Hifonics HF7BEQ Handleiding


Lees hieronder de đź“– handleiding in het Nederlandse voor Hifonics HF7BEQ (10 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 19 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/10
Operator’s Guide
HF7BEQ
Thank you for purchasing the HIFONICS HF7BEQ 7-Band Equalizer/
two-way crossover. This unit has both a pre-amp equalizer and
crossover to provide the multi-speaker system of your vehicle with
improved sound performance. Please read the entire manual to
ensure proper connections and application.
CAUTION
Always consider consulting a professional audio installer
before installing any audio components. Be careful and take
your time. Do not let wires make contact with metal edges or
hot engine components.
Features
• ILLUMINATED BLUE CONTROL KNOB LEDS
• LOW AND HIGH LEVEL AUDIO INPUTS (SPEAKER LEVEL)
• DESIGNATED SUBWOOFER UNBALANCED OUTPUT
• SUBWOOFER X-OVER FREQUENCY CONTROL
• INPUT LEVEL CONTROL ADJUSTMENT
• FADER CONTROL
• HALF DIN CHASSIS SIZE
• MOUNTING HARDWARE (INCLUDED)
• SEVEN EQUALIZATION BANDS EACH ADJUST +/- 12dB
1
Mounting and Hardware
Prior to mounting, connect the wires
to ensure proper operation.
MOUNTING
1. Select the desired mounting location, either under the dash or
in the dash. Make sure that there is adequate depth for the HF7BEQ.
2. Use the mounting brackets and hardware provided. Make sure
there is proper clearance for the mounting bracket screws when
attaching under the dash. Use caution to ensure there are no wiring
harnesses behind the dash panel (where the mounting
screws are fastened).
3. Route the power, ground, and remote wires away from moving
parts to prevent pinching or shortened wires.
WIRING
1. : The power wire should connect to a constant or Power Wire
switched +12 volt source with a in-line fuse. We recommend (2 Amp)
that you use the radio constant or switch +12 volt source.
2. : Connect the ground wire to a clean chassis ground Gound Wire
point. Be sure to remove all paint and primer to expose clean metal.
Use a ring terminal and lock or star washer to secure the ground wire.
3. : The remote wire should be connected to the source Remote Wire
until remote or antenna wire that provides +12 volts when the
source unit is “on” and 0 volts when the source unit is turned “off.”
2


Product specificaties

Merk: Hifonics
Categorie: Niet gecategoriseerd
Model: HF7BEQ

Heb je hulp nodig?

Als je hulp nodig hebt met Hifonics HF7BEQ stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Hifonics

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd