Hoover ATD HY10A2TKEX-80 Handleiding

Hoover Wasdrogers ATD HY10A2TKEX-80

Lees hieronder de 📖 handleiding in het Nederlandse voor Hoover ATD HY10A2TKEX-80 (12 pagina's) in de categorie Wasdrogers. Deze handleiding was nuttig voor 19 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/12
EN
Environmental Issues
All packaging materials used are
environmentally-friendly and recyclable.
Please help dispose of the packaging via
environmentally-friendly means. Your
local council will be able to give you details
of current means of disposal.
To ensure safety when disposing of an old
tumble dryer disconnect the mains plug
from the socket, cut the mains power cable
and destroy this together with the plug. To
prevent children shutting themselves in
the machine break the door hinges or the
door lock.
European irective 20 /ED 12/19 U
This appliance is marked according
Individuals can play an important role in
ensuring that WEEE does not become an
environmental issue it is essential to follow
some basic rules:
WEEE should not be treated as household
waste.
WEEE should be handed over to the relevant
collection points managed by the municipality or
by registered companies. In many countries, for
large WEEE, home collection could be present.
to the European directive 2012/19/EU
on Waste Electrical and Electronic
Equipment (WEEE).
WEEE contains both polluting substances
(which can cause negative consequences for
the environment) and basic components (which
can be re-used). It is important to have WEEE
subjected to specific treatments, in order to
remove and dispose properly all pollutants, and
recover and recycle all materials.
;
-
-
In many countries, when you buy a new
appliance, the old one may be returned to the
retailer who has to collect it free of charge on a
one-to-one basis, as long as the equipment is of
equivalent type and has the same functions as
the supplied equipment.
GIAS Service
To ensure the continued safe and efficient
operation of this appliance we recommend
that any servicing or repairs are only carried
out by an authorised GIAS service engineer.
7
EN
Electrical Requirements
Tumble dryers are supplied to operate at a
voltage of 220-240V, 50 Hz single phase.
Check that the supply circuit is rated to at least
13A.
Electricity can be extremely dangerous.
This appliance must be earthed.
The socket outlet and the plug on the
appliance must be of the same type.
Do not use multiple adapters and/or
extension leads.
The plug should be accessible for
disconnection after the appliance has
been installed.
You may be charged for a service
call if a problem with your machine is
caused by incorrect installation.
switch it on at the mains until the
installation is completed.For your safety,
this dryer must be correctly installed. If
there is any doubt about installation, call
GIAS Service for advice.
Do not plug the machine in and
Adjusting the Feet
Once the machine is
in place the feet
should be adjusted to
en s u r e t ha t t h e
machine is level.
C o n t a i n s f l u o r i n a t e d
g r e e n h o u s e g a s e s .
Hermetically sealed.
GWP1430
is amaged, it must be replaced by a d
special cord which is ONLY obtainable
from the spares service. It must be
installed by a competent person.
If the mains cord on this appliance
8
1
2.
DRAIN HOSE : FITTING
INSTRUCTIONS
To avoid emptying the water container after
each drying cycle, the water can be discharged
directly to a waste water drain pipe (the same
drainage system as household sinks). Water
Bye-Laws prohibit connection to a surface
water drain. The waste water drain pipe should
be located adjacent to the tumble dryer.
The kit consists of:1 hose and 1 tap.
WARNING! Switch off and remove the
tumble dryer plug from the electricity supply
before carrying out any work.
Fit he s Follows:t Hose a
1. Flip the machine
slowly to the right
side.
2. The waste water
pipe is situated at the
right-hand side of the
machine (see the
picture). A grey hose
connects to the bridge
at the left hand side of
the machine. Using
pliers, remove the
pipe retaining clip
from the bridge.
3. Pull the hose off the
bridge connection.
4. Attach the black
hose from the kit,
( using the connector
a n d p i p e c l i p s
supplied , to the hose )
removed from the
bridge connection.
5. Connect the new
drain hose to the waste
Water pipe.
6. Once the machine is
in place, check the
bottom to ensure that
the new hose does not
kink when pushing the
tum bl e d ry er in to
position.
Connect to the mains
electricity supply.
2
3
4
5
Caution:
wait at least 4 hours before switching on so
that the oil can flow back into the
compressor. Failure to do this could result
in damage to the compressor.
If the product is in different side,
6


Product specificaties

Merk: Hoover
Categorie: Wasdrogers
Model: ATD HY10A2TKEX-80

Heb je hulp nodig?

Als je hulp nodig hebt met Hoover ATD HY10A2TKEX-80 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Wasdrogers Hoover

Handleiding Wasdrogers

Nieuwste handleidingen voor Wasdrogers