Holland Electronics HMMS-33 Handleiding

Bekijk gratis de handleiding van Holland Electronics HMMS-33 (2 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 123 mensen en kreeg gemiddeld 4.8 sterren uit 5 reviews. Heb je een vraag over Holland Electronics HMMS-33 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

HMMS

Fixed Channel SAW Filtered Modulator

HMMS SPECIFICATIONS:

RFOutput Channels CATV 2-117, UHF 14-59

Output Level 45dBmv (min)

Range: 12Db (adj)

A/V carrier ratio -9 to -20dB

Visual Carrier Stability ±5KHz

Aural Carrier Offset ±4.5MHz

Aural Carrier Stability ±1 KHz

Spurious Outputs(dBc) -62 dBc

C/N Ratio (in-band) -62 dBc

Broadband Noise(dBc) -95

Visual

Min Video Input .5Vp-p

Frequency Response ±1dB (50Hz to 4.2 MHz)

Video S/N 60dB

Hum Ratio -60dB

Differential Gain 3%

Differential Phase 2 degree

Group Delay 75nsec

AURAL

Input Requirements 200MV (25khz dev)

Input Impedance 10Kohm

Frequency Response ±1 dB: 50Hz-15Khz:

Distortion (THD) 1%

Pre-Emphasis 75usec

Installation Instructions:

1. Slide the model HMMS unit into the HMR rack

2. Power up the modulator by connecting the 3 pin power plug from the HMPS to power

jack in the rear of the HMMS.

3. Allow the HMMS to warm up for at least 30 minutes

4. Connect a spectrum analyzer or field strength meter to the modulator RF OUT port

5. Turn the RF output adjustment on the front of the modulator to get desired output level

6. Turn the A/V adjustment to set the audio carrier 12 to 17 dB below the video carrier

7. Remove analyzer or field strength meter from the modulator RF OUT port

8. Connect baseband audio and video signals to the AUDIO IN and VIDEO IN ports

respectively

9. Connect modulator RF output to television/monitor. (Make sure to use the proper size

attenuator between the modulator and television so as not to overdrive the television

10. Turn on television and set to modulator channel

11. Turn the AUDIO adjustment on the front of the modulator to set the sound on the

television equal in volume to an off-air channel

12. Turn the VIDEO adjustment to set the video modulation.

Over-modulation causes buzzing sounds, overly bright scenes, and distorted

pictures.

Under-modulation results in pictures with dull white levels and dark colors.

13. Remove television/monitor and attenuator from the modulator RF OUT port.

14. Connect modulator RF OUT port to the RF input of the head-end system

Product specificaties