GMG Yepp Easyfit carrier Handleiding

Bekijk gratis de handleiding van GMG Yepp Easyfit carrier (2 pagina’s), behorend tot de categorie Diversen. Deze gids werd als nuttig beoordeeld door 74 mensen en kreeg gemiddeld 4.5 sterren uit 7 reviews. Heb je een vraag over GMG Yepp Easyfit carrier of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Installation instructions for the Yepp® Easyfit carrier

1

Installation instructions for the Yepp® Easyfit carrier

Installation instructions for the Yepp® Easyfit carrier

The YeppEasyfit carrier is suitable for fitting to standard bicycle luggage carriers with a load capacity of

at least 60 lbs. The Yepp Easyfit carrier has a special installation frame for the Yepp Easyfit and the

Yepp Junior rear seat as well as to the GMG Classic 911 model child seats. The maximum width of the

carrier is 6.75 inches.

Installing the Yepp Easyfit carrier

Position the Yepp Easyfit carrier on the luggage carrier and insert the 4 bolts from above into the four

large slots. See the picture below for the proper positioning (pic.1).

Insert the bolts into the 4 clamps positioned under the Yepp Easyfit carrier. Note the proper position

of the clamps (pic.2).

Position the Yepp Easyfit carrier exactly on your luggage carrier and tighten the bolts firmly.

Pic. 1 Pic 2.

Warnings and Safety advices:

WARNING: Check the bolts frequently and tighten them again if necessary.

The Yepp Maxi Easyfit can be quickly and simply fitted after the installation.

The position of the child seat depends on the type and size of the cycle.

WARNING: The centre of gravity of the Yepp Maxi Easyfit model child seat must never be further

than 10cm / 3.75 inches behind the rear axle (see the user instructions for the Yepp Maxi Easyfit).

WARNING The Yepp Easyfit carrier can only be installed on luggage carriers with a load capacity of at

least 60 lbs.

IftheYepp Easyfit carrier is used with the Classic junior 911 model child cycle seat, the luggage carrier

musthave a load capacity of 78 lbs.

If you are installing a Yepp Maxi Easyfit model child seat, please check whether the bicycle

could tip over backwards when the child is in the seat. If so, move the Yepp Easyfit carrier

forwards.

Check frequently to ensure that all fittings are sufficiently tight.

Use the Yepp Easyfit carrier only on a bicycle that is in good working order, of a type suitable

for carrying the additional load, and of proper size and adjustment for the rider.

Check the owner’s manual that accompanied the bicycle or contact the bicycle manufacturer

or distributor to obtain this information.

The Yepp Easyfit carrier must not be used on motorised vehicles (including mopeds, scooters,

etc.) apart from E-bikes.

Never modify the carrier in any way.

Do not use the carrier if any part of it appears damaged.

RECOMMENDATION:

Use a good two-legged bicycle stand.

Product specificaties