Hikoki VB13Y Handleiding


Pagina's 2 Niet gecategoriseerd

Bekijk de handleiding van Hikoki VB13Y gratis online of download de PDF. Deze handleiding is 0 keer bekeken. Vraag over dit model? Stel een vraag

DEFLECTION GUARD INSTRUCTION MANUAL FOR REBAR
CUTTER/BENDER VB16Y & VB13Y
Thank you for purchasing the Rebar Cutter/Bender. Please carefully read thismanual and the metabo HPT
instructionmanual for the product prior to actual use to familiarize yourself with proper and safe operation.
Moreover, keep these instructions along with the manual for the product at a place where you can refer to at any time.
NAMES OF PARTS
The deection guard is provided to protect the persons around the rebar cutter/benderin case rebar splinters into
pieces and deects during bending. Install the deection guard to the VB16Y or the VB13Y for operation with the
Reverse the installation procedure to remove the deflection guard.
1.Insert the base of the deection guard into the slot of the rebar cutter/bender. (Fig.3)
2.Open the guard fully by pulling the arms as shown below until a click is heard. (Fig.4)
When installing the deection guardWhen folding the deection guard
APPLICATION
HOW TO INSTALL
Slot for base insertion
HOW TO REMOVE
Guard
Guard
Arm
Arm
Base
Fig. 1Fig. 2
Fig. 3Fig. 4
1.Be sure to install the deection guard when bending a rebar whose bending length and the xed length are 20"
(inside dimension of the deection guard) or less. (Fig. 5)
Do not bend any rebar exceeding the maximum capacities of the unit described in the specifications.
The rebar you are bending may have a hard spot in it. Quality may vary within each bar. Do not
attempt to bend NON-GRADE Rebar.
Never place your hand onto the bending side of the rebar. If you do so, your hand may be caught in
the mechanical parts.
Install the deflection guard for operation with the bending length of a rebar 20" (inside dimension of
the deflection guard) or less to protect the persons around the rebar cutter/bender in case rebar
splinters into pieces and deflects during bending.
Remove the deflection guard when bending a rebar whose bending length and the fixed length are
more than 20"to prevent damage to the deflection guard.
Replace the deflection guard with new one if it is damaged. Damaged deflection guard cannot
protect the persons around the rebar cutter/bender in case rebar splinters into pieces and deflects
during bending.
WARNING
CAUTION
HOW TO USE
Bending side
20
"
Fixed end
20
"
2.Be sure to install the deection guard when bending a rebar whose bending length is 20" (inside dimension of the
deection guard) or less and the xed length is more than 20". In this case, move the arm at the xed end as
shown below. (Fig. 6)
Bending side
Fixed end
20
"
20
"
3.Remove the deection guard when bending a rebar whose bending length and the xed length are more than 20"
(inside dimension of the deection guard).
Set a rebar on the rebar cutter/bender so that the bending length is equal to or shorter than the fixed
length.
Arm
Fig. 5
Fig. 6
806
Code No.C99514361 N
Printed in Japan

Beoordeel deze handleiding


Product specificaties

Merk: Hikoki
Categorie: Niet gecategoriseerd
Model: VB13Y

Heb je hulp nodig?

Als je hulp nodig hebt met Hikoki VB13Y stel dan hieronder een vraag en andere gebruikers zullen je antwoorden