voor Hotpoint-Ariston FMF823 (24 pagina's) in de categorie Wasmachine. Deze handleiding was nuttig voor 6 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/24

WASHING MACHINE

Contents

Installation, 2-3

Unpacking and levelling

Connecting the electricity and water supplies

The first wash cycle

Technical data

Care and maintenance, 4

Cutting off the water and electricity supplies

Cleaning the washing machine

Cleaning the detergent dispenser drawer

Caring for the door and drum of your appliance

Cleaning the pump

Checking the water inlet hose

Precautions and tips, 5

General safety

Disposal

Opening the porthole door manually

Description of the washing machine, 6-7

Control panel

Display

Running a wash cycle, 8

Wash cycles and options, 9

Table of programmes and wash cycles

Wash option

Detergents and laundry, 10

Detergent dispenser drawer

Preparing the laundry

Special wash cycles

Load balancing system

Troubleshooting, 11

Service, 12

FMF 823

Instructions for use

English,1

Italiano,13

Installation

! This instruction manual should be kept in a

safe place for future reference. If the washing

machine is sold, transferred or moved, make

sure that the instruction manual remains with

the machine so that the new owner is able to

familiarise himself/herself with its operation

and features.

! Read these instructions carefully: they

contain vital information relating to the safe

installation and operation of the appliance.

Unpacking and levelling

Unpacking

1. Remove the washing machine from its

packaging.

2. Make sure that the washing machine has

not been damaged during the transportation

process. If it has been damaged, contact the

retailer and do not proceed any further with

the installation process.

3. Remove the 4

protective screws

(used during

transportation)

and the rubber

washer with the

corresponding

spacer, located on

the rear part of the

appliance ( ).see figure

4. Close off the holes using the plastic plugs

provided.

5. Keep all the parts in a safe place: you will

need them again if the washing machine

needs to be moved to another location.

! Packaging materials should not be used as

toys for children.

Levelling

1. Install the washing

machine on a flat

sturdy floor, without

resting it up against

walls, furniture

cabinets or anything

else.

2. If the floor is not perfectly level, compensate

for any unevenness by tightening or loosening

the adjustable front feet ( ); the angle see figure

of inclination, measured in relation to the

worktop, must not exceed 2°.

Levelling the machine correctly will provide

it with stability, help to avoid vibrations and

excessive noise and prevent it from shifting

while it is operating. If it is placed on carpet or

a rug, adjust the feet in such a way as to allow

a sufficient ventilation space underneath the

washing machine.

Connecting the electricity and

water supplies

Connecting the water inlet hose

1. Connect the inlet

hose by screwing it to

a cold water tap using

a 3/4 gas threaded

connection (see

figure).

Before performing

the connection, allow

the water to run freely

until it is perfectly

clear.

2. Connect the

inlet hose to the

washing machine by

screwing it onto the

corresponding water

inlet of the appliance,

which is situated on

the top right-hand

side of the rear part

of the appliance (see

figure).

3. Make sure that the hose is not folded over

or bent.

! The water pressure at the tap must fall within

the range of values indicated in the Technical

data table (see next page).

! If the inlet hose is not long enough, contact a

specialised shop or an authorised technician.

! Never use second-hand hoses.

! Use the ones supplied with the machine.

Connecting the drain hose

Connect the drain

hose, without bending

it, to a drain duct or

a wall drain situated

between 65 and 100

cm from the floor;

alternatively, placed

it over the edge

of a basin, sink or

tub, fastening the

duct supplied to

the tap ( ). see figure

The free end of the

hose should not be

underwater.

! We advise against the use of hose extensions;

if it is absolutely necessary, the extension must

have the same diameter as the original hose

and must not exceed 150 cm in length.

Electrical connections

Before plugging the appliance into the

electricity socket, make sure that:

• the socket is earthed and complies with all

applicable laws;

• the socket is able to withstand the

maximum power load of the appliance as

indicated in the Technical data table (see

opposite);

• the power supply voltage falls within the

values indicated in the Technical data table

( );see opposite

• the socket is compatible with the plug of

the washing machine. If this is not the case,

replace the socket or the plug.

! The washing machine must not be installed

outdoors, even in covered areas. It is

extremely dangerous to leave the appliance

exposed to rain, storms and other weather

conditions.

65 - 100 cm

! When the washing machine has been

installed, the electricity socket must remain

within easy reach.

! Do not use extension cords or multiple sockets.

! The cable should not be bent or compressed.

! The power supply cable must only be

replaced by authorised technicians.

Warning! The company shall not be held

responsible in the event that these standards

are not observed.

The first wash cycle

Once the appliance has been installed, and

before you use it for the first time, run a wash

cycle with detergent and no laundry, using

wash cycle number auto clean (see “Cleaning

the washing machine”).

Technical data

Model FMF 823

Dimensions width 59.5 cm

height 85 cm

depth 60,5 cm

Capacity from 1 to 8 kg

Electrical

connections

please refer to the technical

data plate fixed to the ma-

chine

Water con-

nections

maximum pressure

1 MPa (10 bar)

minimum pressure

0.05 MPa (0.5 bar)

drum capacity 62 litres

Spin speed up to 1200 rotations per

minute

Test wash

cycles in

accordance

with re-

gulations

1061/2010

1015/2010

programme 4

;

Cotton Standard 60°C.

programme 5

;

Cotton Standard 40°C.

This appliance conforms to

the following EC Directives:

- 2004/108/EC (Electroma-

gnetic Compatibility)

- 2006/95/EC (Low Voltage)

- 2012/19/EU - WEEE

Product specificaties

Merk:	Hotpoint-Ariston
Categorie:	Wasmachine
Model:	FMF823

Heb je hulp nodig?

Als je hulp nodig hebt met Hotpoint-Ariston FMF823 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Wasmachine Hotpoint-Ariston

Hotpoint-Ariston ac 128 l Handleiding

1 April 2023

Hotpoint-Ariston aq 8 l 49 u Handleiding

1 April 2023

Hotpoint-Ariston AQ102F 49H EU AQUALTIS Handleiding

1 April 2023

Hotpoint-Ariston al 109 sl Handleiding

1 April 2023

Hotpoint-Ariston aq9d69uv Handleiding

1 April 2023

Hotpoint-Ariston SWD107617C Handleiding

16 Juni 2023

Hotpoint-Ariston aqgl 129 Handleiding

1 April 2023

Hotpoint-Ariston aq9d49uh va Handleiding

1 April 2023

Hotpoint-Ariston ARTL 82 (EU) Handleiding

2 Juni 2023

Hotpoint-Ariston aq9f 68 u eu Handleiding

1 April 2023

Handleiding Wasmachine

Nieuwste handleidingen voor Wasmachine

Winia WVD-A08T1WK14B Handleiding

28 April 2024

Continental Edison CELL7140IB Handleiding

28 April 2024

Bauknecht WAT Smart Eco 12C Handleiding

27 April 2024

Bauknecht B7 89 SILENCE EE Handleiding

27 April 2024

BEKO WTE 7512 BSS Handleiding

26 April 2024

MPM -4610-PH-04 Handleiding

25 April 2024

Samsung WW11DB8B95GH Handleiding

25 April 2024

Sôlt GGSFLW800W Handleiding

22 April 2024

Whirlpool ZEN FSCR70421 Handleiding

21 April 2024

Samsung WW90T4540TE Handleiding

18 April 2024