Hooker 5750-75400-LTWD Handleiding

Hooker Stoel 5750-75400-LTWD

Lees hieronder de đź“– handleiding in het Nederlandse voor Hooker 5750-75400-LTWD (2 pagina's) in de categorie Stoel. Deze handleiding was nuttig voor 14 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
1/2
ASSEMBLY INSTRUCTION
Item#: 5750 - - 75400 LTWD Upholstered Arm Chair
** Please make sure you have all prior to assembly.parts indicated below
Assembly Steps:
1. . Place chair back on a clean surface
2. c Attached seat frame (L) to hair back (J) by using bolt (A), lock washer (B) flat washer (C) at the ,
center location and tighten by Allen Wrench(D) . Then, tighten seat frame (L) to chair back (J) by
using bolts (E s ), lock washer (B), flat washers (C) and secured by using allen wrench (D) at corner.
(See diagram 1)
3. (I) ) E , C) Attached front legs to seat frame (L by using bolts ( ), lock washers (B) flat washers ( and
t . 1) ighten by allen wrench (D) (See diagram
4. After all bolts are attached and hand tightened, turn the chair upright.
5. Attached front leg bolts ( (I) to chair back(M)by using H), lock washers (B) and flat washers (G).
Tighten all bolts by allen wrench (D). Insert wood plug (F) into s bolts (H).
6. Make sure the chair is level and then tighten all bolts completely by using allen wrench . (D)
D 1 iagram
D 2 iagram
2/2
PLEASE READ THESE INSTRUCTIONS PRIOR TO ASSEMBLING THE
CHAIRS
CHAIR LEVELING INSTRUCTION SUPPLEMENT
Chair leveling procedures:
To make the assembly process easy and efficient, please read the entire instruction sheet prior to
assembling of the chair. Make sure all hardware listed is included. To properly assemble the chair, none of
the bolts should be fully tightened until all components are attached to the chair. This will allow an
opportunity to level the chair and prevent any unnecessary “rocking”.
1. Place the loosely assembled chair on a hard flat surface.
2. Apply gentle downward pressure on the seat. This step eliminates rocking and ensures the chair to
be level.
3. Once the chair is level, tighten all bolts and nuts.
Note:
Most floors have slight irregularities that can affect chair leveling. If your chair is uneven when placed
in its desired location, perform the following steps:
1. Loosen front legs to finger tight.
2. Extend both front legs ward to their fullesup t length.
3. Gently push downward on the front edge of the seat until all four legs rest on the floor.
4. -Re tighten all bolts and nuts.
Cleaning Instruction: Clean finished parts with a damp cloth using a mild dishwashing liquid and water solution.
Polish the finish with soft cloth and an industry recognized furniture polish.


Product specificaties

Merk: Hooker
Categorie: Stoel
Model: 5750-75400-LTWD

Heb je hulp nodig?

Als je hulp nodig hebt met Hooker 5750-75400-LTWD stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Stoel Hooker

Handleiding Stoel

Nieuwste handleidingen voor Stoel