Ganz ZCOH5-D25NXA Handleiding

Ganz Bewakingscamera ZCOH5-D25NXA

Lees hieronder de 📖 handleiding in het Nederlandse voor Ganz ZCOH5-D25NXA (8 pagina's) in de categorie Bewakingscamera. Deze handleiding was nuttig voor 24 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/8
ZC-OH5 TAMPER ESISTANT-R
I /O HNDOOR UTDOOR OUSING
INSTRUCTION ANUALM
Please carefully read and observe all instructions and warnings contained in this manual
or on the product. Improper installation may damage the device and void the warranty.
F COR USE WITH GANZ ZC-D5000 SERIES MINIDOME AMERAS
2
IMPORTANT
Installation should be performed by a qualified service person and
conform to all local codes.
DESCRIPTION
Model ZC-OH5 is a tamper resistant indoor or outdoor housing that is
designed to accommodate all CBC ZC-D5000 series mini-dome cameras.
This housing will accept the following camera models:
M FAJOR EATURES
Polycarbonate dome with rugged cast aluminum housing withstands the
blow from a 10 pound sledgehammer
O-ring sealed housing meets IP66 standards for use in virtually any
weather conditions
Quick-Lock tabs for easy installation and removal of camera module
Built-in conduit access in dome base accepts 3/4” conduit
Quick and easy installation utilizing 6 different dome camera options
Housing mounts directly to an wall, ceiling or 4S Electrical box.y
ZC-D5029NHA/PHA 1/3" Color hi-res dome, 540 TVL, 2.9-8.2mm
AI varifocal
ZC-D5212NHA/PHA 1/3" Color hi-res dome, 540 TVL, 2.8-12mm
AI varifocal
ZC-D5550NHA/PHA 1/3" Color hi-res dome, 540 TVL, 5-50mm
AI varifocal
ZC-DN5029NHA/PHA 1/3" Color hi-res TRUE DAY/NIGHT dome, 540
TVL, 2.9-8.2mm AI varifocal
ZC-DN5212NHA/PHA 1/3" Color hi-res TRUE DAY/NIGHT dome, 540
TVL, 2.8-12mm AI varifocal
ZC-DN5840NHA/PHA 1/3" Color hi-res TRUE DAY/NIGHT dome, 540
TVL, 8.5-40mm AI varifocal
INSTALLATION
1) Standard Housing Installation
a) C :AUTION Do Not Remove Screws. Loosen the 3 set screws
from the dome base using the supplied key and remove the dome
cover (see FIGURE 1).The O-Ring makes a tight seal, so a thin-bladed
screwdriver may be needed to separate the dome cover from the
housing base b using the pr slots to seperate.y y
3
b) Using a minimum 1/2” drill bit, drill the cable feed hole and feed the
video/power cable through the mounting surface or attach 3/4”
conduit fitting to the hole in the side and seal with pipe thread tape
(see FIGURE 2).
FIGURE 1
FIGURE 3
D ROME EMOVAL
I B M HNSIDE ASE OUNTING OLES
Mounting holes for camera base (2)
Mounting holes for housing,
covered by rubber plugs (4)
c) Holding the dome against the mounting surface, mark and drill the 4
mounting holes (see FIGURE 3). Fasten the base to the mounting
surface using the supplied #8 Phillips screws, rubber washers and
plastic anchors (anchors for dry wall only), (see F 1IGURE ).
Depending on the mounting surface other hardware may be needed.
Add rubber gasket seal to the back of the housing for sealing on a
flat surfaces. For uneven surfaces a bead of silicone sealant is
recommended.
FIGURE 2
B V C HACK IEW ONDUIT OLE
Built-in Conduit Hole
Note: If using other mounting hardware; apply silicone sealant
around the inside of the 4 mounting holes before inserting screws or
bolts to prevent damage from leakage.
Loosen (x3) Set Screws
to remove trim ring and 
bubble.
Mounting 
Screws (x4)
Plastic anchors (x4)
for drywall only.
Cable Assembly
Rubber mounting 
washers (x4)


Product specificaties

Merk: Ganz
Categorie: Bewakingscamera
Model: ZCOH5-D25NXA

Heb je hulp nodig?

Als je hulp nodig hebt met Ganz ZCOH5-D25NXA stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Bewakingscamera Ganz

Handleiding Bewakingscamera

Nieuwste handleidingen voor Bewakingscamera