Garmin nuvi 250 Handleiding

Garmin Personal navigatie nuvi 250

Lees hieronder de 📖 handleiding in het Nederlandse voor Garmin nuvi 250 (28 pagina's) in de categorie Personal navigatie. Deze handleiding was nuttig voor 34 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/28

nüvi® 200-Series Bicycle Mount

Instructions 2–3 ………………………

Instructions (Français) 4–5 ………….

Istruzioni 6–7 …………………………

Anweisungen 8–9 ……………………

Instrucciones 10–11 ………………….

Instruções 12–13 ……………………..

Instructies 14–15 ……………………..

Instruktioner 16–17 …………………..

Ohjeet 18–19 …………………………

Instruksjoner 20–21 ………………….

Instruktioner 22–23 …………………..

Инструкции………… ……… 24–25

2-EN

InstructIons

The nüvi

200-series bicycle mount allows

you to attach your nüvi to your bicycle.

Garmin

’s standard Limited Warranty

applies to this accessory. Refer to the limited

warranty and safety warnings in your nüvi Set

Up and Go guide before installing the bicycle

mount.

Do not expose the nüvi to caution:

water. Contact with water can cause the

nüvi to malfunction.

warning: You are responsible for

obeying all trafc laws when using your

nüvi on your bicycle, scooter, or other

vehicle with handlebars.

You can install the bicycle mount to the stem

or handlebars. The stem installation (shown

here) provides a more sturdy location. The

optional wedge should be used under the

mount for a better viewing angle.

To attach the bicycle mount to your

bicycle stem:

1. Insert the hard plastic half of the bicycle

mount into the half with the rubber

backing.

Release lever

Bike mount

Wedge (optional)

EN-3

For horizontal bars: Separate and

remove the top part of the mount, turn it

90 degrees, and replace. Continue with

step 2.

2. Place the wedge on the bicycle stem,

and then place the bicycle mount on

the wedge. Make sure the release lever

is on the left.

3. Thread the two cable ties through the

two slots on the bicycle mount. Position

the mount on your bicycle and attach

using the cable ties.

Release

lever

Cable ties

To attach the cradle to the bicycle

mount:

1. Fit the bottom of the nüvi in the cradle,

and snap the top of the nüvi into place.

2. Align the cradle with the bicycle mount.

3. Slide the cradle left onto the bicycle

mount until it snaps into place.

Change the Usage Mode on your TIP:

nüvi. Touch > > > Settings System

Usage Mode Bicycle > .

To release the cradle:

1. Remove the nüvi from the cradle.

2. Press down on the release lever, and

slide the cradle to the right.

Product specificaties

Merk:	Garmin
Categorie:	Personal navigatie
Model:	nuvi 250
Gewicht:	147 g
Breedte:	97 mm
Diepte:	20 mm
Hoogte:	71 mm
Bluetooth:	Nee
Beeldscherm:	LCD
Resolutie:	320 x 240 Pixels
Levensduur accu/batterij:	5 uur
Batterijtechnologie:	Lithium-Ion (Li-Ion)
Water:	Nee
Sport (fitness, hardlopen):	Nee
Outdoor:	Ja
Geocaching:	Nee
Auto:	Ja
Vliegen:	Nee
Aantal Waypoints:	500
Basiskaart:	Nee
Afmetingen scherm (HxV) (imperiaal):	3.5 "
GPS ontvanger:	Ja
WAAS ontvangst:	Ja