GE JV327XWH Handleiding

GE Afzuigkap JV327XWH

Lees hieronder de 📖 handleiding in het Nederlandse voor GE JV327XWH (12 pagina's) in de categorie Afzuigkap. Deze handleiding was nuttig voor 36 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/12
Use and Care of Recirculation Hood Model JN327
and Ventilating Hood Models JV327, JV337 & JV347
IMPORTANT SAFETY
INSTRUCTIONS
READ AND SAVE THESE
INSTRUCTIONS.
WARNING—TO REDUCE THE RISK
OF FIRE, ELECTRIC SHOCK OR
INJURY TO PERSONS, OBSERVE
THE FOLLOWING:
A. Use this unit only in the manner intended
by the manufacturer. If you have any questions,
contact the manufacturer.
B. Before servicing or cleaning unit, switch
power off at service panel and lock the service
disconnecting means to prevent power from
being switched on accidentally. When the service
disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a
tag, to the service panel.
CAUTION: For general ventilating use only. Do
not use to exhaust hazardous or explosive
materials and vapors.
When you get your new hood…
• Have it installed and properly grounded by a
qualied technician in accordance with the
installation instructions.
• Have the installer show you the location of
the hood circuit breaker or fuse and mark it for
easy reference.
Take the time to read our suggestions for best use.
WARNING—TO REDUCE THE RISK
OF FIRE, ELECTRIC SHOCK OR
INJURY TO PERSONS, OBSERVE
THE FOLLOWING:
A. The combustion airflow needed for safe
operation of fuel-burning equipment may be
affected by this unit’s operation. Follow the
heating equipment manufacturers guideline and
safety standards such as those published by the
National Fire Protection Association (NFPA),
and the American Society for Heating
Refrigeration and Air Conditioning Engineers
(ASHRAE), and the local code authorities.
B. Installation work and electrical wiring must be
done by qualied person(s) in accordance with
all applicable codes and standards, including
re-rated construction.
C. When cutting or drilling into wall or ceiling,
do not damage electrical wiring and other
hidden utilities.
D. Ducted fans must always be vented to
the outdoors.
E. If this unit is to be installed over a tub or
shower, it must be marked as appropriate
for the application.
WARNING—To reduce the risk of fire,
use only metal ductwork.
When using your hood…
• Never leave surface units unattended at high
settings. Boilover causes smoking and greasy
spillovers that may ignite and spread if hood is
used. Use surface unit heat settings recommended
by the manufacturer and adequate-size utensils.
• Never use your cooking appliance for warming
or heating the room. The electrical wiring of your
range hood may not withstand the resulting
excessive heat.
• Keep the hood clean and clean grease lter or
replace combination lter as recommended to
maintain good venting and to avoid grease res.
WARNING—TO REDUCE THE RISK
OF A RANGE TOP GREASE FIRE:
A. Keep fan, lters and grease laden
surfaces clean.
B. Always turn hood ON when cooking
at high heat.
C. Use high range settings on range only
when necessary. Heat oil slowly on low
to medium setting.
D. Don’t leave range unattended when cooking.
E. Always use cookware and utensils appropriate
for the type and amount of food being prepared.
When flaming foods under the hood, turn the fan on.
(continued next page)
Turn the page for Operation and Maintenance instructions.
GE Quality Product
IMPORTANT SAFETY
INSTRUCTIONS (continued)
WARNING—TO REDUCE THE RISK
OF INJURY TO PERSONS IN THE
EVENT OF A RANGE TOP GREASE
FIRE, OBSERVE THE FOLLOWING:
*
A. SMOTHER FLAMES with a close-tting lid,
cookie sheet, or metal tray, then turn off the burner.
BE CAREFUL TO PREVENT BURNS.
If the ames do not go out immediately,
EVACUATE AND CALL THE
FIRE DEPARTMENT.
B. NEVER PICK UP A FLAMING PAN.
You may be burned.
C. DO NOT USE WATER, including wet dishcloths
or towels—a violent steam explosion will result.
D. USE AN EXTINGUISHER ONLY IF:
1. You know you have a Class ABC extinguisher,
and you already know how to operate it.
2. The re is small and contained in the area
where it started.
3. The re department is being called.
4. You can ght the re with your back to an exit.
*Based on “Kitchen Firesafety Tips” published by NFPA.
WARNING: The electrical wiring and fan
motor in this range hood are not intended
for use with, or provided with, a solid state
speed control. Any such alteration from
original factory wiring concept could result
in damage to the unit and/or create an
electrical safety hazard.
