GE Café CX153P4MWM Handleiding

GE Magnetron Café CX153P4MWM

Lees hieronder de 📖 handleiding in het Nederlandse voor GE Café CX153P4MWM (7 pagina's) in de categorie Magnetron. Deze handleiding was nuttig voor 9 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/7
Installation Microwave Oven
Instructions Built-In Trim Kits
1
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT — Save these instructions
for local inspector’s use.
IMPORTANT — Observe all governing codes
and ordinances.
Note to Installer – Be sure to leave these instructions
with the Consumer.
Note to Consumer Keep these instructions for future
reference.
Skill level Installation of this appliance requires basic
mechanical and electrical skills.
Completion time 1 to 3 hours
Proper installation is the responsibility of the installer.
Product failure due to improper installation is not
covered under the Warranty.
This kit is for use on model: CEB515
This kit and microwave are approved for installation
alone or above any single electric wall oven. Do not
mount adjacent (within 2 feet) to any range, cooktop,
gas oven, or other microwave.
This product is to be installed 3 feet above floor level.
Do not alter or modify any part of this kit or the oven.
For easier installation and personal safety, we
recommend that two people install this microwave
oven.
Unplug the microwave oven before attempting
installation of this kit.
This oven must be plugged into a
properly grounded 3-hole, 120 volt receptacle as required
by the National Electrical Code.
Before beginning the installation,
switch power off at service panel and lock the service
disconnecting means to prevent power from being
switched on accidentally. When the service disconnecting
means cannot be locked, securely fasten a prominent
warning device, such as a tag, to the service panel.
PARTS INCLUDED
NOTE: This kit has extra screws to prevent the
technician from spending extra time locating
a replacement in case they lose one during
installation.
CX152, CX153
PART QUANITY
Rear Duct 1
Bottom Duct
1
Trim Kit
Frame 1
Rail
2
Short Screws
16 required
3 extra
Long Wood
Screws 4 required
2 extra
If you have questions, visit our website at: cafeappliances.com
WARNING
WARNING
CUTOUT DIMENSIONS
This trim kit uses air flow from the top, bottom and
sides of the trim frame. Blocking the air flow can
cause the microwave to function improperly and may
cause damage to the microwave.
Allow a 1 clearance beyond the edge of the trim kit
frame to provide proper air flow.
FOR INSTALLATION ABOVE A BUILT-IN OVEN:
Microwave oven should be installed on a 3/8
plywood base and supported by 2x4 or 1x2
equivalent runners on all sides. Base must be
capable of supporting a minimum of 100 lbs.
2
Installation Instructions
Min. depth with receptacle outside cutout – 22
Min. depth with receptacle inside cutout – 23 1/2
120 volt – 60 Hertz grounded power receptacle.
TOOLS YOU WILL NEED
Ŷ
2 Phillips Screwdrivers (#1 & #2)
Ŷ
Drill with 3/32” Drill Bit
Ŷ
Pencil
Ŷ
Level
Ŷ
Tape Measure
Depth
Height
1” Overlap
Width
1” Overlap
1” Clearance beyond
trim frame
(on all sides)
3” Min.
27”models: 1 7/8” overlap
30”models: 3 5/16” overlap
Bottom of trim kit must be
minimum of 36” from floor
Dimen-
sion
Trim Kit Cutout
27” 30”
Height 19 1/8 19 1/8 17 1/8 ± 1/ ”8
Width 26 7/8 29 3/4 23 1/4 ± 1/ ”8
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event
of an electrical short circuit, grounding reduces
the risk of electric shock by providing an escape
wire for the electric current. This appliance
is equipped with a cord having a grounding
wire with a grounding plug. The plug must be
plugged into an outlet that is properly installed
and grounded.Consult a qualified electrician or
serviceman if the grounding instructions are not
completely understood, or if doubt exists as to
whether the appliance is properly grounded.
Improper use of the
grounding plug can
result in a risk of
electric shock.
Do not use an
extension cord. If the
power supply cord
is too short, have a
qualified electrician or
serviceman install an
outlet near the appliance.
Permanent and Correct Installation
3-Prong plug
Grounding pin
3-Prong receptacle
Grounded receptacle box
ELECTRICAL REQUIREMENTS
Product rating is 120 volts AC, 60 Hertz, 14
amps and 1.60 kilowatts. This product must
be connected to a supply circuit of the proper
voltage and frequency. Wire size must conform
to the requirements of the National Electrical
Code or the prevailing local code for this kilowatt
rating. The power supply cord and plug should
be brought to a separate 15 to 20 ampere
branch circuit single grounded outlet. The outlet
box should be located in the cabinet above the
oven. The outlet box and supply circuit should be
installed by a qualified electrician and conform
to the National Electrical Code or the prevailing
local code.
WARNING
WARNING
7
INSTALL THE TRIM KIT FRAME
1. Position the assembled Trim Kit frame around the
oven.
2. Drill pilot holes using the drill (3/22).
3. Secure the Trim Kit by 4 long screws through the
trim kit into the cabinet by using a manual screw
driver.
IMPORTANT-
Start all screws before tightening any one screw. Do
not overtighten screws since it can cause misalignment of
top/side strips.
4
Installation Instructions
31-2000081
06-18 GEA
READ CAREFULLY. KEEP THESE INSTRUCTIONS.
8
REPLACE ANY LOOSE ITEMS
1. Your trim kit is now fully installed. Replace the
turntable and turntable support that was removed
from inside the microwave oven.
2. Keep these installation instructions and extra
screws for future reference and need. Do not place
them in the microwave oven.
3. Replace the house fuse, or close the circuit breaker
to restore power at the service panel.
6
SECURE THE RAILS TO THE
CABINET
Ensure the Base Pan and Bottom Bracket front flanges
are tight against the cabinet, and that the screws holes
are aligned. Drive 4 short screws through the Base Pan
and Rails into the cabinet
Short Screw
Mounting Holes
4
INSTALL THE MICROWAVE OVEN
Plug the power cord into the wall receptacle. Slide the
microwave oven assembly gently into the cabinet, using
care not to pinch the power cord. Be sure to keep the
assembly centered as it slides back to where the tongue
of the rails goes through the slots on Base Plan. The top
edges of the Base Plan should now be centered right to
left in the opening. The Base should be tight against the
cabinet.
5
CHECK LEVELING
Check the leveling by placing a level at the front and
sides of the microwave. It may be necessary to add wood
shims under the base pan to level the microwave front-to-
back and side-to-side.
Rail
Guides
Rails
3
INSTALL THE REAR DUCT
(continued)
6. Use 3 short screws to secure back of rear duct to the
back of microwave oven, as shown.
A. Short screws (3)
B. Rear duct
C. Back of microwave oven
ABC
Long Screw
Printed in China


Product specificaties

Merk: GE
Categorie: Magnetron
Model: Café CX153P4MWM

Heb je hulp nodig?

Als je hulp nodig hebt met GE Café CX153P4MWM stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Magnetron GE

Handleiding Magnetron

Nieuwste handleidingen voor Magnetron