Heatit External Room Sensor Handleiding

Bekijk gratis de handleiding van Heatit External Room Sensor (2 pagina’s), behorend tot de categorie ivópalack. Deze gids werd als nuttig beoordeeld door 82 mensen en kreeg gemiddeld 4.5 sterren uit 9 reviews. Heb je een vraag over Heatit External Room Sensor of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Heatit Controls AB can not be held liable for typographical errors, other errors or

omittances in our information. Product specifications may change without further notice.

All electrical installations must be carried out by a licensed electrician. The product must

be installed in accordance with national building codes and our installers manual.

Heatit Controls AB l Läkarvägen 4, 454 31 BRASTAD, SWEDEN

Phone: +47 61 18 77 77 l post@heatit.com – www.heatit.com

INTRODUCTION

Heatit External Room Sensor is designed for use with Multireg and

Heatit thermostats. The sensor can be mounted directly on a wall or

on the outside of a wall box. Fits into System-55 frames. The product is

delivered in a matte nish.

When used with a thermostat, dimmer or other products that emit

heat, it is recommended that the sensor be mounted below the other

products.

It is not possible to connect the sensors in series or in parallel.

INSTALLATION

Installation must be done by a qualied electrician in accordance with

national building codes. Before installation, disconnect the power to the

thermostat from the mains. During installation of the sensor, power to

the thermostat must be disconnected AT ALL TIMES.

HEATIT EXTERNAL

ROOM SENSOR

Quick Guide

01.01.22

Ver 2022-A

Use up to 1.5mm cable to connect the device to the thermostat.

The product is connected from the terminals on the product to the

terminals marked with ”Sensor” on the thermostat.

TECHNICAL DATA

NTC 10k @25°C

Cable Ø1.5mm

Size84 x 84 x 20mm

IP-Code IP 21

Approvals CE

RAL 9010RAL 9003

20mm84mm

84mm

Product specificaties