GE JXS77BB Handleiding

GE Fornuis JXS77BB

Lees hieronder de đź“– handleiding in het Nederlandse voor GE JXS77BB (2 pagina's) in de categorie Fornuis. Deze handleiding was nuttig voor 51 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
Installation Instructions
Body Side Kit For End of the Counter Installation
Tools Required:
#2 Phillips screw driver
Installing the Kit
This Body Side Kit must be installed prior to installing the Range in position.
Locate the body side keyway holes over the heads of the panel supports.
A
A1 Place the three panel supports in the 3 square holes of the vertical side trim and rotate 45° as shown below.
( May require Pliers) See illustration on back page.
A3 Insert 1” screw through shoulder rivet. Place the 1/2” spacer over the end of the 1” screw. Place the spacer-
shoulder rivet-screw assembly through washer. Install assembly in place of the screw removed in A2. (See
illustration on back page.)
A4
Pub. No. 31-10451
229C4053P434
Push the body side forward locking the slots of the keyway holes on the side panel supports.
A5
Place the longest screw (1-1/2” ) through the top hole of the body side at the rear of the range. Slide the spacer
(1-1/4”) over the screw and attach the screw to the hole in the rear of the range above the louvers. Do not tighten.(If
a backsplash kit is used in conjunction with this kit, use the shorter spacer found in the backsplash kit.) See
illustration on back page.
A6
Lift the rear of the body side to close the gap between the cooktop glass and the body side. Tighten the screws
from steps A6 and A7.
A7
Place the short (3/8” long) hex head screw through the bottom hole in the rear of the body side and attach to the
lower section of the range. See illustration on back page, Do Not Tighten.
A8
To stabilize the bottom front corner of the body side-range assembly, place the clip over the inside flange of the
body side and the outside flange of the vertical side trim, as shown in illustration. Start by raising the front corner
of the range by turning the leveling leg downward, to provide more clearance for attaching clip. See illustration on
back page for details of attaching clip. (Hold the body side and the vertical side trim close for easier assembly
of the clip.) See Illustration on back page.
A9
Refer to the Installation Instructions included with the range to place the range into kitchen location.
A10
1/4” Nut Driver
Pliers
Parts Supplied:
3 Panel Supports
1 Body Side
1/2” Spacer
1-1/4” Spacer
Clip
Shoulder Rivet
Washer
#8-3/8” Long
Hex Screw
#8-1” Long Screw
#8-1-1/2” Long Screw
Use these instructions to mount the Body Side Kit on either side of the Slide-In Range.
Remove the hex head screw at the top end of the vertical side trim as shown in the illustration on back page.
A2
1
2
BASE
ASSY.
VERTICAL
SIDE TRIM
3/8" LONG
HEX HEAD
SCREW
BODY
SIDE
1-1/2" LONG
SCREW
UPPER REAR
CORNER
BODY SIDE
1 1/4" LONG
SPACER
PUSH
CLIP
CLIP JOINS BODY SIDE
CLIP JOINS BODY SIDE
CLIP JOINS BODY SIDE
CLIP JOINS BODY SIDE
TO RANGE SIDE TRIM
TO RANGE SIDE TRIM
TO RANGE SIDE TRIM
TO RANGE SIDE TRIM
CLIP JOINS BODY SIDE
TO VERTICAL SIDE TRIM
INNER FLANGE
INNER FLANGE
INNER FLANGE
INNER FLANGE
BODY SIDE
BODY SIDE
BODY SIDE
BODY SIDE
INNER FLANGE
BODY SIDE
TURN PANEL
SUPPORT 45Ëš
WASHER
1" LONG SCREW
1/2" SPACER
REMOVE THE (UPPER)
HEX HEAD SCREW
LOCATED INSIDE THE
BODYSIDE TRIM
OUTER FLANGE
OUTER FLANGE
OUTER FLANGE
OUTER FLANGE
VERTICAL SIDE TRIM
VERTICAL SIDE TRIM
VERTICAL SIDE TRIM
VERTICAL SIDE TRIM
OUTER FLANGE
VERTICAL SIDE TRIM
SHOULDER RIVET
PUSH CLIP HOLDS BO
PUSH CLIP HOLDS BO
PUSH CLIP HOLDS BO
PUSH CLIP HOLDS BOTH
TH
TH
TH
THE VERTICAL
THE VERTICAL
THE VERTICAL
THE VERTICAL SIDE TRIM
SIDE TRIM
SIDE TRIM
SIDE TRIM
AND
AND
AND
AND THE BOD
THE BOD
THE BOD
THE BODY SIDE A
Y SIDE A
Y SIDE A
Y SIDE AT
T
T
T
THE LO
THE LO
THE LO
THE LOWER FRONT CORNER
WER FRONT CORNER
WER FRONT CORNER
WER FRONT CORNER
PUSH CLIP HOLDS BOTH
THE VERTICAL SIDE TRIM
AND THE BODY SIDE AT
THE LOWER FRONT CORNER
BODY
SIDE
TRIM
BODY
SIDE
A2
A3
A9
A1
A7
A6
A4 A5

Product specificaties

Merk: GE
Categorie: Fornuis
Model: JXS77BB

Heb je hulp nodig?

Als je hulp nodig hebt met GE JXS77BB stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Fornuis GE

GE

GE GRF40HSVSS Handleiding

16 April 2024
GE

GE GGF600AVFS Handleiding

16 April 2024
GE

GE CEP90302TSS Handleiding

19 Maart 2024
GE

GE PCGS960YPFS Handleiding

19 Maart 2024
GE

GE CHP90362TSS Handleiding

19 Maart 2024
GE

GE CHP90361TBB Handleiding

19 Maart 2024
GE

GE GGF600AVWW Handleiding

16 Maart 2024
GE

GE Profile PLU612DWBB Handleiding

16 Maart 2024
GE

GE GGS500SVSS Handleiding

16 Maart 2024
GE

GE GRF500PVWW Handleiding

16 Maart 2024

Handleiding Fornuis

Nieuwste handleidingen voor Fornuis

AEG

AEG NCP84C01AZ Handleiding

28 April 2024
AEG

AEG TI64IB30IZ Handleiding

28 April 2024
Midea

Midea MC-HV848 Handleiding

28 April 2024
IKEA

IKEA TILLREDA 005.558.96 Handleiding

27 April 2024
IKEA

IKEA MATMĂ„SSIG 905.136.04 Handleiding

27 April 2024
IKEA

IKEA VASASTAN 405.236.05 Handleiding

27 April 2024
Bertazzoni

Bertazzoni PRO1005GGVLXE Handleiding

25 April 2024
Bertazzoni

Bertazzoni P905CAPROX Handleiding

25 April 2024
Mestic

Mestic MIC-120 Handleiding

25 April 2024
LG

LG LCE3010SBE Handleiding

18 April 2024