READ AND SAVE THESE
INSTRUCTIONS
Models: JN327 & JV347 non-ducted
Your hood is equipped with a replaceable combination
lter. When the fan is operated, air is drawn through the
filter and discharged into the room through the hood.
Model: JV327
Your hood is equipped with a metal grease lter. When
the fan is operated, air is drawn through the lter and
discharged to the outside.
Models: JV337 & JV347 ducted
Your hood is equipped with a metal grease lter. When
the fan is operated, air is drawn through the lter and
discharged to the outside.
CAUTION–before operating the hood:
Install the lamp bulb (not provided). See the
Lamp Replacement instructions.
If You Need Service…
Do not attempt to repair or replace any part of
your hood unless it is specifically recommended
in this book. All other servicing should be
referred to a qualified technician.
• Disconnect hood circuit breaker or fuse before
performing any service.
2
Replaceable combination lter
Grease
lter
(Model JV347 has a lamp cover.)
Lamp
holder
Grease lter
(Model JV347 has a lamp cover.)
Lamp
holder
Lamp
holder
To Operate
Lamp Switch
Models: JN327, JV327, JV337
Press for OFF and ON.
Lamp Switch
Model: JV347
Rotate clockwise, rst position for NIGHT LIGHT,
second position for BRIGHT LIGHT.
Fan Switch
Models: JN327, JV327, JV337
CENTER position OFF, DOWN position LOW SPEED,
TOP position HIGH SPEED.
Model: JV347
Rotate Clockwise, FIRST position HIGH, SECOND
position MEDIUM, THIRD position LOW.
To Maintain
Replaceable Filter
JN327, JV347 non-ducted installation
The efficiency of your hood depends upon a clean filter,
the frequency of filter replacement depends upon the type
of cooking you do; however, with average, normal usage,
replacement should be every 6 to 12 months.
NEVER OPERATE THE HOOD WITHOUT THE
FILTER IN PLACE.
When to replace the lter: JN327
The filter has distinct color stripes of indicating material on
the visible surface. It is TIME TO CHANGE when the filter
stripes have either blended together or faded completely.
Model JV347 non-ducted installations
The lter supplied with the hood does not have
indicating stripes and should be replaced after 6 months.
Replacement lters will have the indicating stripes as
described under the lter for Model JN327.
To remove: Pull down on the center of the front edge of
the lter. The lter will then slip out of the retaining tabs
on the back.
To replace:
Slip the back edge of the filter into the retaining
tabs and push the front edge up until it snaps in place.
Replace with genuine GE part: lter part number
WB02X8406.
Grease Filter “JV” models only
The eciency of your hood depends on a clean lter.
Frequency of cleaning depends on the type of cooking you
do. BUT GREASE FILTER SHOULD BE CLEANED
AT LEAST ONCE A MONTH. NEVER OPERATE
THE HOOD WITHOUT THE FILTER IN PLACE.
To remove: Pull down on the center of the front edge of
the lter. The lter will then slip out of the retaining tabs
on the back.
To clean: Soak and then agitate in a hot detergent
solution. Light brushing may be used to remove imbedded
soil. Rinse, shake and remove moisture before replacing.
With careful handling, the lter will last for years.
If replacement becomes necessary, order the part from
your dealer.
To replace: Slip the back edge of the lter into the
retaining tabs and push the front edge up until it snaps
into place.
Hood
Clean grease laden surfaces of the hood frequently.
Use warm detergent solution. About 1 tablespoon of
ammonia may be added to the water. TAKE CARE TO
NOT COME IN CONTACT WITH FILTERS AND
OTHER NON-ENAMELED SURFACES. The hood
shell can be washed, rinsed and dried with a soft cloth.
Motor and Fan
To Clean Motor and Fan
1. DISCONNECT THE HOOD POWER SUPPLY AT
THE HOUSEHOLD DISTRIBUTION PANEL BY
REMOVING THE FUSE OR SWITCHING OFF
THE CIRCUIT BREAKER.
2. Remove the lter.
3. Wipe the fan blade and motor with cloth, dampened
only in ammonia and warm water solution.
4. Replace the lter.
5. Reconnect the hood power supply.
CAUTION: Be certain when cleaning the hood
surfaces you do not touch the lamp bulb with moist
hands or cloth. A warm or hot lamp bulb may break
if touched with a moist surface. ALWAYS let lamp
cool COMPLETELY before cleaning around it.
3
Vents (JN327 & JV347)
Fan switch Lamp switch


Product specificaties

Merk: GE
Categorie: Afzuigkap
Model: JV327XWH

Heb je hulp nodig?

Als je hulp nodig hebt met GE JV327XWH stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Afzuigkap GE

Handleiding Afzuigkap

Nieuwste handleidingen voor Afzuigkap