Honeywell T410B Handleiding

Bekijk gratis de handleiding van Honeywell T410B (24 pagina’s), behorend tot de categorie Thermostaat. Deze gids werd als nuttig beoordeeld door 99 mensen en kreeg gemiddeld 5.0 sterren uit 6 reviews. Heb je een vraag over Honeywell T410B of wil je andere gebruikers van dit product iets vragen? Stel een vraag

X-XX UL

INSTALLATION INSTRUCTIONS

®U.S. Registered Trademark

Copyright © 2002 Honeywell • • All Rights Reserved

T410A,B

Line Voltage

T410A provides single-line break.

T410B provides double-line break.

Temperature Range: 40F to 80F (4°° °C to 27°C)

Electrical Ratings: 60 Hz noninductive

22A at 120-240 Vac; 19A at 277 Vac

Do-It-Yourself models

Your Honeywell Thermostat

Your new Honeywell T410 Electric Heating Thermostat

provides line voltage control of a radiant cable, electric

baseboard, and resistive-rated fan forced heaters within

the ratings listed above.

WARNING

This thermostat is a line voltage control (120 Volts to

240 Volts.) Do not install it if you are not completely

familiar with house wiring. If handled improperly,

there can be risk of a 120 Volt to 240 Volt electric

shock hazard, which may cause serious injury or

death.

MERCURY NOTICE

If this control is replacing a control that contains

mercury in a sealed tube, do not place you old

control in the trash. Dispose of properly.

Contact you local waste management authority for

instruction regarding recycling and the proper

disposal of a old control.

1 PREPARATION

Proper installation of your Honeywell thermostat will

occur if you follow these instructions STEP-BY-

STEP. It is recommended that as you read, understand

and complete each step, you check it off with pencil or✓

pen.

Check thermostat suitability for your home’s system

by reviewing the ratings listed above.

Make certain that your heating system is working,

especially if it has been inoperative for a length of

time. If the system does not work, contact your local

electrician for assistance.

Carefully unpack your new thermostat. To avoid

damage to the sensing element, do NOT remove

the thermostat cover until wiring has been completed.

Save packages of screws, instructions, receipt and

proof-of-purchase.

2 REMOVE OLD THERMOSTAT

WARNING

Begin by turning off power to the heating circuit at

the main service panel.

Remove cover of old thermostat—cover normally

snaps off when pulled firmly from the bottom. If it

resists, check for a screw that locks the cover.

Loosen screws holding thermostat base to outlet box

and lift away.

Disconnect wires from old thermostat. As you

disconnect each wire, tape the end and label it with

the letter of the terminal designation to make reconnection

to new thermostat easier.

Check the old insulation for cracks, nicks or fraying,

and apply high quality plastic tape where necessary

for adequate insulation.

Retain the old thermostat for reference purposes

and until your new thermostat is functioning

smoothly.

Electric Heat Thermostats

69-1562-1

Product specificaties