Hoffman F88WG Handleiding

Hoffman Kabels voor pc's en randapparatuur F88WG

Bekijk gratis de handleiding van Hoffman F88WG (16 pagina’s), behorend tot de categorie Kabels voor pc's en randapparatuur. Deze gids werd als nuttig beoordeeld door 22 mensen en kreeg gemiddeld 5.0 sterren uit 11.5 reviews. Heb je een vraag over Hoffman F88WG of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Download PDF

Pagina 1/16

Feed Through Wireway−

Feed Through Kabelkanal−

Chemin de câbles grande étanchéité

Ducto De Vidrio Con Brida Cerrada

87565317

Rev. B 113357 P/N 99401616E 2005 Hoffman Enclosures Inc.

E 2005 Hoffman Enclosures Inc.

2 87565317

INDEX

INCRÉMENT

ÍNDICE

CONTENT PAGES. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

INHALT SEITEN. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

CONTENUE PAGES. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

CONTENIDO PÁGINA. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

English Instructions 3−5. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Deutsche Anleitung 6−8. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Instructions français 9−11. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Español Instrucciones 12−14. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

87565317 3

E 2005 Hoffman Enclosures Inc.

1ENGLISH

Installation Instructions

Feed−Through Wireway

I. FINISH: The standard finish on this wireway is gray polyester powder over a cleaned and phosphatized surface. This

surface may be further finished with lacquer or enamel.

II. ASSEMBLY: To assemble most wireway sections and

fittings, simply place a gasket between

flanges and install screws and nuts as

shown in detail 1.

III. TELESCOPE FITTING:

A. To Adjust Telescope Fitting:

1. Assemble parts on body of telescope fitting in correct order as shown in detail 2.

2. Insert body of telescope fitting into straight section and adjust to the desired length.

3. Position gasket retainer against flange of straight section and force the gasket inside the gasket retainer

and against the flange.

4. Position compression ring against gasket retainer and install screws and nuts as shown in detail 3.

5. If wireway is to be used as ground, provisions must be made for grounding continuity across telescope fitting.

B. To Anchor Telescope Fitting at Desired Extension:

1. If the telescope fitting is used in a vertical position to support the wireway above, or if the telescope fitting

is otherwise subjected to a material axial load, means to support such a load may be provided by one of

two methods:

Method I: With the telescope fitting at the desired

extension, drill .25 inch diameter holes through each

side of the straight section and through the

telescope fitting. Install .25 20x.5 screws through−

the holes from the outside and install cap nuts and

lockwashers as shown in detail 4.

Method II: Replace screws in two diagonally

opposite corners of flanges with .25−20 threaded

rods. Assemble rods, nuts, and washers as shown

in detail 5. After tightening the nuts, measure the

length of the extension to be sure it is the same on

both sides.

Flange Gasket

Wireway

Sections

Detail 1

Gasket

Detail 3

Gasket Retainer

Detail 2

Gasket

Compression Ring

Body

Straight Section

Detail 4

Straight Section

Anchoring Screws

Telescope Fitting

(Nuts and lockwashers

are on inside)

Detail 5

Telescope Fitting

Lockwashers

And Nuts

Straight

Section

.25−20 Threaded

Rods

Product specificaties

Merk:	Hoffman
Categorie:	Kabels voor pc's en randapparatuur
Model:	F88WG
Kleur van het product:	Zwart
Breedte:	203 mm
Hoogte:	203 mm
Soort:	Onderpakking
Internationale veiligheidscode (IP):	IP54
Ondersteuning voor plaatsing:	Horizontaal/Verticaal
Montagewijze:	Schroeven
Certificering:	EN 60204-1: 2006\nIEC 60204-1: 2005/A1:2008\nEN 60529:1991\nIEC 60529:1989\nEN 60529:1991/AC:1993
Materiaal:	Rubber
Duurzaamheidscertificaten:	RoHS
Aantal per verpakking:	1 stuk(s)
Aantal:	1
Compatibele producten:	Feed-Through Wireway, NEMA Type 12
Compatibiliteit:	Feed-Through Wireway, NEMA Type 12
Gemakkelijk te installeren:	Ja
Verbindingstype:	Schroef
Bevestigingstype:	4 pinnen