Hoover HMF250X Handleiding

Hoover Magnetron HMF250X

Lees hieronder de 📖 handleiding in het Nederlandse voor Hoover HMF250X (45 pagina's) in de categorie Magnetron. Deze handleiding was nuttig voor 34 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/45
MICROWAVE
FORNI A MICROONDE
MANUALE DI ISTRUZIONI
HORNOS MICROONDAS
MANUAL DE INSTRUCCIONES
FOURS A MICRO-ONDES
MANUEL D INSTRUCTIONS
,
MIKROWELLENHERD
BEDIENUNGSANWEISUNG
FORNOS MICROONDAS
MANUAL DE INSTRUCOES
MAGNETRON OVEN
GEBRUIKERSHANDLEIDING
KUCHENKA MIKROFALOWA
INSTRUKCJA OBUGI
MIKROVLNNÁ TROUBA
VOD K OBSLUZE
МИКРОВОЛНОВАЯ ПЕЧЬ
ИНСТРУКЦИЯ ПО ЭКСПЛУАТАЦИИ
USER INSTRUCTIONS
MIKROAALTOUUNI
OHJESIKIRJA
Installation Instruction
Please Read the Manual Carefully Before Installation
Please Note
Electrical connection
The oven is fitted with a plug and must be only connected to a properly installed earthed
socket. In accordance with the appropriate regulations, the socket must only be installed and
the connecting cable must only be replaced by a qualified electrician.
If the plug is no longer accessible following installation and all-pole isolating switch must
be present on the installation side with a contact gap at least 3mm.
A. Built-in furniture
The built-in cabinet shall not have a rear wall behind the appliance.
Minimum installation height is 85cm.
Do not cover ventilation slots and air intake points.
GB
1
B. Prepare the Cabinet.
1. Read the instruction on the BOTTOM CABINET TEMPLATE, put the
template on the bottom plane of cabinet.
2. Make marks on the bottom plane of cabinet according to marks “aof the
template.
1
2
GB
BOTTOM CABINET TEMPLATE
1. Check if your cabinet has a smooth, flat bottom and right size, and tape the
template onto the bottom plane of cabinet.
-Make sure the CENTER LINE of the template is in t he middle of the c abinet
-Make sure the FRONT EDGE of t he template is even with t he cabinet front
edge
2. Make marks on the bottom plane of cabinet according to the hole “a” of the
template.
-Do not drill holes in the bottom cabinet.
3. After make all marks (10 marks ) according to the inst ruction, remove t he
bottom c abinet template.
4. After marking holes “a”, c ontinue to install acc ording to the installation
instructions.
NOTE: IT IS VERY IMPORTANT TO READ AND FOLLOW THE
DIRECTIONS IN THE INSTAL LATION INSTRUCTIONS
BEFORE INSTALLATION.
This templ ate is used to locate the ca bine t bottom bracket ho les
“a”.
LEFT SIDE
RIGHT SIDE
FRONT EDGE FRONT EDGE
FRONT EDGE
CENTER LINE
2


Product specificaties

Merk: Hoover
Categorie: Magnetron
Model: HMF250X

Heb je hulp nodig?

Als je hulp nodig hebt met Hoover HMF250X stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Magnetron Hoover

Handleiding Magnetron

Nieuwste handleidingen voor Magnetron